scholarly journals Determination of Iodine in Seafood by Inductively Coupled Plasma/Mass Spectrometry

2001 ◽  
Vol 84 (6) ◽  
pp. 1976-1983 ◽  
Author(s):  
Kaare Julshamn ◽  
Lisbeth Dahl ◽  
Karen Eckhoff

Abstract A method was developed for determination of total iodine content in different standard reference materials (SRMs) and seafood products by inductively coupled plasma/mass spectrometry (ICP/MS). If iodine is present as iodide and nitric acid is used in the wet digestion system, the observed signal is not stable when iodine is measured by ICP/MS at m/z 127. To stabilize the iodine signal, 3% ammonia solution (1 + 1, v/v) was added to the digest. The limit of quantitation of the method, defined as 6 times the standard deviation in the blank solution (n = 20) was estimated to be 15 mg/kg (using 0.2 g dry mass and a dilution factor of 50). The precision, expressed as repeatability of the iodine concentration, varied between 3.2 and 12% in SRMs, with concentrations of 4.70–0.17 mg/kg dry matter. The described method was compared with a method using tetramethylammonium hydroxide extraction. Both methods showed good precision and trueness by analyses of SRMs. The 2 methods were used to determine iodine in seafood from the Barents Sea, the Norwegian Sea, and the North Sea. The results showed great variation between different fish species as well as between individuals within a species. The lowest values of iodine were recorded in muscle of ling (Molva molva) with a mean of 0.07 mg/kg fresh weight and a variation between 0.03 and 0.11 mg/kg fresh weight. The highest values were found in cod (Gadus morhua) from the Barents Sea, with a mean of 2.5 mg/kg and a variation between 0.7 and 12.7 mg/kg fresh weight.

2003 ◽  
Vol 86 (2) ◽  
pp. 439-448 ◽  
Author(s):  
Lisa Jo Melnyk ◽  
Jeffrey N Morgan ◽  
Reshan Fernando ◽  
Edo D Pellizzari ◽  
Olujide Akinbo

Abstract A study was conducted to evaluate the applicability of inductively coupled plasma-mass spectrometry (ICP-MS) techniques for determination of metals in composite diets. Aluminum, cadmium, chromium, copper, lead, manganese, nickel, vanadium, and zinc were determined by this method. Atmospheric pressure microwave digestion was used to solubilize analytes in homogenized composite diet samples, and this procedure was followed by ICP-MS analysis. Recovery of certified elements from standard reference materials ranged from 92 to 119% with relative standard deviations (RSDs) of 0.4–1.9%. Recovery of elements from fortified composite diet samples ranged from 75 to 129% with RSDs of 0–11.3%. Limits of detection ranged from 1 to 1700 ng/g; high values were due to significant amounts of certain elements naturally present in composite diets. Results of this study demonstrate that low-resolution quadrupole-based ICP-MS provides precise and accurate measurements of the elements tested in composite diet samples.


2016 ◽  
Vol 99 (3) ◽  
pp. 766-775 ◽  
Author(s):  
Lawrence H Pacquette ◽  
Anil Anumula

Abstract A method was developed for the determination of As, Cd, Hg, and Pb in raw ingredients, nutritional products, and infant formula using inductively coupled plasma mass spectrometry (ICP-MS). Three raw ingredients (acid casein, maltodextrin, skim milk powder) and three standard reference materials [NIST 1548a (Typical Diet), NIST 1577c (Bovine Liver), NIST SRM 1568b (Rice Flour)] obtained from the National Institute of Standards and Technology were analyzed by two analysts using two ICP-MS instruments in different laboratories. NIST SRM 1568b was used as the control sample. All protocol validation parameters (intermediate precision, accuracy, linearity, quantitation limit, specificity, and robustness) were met. The overall precision (n = 8) for analyte concentrations (2.5–300 ng/g) ranged from 2 to 14% RSD. Spike recoveries ranged from 88 to109% for spike levels between 25 and 200%. The overall average concentration of As, Cd, Hg, and Pb measured in all three NIST SRMs were within the certified value ranges. Good linearity (correlation coefficient (r) = 0.9995 or better) was obtained for all analytes. Control chart results for 8 independent days showed that the method is robust (precision values of 10% and all points within ±3 σ were obtained). Excellent specificity was also demonstrated when the analytes were measured in the presence of high concentrations of the other concomitants.


Sign in / Sign up

Export Citation Format

Share Document