Effect of strong shot peening cleaning and hot galvanizing on fatigue strength of steel welded joint

2009 ◽  
Vol 23 (5) ◽  
pp. 360-368 ◽  
Author(s):  
Masayoshi Hasegawa ◽  
Hiroaki Suzuki ◽  
Ken Miura
Keyword(s):  
Fatigue Strength ◽  
Shot Peening ◽  
Welded Joint

Increasing the fatigue strength of high-strength steel parts by repeated treatment with shot peening

2020 ◽  
pp. 79-82
Author(s):  
G.N. Kravchenko ◽  
K.G. Kravchenko
Keyword(s):  
Fatigue Strength ◽  
Shot Peening ◽  
High Strength Steel ◽  
High Strength ◽  
Resource Recovery ◽  
Repeated Treatment ◽  
Multiple Processing

The effectiveness of multiple hardening by shot peening of samples made of «30ХГСН2А» high-strength steel to increase their fatigue strength is experimentally established. Repeated hardenings allow not only to restore the original durability and even significantly increase it. Keywords fatigue strength, durability, resource recovery, multiple processing by shot peening, repeated hardening, high-strength steel. [email protected]

Characterization of nanocrystalline surface layer induced by shot peening and effect on their fatigue strength.

2004 ◽  
Vol 843 ◽  
Author(s):  
Hideo Mano ◽  
Kondo Satoru ◽  
Akihito Matsumuro ◽  
Toru Imura
Keyword(s):  
Residual Stress ◽  
Surface Layer ◽  
Fatigue Strength ◽  
Vickers Hardness ◽  
Shot Peening ◽  
White Layer ◽  
The Other ◽  
Fatigue Properties ◽  
Nanocrystalline Layer

ABSTRACTThe shot peening process is known to produce a hard layer, known as the white layer” on the surface of coil springs. However, little is known about the fatigue properties of this white-layer.In this study, coil springs with a white-layer were manufactured. The surface of these springs was then examined using micro Vickers hardness, FE-SEM etc. to test fatigue strength of the springs.From the results obtained, a microstructure of the white-layer with grain size of 50–100 nm was observed, with a Vickers hardness rating of 8–10 GPa.Tow category springs were manufactured utilizing a double-peening process. These springs had the same residual stress destruction and surface roughness. Only one difference was observed: one spring had a nanocrystalline layer on the surface, while the other did not. The results of the fatigue test realized an increase in the fatigue life of the nanocrystalline surface layer by 9%.

Sign in / Sign up

Export Citation Format

Share Document