A comprehensive power loss, efficiency, reliability and cost calculation of a 1 MW/500 kWh battery based energy storage system for frequency regulation application

2015 ◽  
Vol 74 ◽  
pp. 158-169 ◽  
Author(s):  
Md Arifujjaman
Author(s):  
Md. Asaduz-Zaman ◽  
Md. Habibur Rahaman ◽  
Md. Selim Reza ◽  
Md. Mafizul Islam

Several microgrids can be interconnected together to enhance the grid reliability and reduce the cost of supplying power to an island area where conventional power grid cannot be connected. Source and load demand do not properly balance always. Besides that, sometimes power and frequency fluctuation has occurred in MG at island mode. Need to design a special control for maintaining the state of charge (SoC) of energy storage system. This paper proposes a new power supply system for an island area that interconnects two microgrids with a single energy storage system (ESS). An algorithm has been proposed that control the microgrids energy storage system for spinning reserve and load power/frequency regulation purpose. The minimum loading constraints of diesel engine generator (DEG) is considered and the SOC of the ESS is properly maintained.


2020 ◽  
Vol 12 (15) ◽  
pp. 6154 ◽  
Author(s):  
Hui Wang ◽  
Jun Wang ◽  
Zailin Piao ◽  
Xiaofang Meng ◽  
Chao Sun ◽  
...  

High-penetration grid-connected photovoltaic (PV) systems can lead to reverse power flow, which can cause adverse effects, such as voltage over-limits and increased power loss, and affect the safety, reliability and economic operations of the distribution network. Reasonable energy storage optimization allocation and operation can effectively mitigate these disadvantages. In this paper, the optimal location, capacity and charge/discharge strategy of the energy storage system were simultaneously performed based on two objective functions that include voltage deviations and active power loss. The membership function and weighting method were used to combine the two objectives into a single objective. An energy storage optimization model for a distribution network considering PV and load power temporal changes was thus established, and the improved particle swarm optimization algorithm was utilized to solve the problem. Taking the Institute of Electrical and Electronic Engineers (IEEE)-33 bus system as an example, the optimal allocation and operation of the energy storage system was realized for the access of high penetration single-point and multi-point PV systems in the distribution network. The results of the power flow optimization in different scenarios were compared. The results show that using the proposed approach can improve the voltage quality, reduce the power loss, and reduce and smooth the transmission power of the upper-level grid.


Sign in / Sign up

Export Citation Format

Share Document