scholarly journals Critical-current reduction in thin superconducting wires due to current crowding

2012 ◽  
Vol 100 (18) ◽  
pp. 182602 ◽  
Author(s):  
H. L. Hortensius ◽  
E. F. C. Driessen ◽  
T. M. Klapwijk ◽  
K. K. Berggren ◽  
J. R. Clem
1995 ◽  
Vol 115 (3) ◽  
pp. 194-200
Author(s):  
Narikazu Matsukura ◽  
Takayoshi Miyazaki ◽  
Yasuhiko Inoue ◽  
Takayuki Miyatake ◽  
Masao Shimada ◽  
...  

Pramana ◽  
1988 ◽  
Vol 30 (1) ◽  
pp. L81-L86 ◽  
Author(s):  
R G Sharma ◽  
Y S Reddy ◽  
S R Jha ◽  
S S Dubey

2014 ◽  
Vol 783-786 ◽  
pp. 2081-2090 ◽  
Author(s):  
Xin Zhe Jin ◽  
Tatsushi Nakamoto ◽  
Kiyosumi Tsuchiya ◽  
Akira Yamamoto ◽  
Toru Ogitsu ◽  
...  

Development for superconducting wires of materials such as Nb3Al and the high-temperature superconductors (HTS such as REBCO, Bi2223, and Bi2212) has been carried out for high-field magnet applications. It is known that these types of wire exhibit very different characteristics and performance for different applications. The development of Nb3Al wire for high-field accelerator magnet has resulted in remarkable achievements in critical current using a Rapid Heating and Quenching (RHQ) method by High Energy Accelerator Research Organization (KEK) and National Institute for Materials Science (NIMS). As one example of a characteristic of Nb3Al, the strain sensitivity of the critical current in the RHQ-Nb3Al wire is better than that of Nb3Sn wire. A strain study is needed to further the development of a high-filed magnet; therefore, we have carried out experimental studies using the neutron diffractometer at J-PARC Takumi. Researchers have recently achieved the highest critical current density for REBCO wires in a high-field above 15 T. For this reason, REBCO wire has been considered for high-field magnet NMR applications in Riken. But several obstacles remain, including coil degradation, shielding current and thermal runaway. In this paper, R&D on recent advances for applications will be presented.


2012 ◽  
Vol 22 (3) ◽  
pp. 4805005-4805005 ◽  
Author(s):  
T. Miyatake ◽  
Y. Murakami ◽  
H. Kurahashi ◽  
S. Hayashi ◽  
K. Zaitsu ◽  
...  

2004 ◽  
Vol 68 (9) ◽  
pp. 661-667
Author(s):  
Tsuneo Kuroda ◽  
Takayuki Nakane ◽  
Hiroaki Kumakura ◽  
Yoshifumi Suga ◽  
Kuniaki Miura

2021 ◽  
Author(s):  
◽  
Anne-Hélène Puichaud

<p>High-temperature superconductors are of great interest because they can transport electrical current without loss. For real-world applications, the amount of current, known as the critical current Ic, that can be carried by superconducting wires is the key figure of merit. Large Ic values are necessary to off-set the higher cost of these wires. The factors that improve Ic (microstructure/performance relationship) in the state-of-the-art coated conductor wires based on YBa₂Cu₃O₇ (YBCO) are not fully understood. However, microstructural defects that immobilise (or pin) tubes of magnetic flux (known as vortices) inside the coated conductors are known to play a role in improving Ic. In this thesis, the vortex-defect interaction in YBCO superconductors was investigated with high-end transmission electron microscopy (TEM) techniques using two approaches.  First, the effect of dysprosium (Dy) addition and oxygenation temperature on the microstructure and critical current were investigated in detail. Changing only the oxygenation temperature leads to many microstructural changes in pure YBCO coated conductors. It was found that Dy addition reduces the sensitivity of the YBCO to the oxygenation temperature, in particular it lowers the microstructural disorder while maintaining the formation of nanoparticles, which both contribute to the enhancement of Ic.  In the second approach, two TEM based techniques (off-axis electron holography and Lorentz microscopy) were used to study the magnetic flux vortices. Vortex imaging was attempted with a TEM operated at 300 kV on both a YBCO crystal as well as a YBCO coated conductor. Many challenges were encountered including sample preparation, inhomogeneity, and geometry, in addition to the need to perform measurements at cryogenic temperatures. Although vortices were not able to be observed in the coated conductors, tentative observation of vortices in a YBCO crystal was made using Lorentz microscopy. Improvements for future electron holography experiments on YBCO at low voltage are suggested. This work represents a pioneering step towards directly imaging vortices in YBCO using more widely available microscopes with the aim of better understanding flux pinning to ultimately boost Ic in superconducting wires.</p>


Sign in / Sign up

Export Citation Format

Share Document