Dry sliding wear behavior of Fe3Al alloys prepared by mechanical alloying and plasma activated sintering

Wear ◽  
2010 ◽  
Vol 268 (3-4) ◽  
pp. 473-480 ◽  
Author(s):  
Jian Wang ◽  
Jiandong Xing ◽  
Li Cao ◽  
Wei Su ◽  
Yimin Gao
2009 ◽  
Vol 79-82 ◽  
pp. 1939-1942 ◽  
Author(s):  
Jing Li ◽  
Kuan Yu ◽  
Shi Lei ◽  
Zhong Quan Ma

Fe3Al intermetallics with different Al contents were prepared by mechanical alloying and hot pressing. The phases and dry sliding wear behavior were studied. The results show that Fe3Al bulk materials are mainly characterized by the low ordered B2 structure. The wear resistance increased with increasing Al content, with the lowest volume loss of Fe-32Al and irregular value of Fe-30Al. There were obvious differences in wear mechanisms of sintered Fe3Al under different testing conditions. Under lower loads plastic deformation occurred on the wear surface and the wear performance is mainly particle abrasion, the characteristics of which are micro cutting and furrows. With higher loads, the stress concentration led to rapid crack propagation and eventually the fatigue fracture, which was characterized by brittle split of material.


2016 ◽  
Vol 58 (7-8) ◽  
pp. 640-643 ◽  
Author(s):  
Ilyas Istif ◽  
Mehmet Tunc Tuncel

Wear ◽  
2019 ◽  
Vol 426-427 ◽  
pp. 989-995 ◽  
Author(s):  
C.A. León-Patiño ◽  
M. Braulio-Sánchez ◽  
E.A. Aguilar-Reyes ◽  
E. Bedolla-Becerril ◽  
A. Bedolla-Jacuinde

2016 ◽  
Vol 23 (6) ◽  
pp. 493-502 ◽  
Author(s):  
Sunil Mohan ◽  
Gaurav Gautam ◽  
Narendra Kumar ◽  
Rakesh Kumar Gautam ◽  
Anita Mohan ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document