Effect of strain and stoichiometry on the ferroelectric and pyroelectric properties of the epitaxial Pb(Zr0.2Ti0.8)O3 films deposited on Si wafers

2021 ◽  
Vol 266 ◽  
pp. 115042
Author(s):  
Cristina Chirila ◽  
Georgia Andra Boni ◽  
Lucian Dragos Filip ◽  
Marius Husanu ◽  
Stefan Neatu ◽  
...  
Author(s):  
П. Гуранич ◽  
Р. Росул ◽  
О. Гомоннай ◽  
О. Сливка ◽  
О. Гомоннай ◽  
...  

Author(s):  
А. І. Сусла ◽  
М. С. Зеленюк ◽  
Г. М. Гуйван ◽  
О. Г. Сливка ◽  
В. М. Кедюлич

2003 ◽  
Vol 30 (1-2) ◽  
pp. 25-39 ◽  
Author(s):  
K. Sambasiva Rao ◽  
T. N. V. K. V. Prasad ◽  
N. Vallisnath ◽  
Joon-Hyung Lee ◽  
Sang-Hee Cho

1999 ◽  
Vol 85 (12) ◽  
pp. 8343-8348 ◽  
Author(s):  
Jianping Zhang ◽  
Burtrand I. Lee ◽  
Robert W. Schwartz ◽  
Zhenya Ding

MRS Advances ◽  
2016 ◽  
Vol 1 (39) ◽  
pp. 2711-2716 ◽  
Author(s):  
V. Vasilyev ◽  
J. Cetnar ◽  
B. Claflin ◽  
G. Grzybowski ◽  
K. Leedy ◽  
...  

ABSTRACTAlN thin film structures have many useful and practical piezoelectric and pyroelectric properties. The potential enhancement of the AlN piezo- and pyroelectric constants allows it to compete with more commonly used materials. For example, combination of AlN with ScN leads to new structural, electronic, and mechanical characteristics, which have been reported to substantially enhance the piezoelectric coefficients in solid-solution AlN-ScN compounds, compared to a pure AlN-phase material.In our work, we demonstrate that an analogous alloying approach results in considerable enhancement of the pyroelectric properties of AlN - ScN composites. Thin films of ScN, AlN and Al1-x ScxN (x = 0 – 1.0) were deposited on silicon (004) substrates using dual reactive sputtering in Ar/N2 atmosphere from Sc and Al targets. The deposited films were studied and compared using x-ray diffraction, XPS, SEM, and pyroelectric characterization. An up to 25% enhancement was observed in the pyroelectric coefficient (Pc = 0.9 µC /m2K) for Sc1-xAlxN thin films structures in comparison to pure AlN thin films (Pc = 0.71 µC/m2K). The obtained results suggest that Al1-x ScxN films could be a promising novel pyroelectric material and might be suitable for use in uncooled IR detectors.


2012 ◽  
Vol 02 (01) ◽  
pp. 1250005 ◽  
Author(s):  
Y. P. JIANG ◽  
X. G. TANG ◽  
Y. C. ZHOU ◽  
Q. X. LIU

Lead strontium titanate ( Sr 1-x Pb x) TiO 3 (0.20 ≤ x ≤ 0.45,step = 0.05) ceramics were prepared by conventional mixed oxide method. The X-ray diffraction patterns indicate that the prepared samples have perovskite-type structure. With the increase of Pb content, there is a tendency from the cubic to tetragonal structure. The scanning electron microscopy micrographs reveal that the addition of Pb can affect microstructure. The dependent temperature dielectric permittivity and dielectric loss were investigated in the frequency range from 100 Hz to 1 MHz. The maximum peak of the dielectric permittivity versus temperature curve was broadened and a frequency dispersion of the dielectric permittivity was observed for the (Sr0.8Pb0.2)TiO3 ceramics. The results obtained at the frequency of 10 kHz reveal the Curie temperature linearly increased with the lead content. The fitted curves of temperature versus inverse dielectric permittivity at 10 kHz for ( Sr 1-x Pb x) TiO3 ceramics are consistent with Curie–Weiss law. The Pyroelectric properties were also investigated. The high pyroelectric coefficients and figure of merits indicate that the SPT ceramics are potential materials for pyroelectric sensors.


Sign in / Sign up

Export Citation Format

Share Document