scholarly journals Surface Integrity Analysis of Ceramics Machined by Wire EDM Using Different Trim Cut Technologies

Procedia CIRP ◽  
2020 ◽  
Vol 87 ◽  
pp. 251-256 ◽  
Author(s):  
T. Bergs ◽  
M. Olivier ◽  
A. Gommeringer ◽  
F. Kern ◽  
A. Klink
Keyword(s):  
Surface Integrity ◽  
Wire Edm ◽  
Trim Cut ◽  
Integrity Analysis

scholarly journals EBSD-Analysis of Flexure Hinges Surface Integrity Evolution via Wire-EDM Main and Trim Cut Technologies

Procedia CIRP ◽  
2014 ◽  
Vol 13 ◽  
pp. 237-242 ◽  
Author(s):  
F. Klocke ◽  
L. Hensgen ◽  
A. Klink ◽  
J. Mayer ◽  
A. Schwedt
Keyword(s):  
Surface Integrity ◽  
Ebsd Analysis ◽  
Wire Edm ◽  
Flexure Hinges ◽  
Trim Cut

Surface Integrity analysis of Wire-EDM on in-situ hybrid composite A359/Al2O3/B4C

2018 ◽  
Vol 5 (11) ◽  
pp. 24632-24641 ◽  
Author(s):  
Akash Nag ◽  
Ashish Kumar Srivastava ◽  
Amit Rai Dixit ◽  
Amitava Mandal ◽  
Alok Kumar Das ◽  
...  
Keyword(s):  
Surface Integrity ◽  
Hybrid Composite ◽  
Wire Edm ◽  
Integrity Analysis

Surface integrity analysis of machined Inconel 718 over multiple length scales

CIRP Annals ◽  
2012 ◽  
Vol 61 (1) ◽  
pp. 99-102 ◽  
Author(s):  
Rachid M'Saoubi ◽  
Tommy Larsson ◽  
José Outeiro ◽  
Yang Guo ◽  
Sergey Suslov ◽  
...  
Keyword(s):  
Surface Integrity ◽  
Inconel 718 ◽  
Length Scales ◽  
Multiple Length Scales ◽  
Integrity Analysis

Surface Integrity Studies in Ball End Milling of Thin Shaped Cantilever Inconel 718

2014 ◽  
Author(s):  
Nandkumar N. Bhopale ◽  
Raju S. Pawade
Keyword(s):  
Surface Integrity ◽  
Inconel 718 ◽  
Tool Path ◽  
Surface Defects ◽  
End Milling ◽  
Surface Region ◽  
Lower Surface ◽  
Machined Surface ◽  
Ball End Milling ◽  
Integrity Analysis

The paper presents the surface integrity analysis in ball end milling of thin shaped cantilever plate of Inconel 718. It is noticed that the workpiece deflection has significantly contributed to machined surface integrity in terms of surface topography and subsurface microhardness. The ball end milling performed with 15° workpiece inclination with horizontal tool path produced higher surface integrity which varies with the location of machined surface region. In general, the mid portion of the machined plate shows lower surface roughness and microhardness with less surface defects.

Sign in / Sign up

Export Citation Format

Share Document