99/03688 Design and testing controlled low-strength materials (CLSM) using clean coal ash

1999 ◽  
Vol 40 (6) ◽  
pp. 389
2016 ◽  
Vol 124 ◽  
pp. 598-605 ◽  
Author(s):  
Young-sang Kim ◽  
Tan Manh Do ◽  
Hyeong-ki Kim ◽  
Gyeongo Kang

Nature ◽  
1926 ◽  
Vol 118 (2966) ◽  
pp. 345-346
Author(s):  
H. J. HODSMAN
Keyword(s):  
Coal Ash ◽  

2013 ◽  
Vol 734-737 ◽  
pp. 901-905 ◽  
Author(s):  
Jian Li Yang ◽  
Mei Li Du ◽  
Jing Liu ◽  
Chun Xia Yu

At present, kerosene is one of the most widely used non-polar hydrocarbon oil collector agent in coal flotation in China, kerosene is difficult to dissolve in water, with good collector, but the dosage is comparatively large in the actual production.The drainage oil is from the dining recycled goods and the waste of animal flesh, can be used for preparation of fatty acid collector, which not only to reduce environmental pollution,but also to reduce the risk of food safety. At the same time, if drainage oil can replace the kerosene in coal collection, it will improve the coal preparation plant efficiency and solve the problem of shortage of national resources. In this study, we use Huangling coal as raw material for flotation experiment, use kerosene, diesel, drainage oil and emulsified drainage oil as collectors. Adding different collectors in the same flotation conditions to research the yield of clean coal, the clean coal ash and the yield of tailings by changing the dosage of collectors. The results show when adding to OP emulsifier and the proportion of water and oil is 6:4, flotation effects is the best, the yield of clean coal is 88.67%, the ash of clean coal is from 9.16% down to 8.63%, the yield of tailings is 11.32% .


2020 ◽  
Author(s):  
Sugali Sekhar Chandra

Abstract The effect of differential crushing on liberation characteristics has been studied for a low volatile coking coal of Indian origin through washability studies. Two parameters, namely “Index of Washability” (IW) and “Near Gravity Material Index” (NGMI), are used to describe the ease of washability. The ROM Coal is crushed to four different top sizes namely, 75 mm, 25 mm, 13 mm and 6 mm.On the basis of calculated IW it is observed that relative ease of washabiltiy increases with decrease in top size. From calculated IW values it may be said that this coal can be economically beneficiated using gravity process after crushing to -6 mm size. From the calculated NGMI values, the critical specific gravities have been estimated and the values for crushing to -75 mm,-25 mm,-13 mm and − 6 mm are 1.65, 1.68, 1.53 and 1.58 respectively. These critical specific gravity values suggest the separation at this specific gravity range is most difficult task using gravity methods. From NGMI analysis, it may be said that the NGMI values for coals crushed to -25 mm & -6 mm are identical (≈ 0.18) at 17% clean coal ash content. This suggests that with similar degree of difficulty, clean coal of 17% ash can be produced from these two different crushing sizes. In order to increase the yield for the clean coal of 17% ash, the decision on blending these two size coals may need to be taken.


Measurement ◽  
2020 ◽  
pp. 108663
Author(s):  
Zhaoyu Qiu ◽  
Dongyang Dou ◽  
Deyang Zhou ◽  
Jianguo Yang

2012 ◽  
Vol 610-613 ◽  
pp. 3357-3361
Author(s):  
Deng Gao Ji ◽  
Su Qin Peng ◽  
Yue Wu ◽  
Yang Hui Cai

There are lots of problems in coal flotation reagents. For example, it is difficult to disperse in coal pulp, it needs a large consumption, and its selectivity is poor. So this paper refers that kerosene can be made into compound kerosene by using different chemical products and surfactants, and then used for coal flotation. Tests proved that when the ST-1 Complex Reagent dosage is 500g/t, kerosene dosage is 900g/t, clean coal ash consistent is the same, and clean coal yield is closed, collector dosage saved 44.44%, and the fastest floating speed of clean coal is 99.3g/min, 4.8g/min fast than kerosene, Zeta potential is-28.9409mv after kerosene effect, Zeta potential is -13.2555mv after ST-1 Complex Reagent effect.


2013 ◽  
Vol 734-737 ◽  
pp. 1082-1085
Author(s):  
Xi Yuan Yang ◽  
Mei Li Du ◽  
Jin Ren Zhang ◽  
Jian Li Yang

On the basis of the coal quality characteristics, the screening and drifting tests have been carried out to investigate the separability of the coals in the inclined shaft coal samples of Chenghe Wangcun coal mine. The results showed that the mine raw coal seams are medium ash, high sulfur and medium volatile coals. The screening test results showed that the water content and sulfur content of coals samples in each grade after sieving essentially remained the row coal characteristic. Heating value increased with the decrease of particle size, but ash content decreased with the particle size. The float-and-sink tests showed that when the given clean coal ash content was 10%13% and 15% respectively, the coal samples were in the extremely difficult degree, medium separability degree and medium separability degree respectively.


Sign in / Sign up

Export Citation Format

Share Document