A Hybrid Control Delay Model Combining Control Delay and Queuing Profile at Uncongested Signalized Intersections

ICTIS 2013 ◽  
2013 ◽  
Author(s):  
Pengfei Li ◽  
Zhi-jun Qiu
Keyword(s):  
Hybrid Control ◽  
Signalized Intersections ◽  
Delay Model ◽  
Control Delay ◽  
Model Combining

Modeling Pedestrian Delays at Signalized Intersections as a Function of Crossing Directions and Moving Paths

2017 ◽  
Vol 2615 (1) ◽  
pp. 95-104 ◽  
Author(s):  
Jing Zhao ◽  
Yue Liu
Keyword(s):  
Performance Indicator ◽  
Green Light ◽  
Field Measurements ◽  
Signalized Intersections ◽  
Estimation Accuracy ◽  
Delay Model ◽  
Factors Affecting ◽  
Highway Capacity Manual ◽  
Control Delay ◽  
Proposed Model

Pedestrian delay is a key performance indicator for evaluating the level of service for pedestrians at signalized intersections. Although much is known about the pedestrian delay of a signalized crosswalk, the existing model in the Highway Capacity Manual 2010 cannot provide the necessary accuracy for estimating the pedestrian delay of the diagonal crossing (crossing to the diagonally opposite corner of the intersection in two stages) and the entire intersection. In this paper, a new pedestrian control delay model is proposed: the model considers the diagonal crossing and moving paths. The proposed model is validated on the basis of field measurements. The main factors affecting the pedestrian control delay during diagonal crossing are discussed. Results reveal that the proposed model is promising in increasing the estimation accuracy of the pedestrian control delay of the diagonal crossing and the entire intersection (approximately 20%). The delay of the diagonal crossing increases with an increase in the time gap of the green light between the two adjacent crosswalks and an increase in the green time length of the crosswalk.

Validation of Generalized Delay Model for Vehicle-Actuated Traffic Signals

1997 ◽  
Vol 1572 (1) ◽  
pp. 105-111 ◽  
Author(s):  
Nagui M. Rouphail ◽  
Mohammad Anwar ◽  
Daniel B. Fambro ◽  
Paul Sloup ◽  
Cesar E. Perez
Keyword(s):  
North Carolina ◽  
Field Data ◽  
Traffic Signals ◽  
Signalized Intersections ◽  
Delay Model ◽  
Highway Capacity ◽  
Generalized Model ◽  
Highway Capacity Manual ◽  
Traffic Volumes ◽  
Isolated Intersection

One limitation of the Highway Capacity Manual (HCM) model for estimating delay at signalized intersections is its inadequate treatment of vehicle-actuated traffic signals. For example, the current delay model uses a single adjustment for all types of actuated control and is not sensitive to changes in actuated controller settings. The objective in this paper was to use TRAF-NETSIM and field data to evaluate a generalized delay model developed to overcome some of these deficiencies. NETSIM was used to estimate delay at an isolated intersection under actuated control, and the delay values obtained from NETSIM were then compared with those estimated by the generalized delay model. In addition, field data were collected from sites in North Carolina, and delays observed in the field were compared with those estimated by the generalized delay model. The delays estimated by the generalized model were comparable with the delays estimated by NETSIM. The data compared favorably for degrees of saturation of less than 0.8. However, at higher degrees of saturation, the generalized model produced delays that were higher than NETSIM’s. Some possible explanations for this discrepancy are discussed. The delays estimated by the generalized model were comparable with delays observed in the field. Researchers have concluded that the generalized delay model is sensitive to changes in traffic volumes and vehicle-actuated controller settings and that the generalized delay model is much improved over the current HCM model in estimating delay at vehicle-actuated traffic signals.

Accounting for Nonrandom Arrivals in Estimate of Delay at Signalized Intersections

1996 ◽  
Vol 1555 (1) ◽  
pp. 9-16 ◽  
Author(s):  
Janice Daniel ◽  
Daniel B. Fambro ◽  
Nagui M. Rouphail
Keyword(s):  
Field Data ◽  
Empirical Studies ◽  
Primary Objective ◽  
Signalized Intersections ◽  
Degree Of Saturation ◽  
Delay Model ◽  
Highway Capacity ◽  
Highway Capacity Manual ◽  
Research Show

The primary objective of this research was to determine the effect of nonrandom or platoon arrivals on the estimate of delay at signalized intersections. The delay model used in the 1994 Highway Capacity Manual (HCM) accounts for nonrandom arrivals through the variable m, which can be shown to be equal to 8kI, where k describes the arrival and service distributions at the intersection and I describes the variation in arrivals due to the upstream intersection. The 1994 HCM delay model m-values are a function of the arrival type, where the arrival type describes the quality of progression at the intersection. Although an improvement to the fixed k I-value used in the 1985 delay model, the 1994 m values are based on empirical studies from limited field data and do not account for the decrease in random arrivals as the volume approaches capacity at the downstream intersection. This research provides an estimate of the variable kI for arterial conditions. An analytical equation was developed as a function of the degree of saturation, and a separate equation was developed for each signal controller type. The results from this research show that the proposed kI's provide delay estimates closer to the measured delay compared with the delay estimates using the kI-values in the 1994 HCM delay model.

Arrival-Based Uniform Delay Model for Oversaturated Signalized Intersections with Poor Progression

2005 ◽  
Vol 1920 (1) ◽  
pp. 86-94
Author(s):  
Rahim F. Benekohal ◽  
Sang-Ock Kim
Keyword(s):  
Signalized Intersections ◽  
Delay Model ◽  
Adjustment Factor ◽  
Highway Capacity ◽  
New Approach ◽  
Highway Capacity Manual ◽  
Traffic Conditions ◽  
Proposed Model ◽  
Uniform Delay ◽  
Control Delays

For oversaturated traffic conditions, the Highway Capacity Manual (HCM) does not apply a progression adjustment factor to the delay model for signalized intersections when there is an initial queue. This causes counterintuitive results in the calculation of delay; for some cases, delay for a nonzero initial queue condition ends up being less than the delay with zero initial queue conditions. Also, for oversaturated traffic conditions, the delay model in the 2000 edition of HCM yields the same uniform delay values for all arrival types when there is an initial queue. This does not seem reasonable because it ignores the effect of platooning on delay. This paper introduces a new approach for computing uniform delay for oversaturated traffic conditions when progression is poor. This approach directly considers the platooning effects in delay and thus eliminates the need to apply a progression adjustment factor. The proposed model is applicable whether there is an initial queue or not. The approach was validated by a comparison of the control delays obtained from a CORSIM simulation to the delays from the proposed model. Validation procedures were conducted on the basis of zero and nonzero initial queue conditions. The proposed approach resulted in more accurate delay values than the HCM model.

Validation of Generalized Delay Model for Oversaturated Conditions

1997 ◽  
Vol 1572 (1) ◽  
pp. 122-130 ◽  
Author(s):  
Roelof J. Engelbrecht ◽  
Daniel B. Fambro ◽  
Nagui M. Rouphail ◽  
Aladdin A. Barkawi
Keyword(s):  
Simulation Model ◽  
Close Agreement ◽  
Signalized Intersections ◽  
Delay Model ◽  
Traffic Operations ◽  
Microscopic Simulation ◽  
Highway Capacity ◽  
Traffic Demand ◽  
Highway Capacity Manual ◽  
The U.S

With today’s ever-increasing traffic demand, more and more signalized intersections are experiencing congestion for longer periods of time. To better quantify oversaturated conditions, it is necessary to accurately estimate oversaturation delay. The generalized delay model, proposed for inclusion in the next update of the U.S. Highway Capacity Manual (HCM), is introduced here. The generalized delay model differs from the model in the 1994 edition of the HCM as it is sensitive to the duration of the analysis period and is not restricted to degrees of saturation less than 1.2. The TRAF-NETSIM microscopic simulation model was used to verify the generalized delay equation for oversaturated conditions. A simulation model was used, because it is extremely difficult to measure oversaturated delay in the field. The study was designed to cover as much of the domain of oversaturated traffic operations as possible. The variability in simulated delays was investigated, and an equation was developed to predict the standard deviation of oversaturated delay estimates. It was found that delays estimated by the proposed generalized delay model are in close agreement with those simulated by TRAF-NETSIM. On average, simulated delays are overestimated slightly, but the error is small compared with actual delays. The proposed generalized delay model is expected to provide a good estimate of actual oversaturation delays that occur in the field.

scholarly journals An Empirical Framework for Intersection Optimization Based on Uniform Design

2017 ◽  
Vol 2017 ◽  
pp. 1-10 ◽  
Author(s):  
Ying Zhang ◽  
Daniel Jian Sun ◽  
Alexandra Kondyli
Keyword(s):  
Performance Optimization ◽  
Uniform Design ◽  
Signalized Intersections ◽  
Simulation Software ◽  
Practical Implementation ◽  
Control Delay ◽  
Software Packages ◽  
The One ◽  
Entire Network

Operational performance optimization of signalized intersections is one of the most important tasks for traffic engineers and researchers. To compensate for the limitations of practical implementation, simulation software packages have been widely used to evaluate different optimization strategies and thus to improve the efficiency of the intersections as well as the entire network. However, for the existing optimization studies on signalized intersections, the relationships among various optimization measures and the combination of strategies have not been fully investigated. In this paper, uniform design experimentation was introduced to combine different optimization measures into strategies and achieve the minimum time cost in model construction. VISSIM software package was then calibrated and used to evaluate various optimization strategies and identify the one with the best measurement of performance, namely, control delay at the signalized intersection. By taking a representative congested intersection in Shanghai as a case study, the optimal strategy was identified to reduce the overall control delay by 27.3%, which further verified the modeling capability of the proposed method.

Sign in / Sign up

Export Citation Format

Share Document