Research on Mechanism and Suppression of Sediment Deposition on Grading Electrodes in Cooling Water Dielectric of HV Converter Valve

2020 ◽  
Author(s):  
Xingfei Wang ◽  
Xuezhong Liu ◽  
Chenxing Wang
Keyword(s):  
Cooling Water ◽  
Sediment Deposition

A SYSTEM FOR PROTECTING AN OIL DIFFUSION PUMP AGAINST FAILURE OF THE MECHANICAL FORE PUMP, COOLING WATER, OR ELECTRICITY

1970 ◽  
Vol 28 ◽  
pp. 344-345
Author(s):  
W. C. Bigelow ◽  
F. B. Drogosz ◽  
S. Nitschke
Keyword(s):  
High Vacuum ◽  
Cooling Water ◽  
Effective Protection ◽  
Pump Line ◽  
Diffusion Pump ◽  
System Pressure ◽  
Control Relay ◽  
Vacuum Systems ◽  
Vacuum Gage ◽  
Pressure Switch

High vacuum systems with oil diffusion pumps usually have a pressure switch to protect against Insufficient cooling water; however, If left unattended for long periods of time, failure of the mechanical fore pump can occur with equally serious results. The device shown schematically in Fig. 1 has been found to give effective protection against both these failures, yet it is inexpensive and relatively simple to build and operate.With this system, pressure in the fore pump line is measured by thermocouple vacuum gage TVG (CVC G.TC-004) whose output is monitored by meter relay MRy (Weston 1092 Sensitrol) which is set to close if the pressure rises above about 0.2 torr. This energizes control relay CRy (Potter & Brumfield KA5Y 120VAC SPDT) cutting off power to solenoid-operated fore line valve Vf (Cenco 94280-4 Norm. Closed) which closes to prevent further leakage of air into the diffusion pump

Dispersion of Cooling Water From a Coastal LNG Plant

1980 ◽  
Author(s):  
P. Ackers ◽  
J.D. Pitt ◽  
G. Thompson ◽  
K.G. Rippin
Keyword(s):  
Cooling Water

Assessment of thermal behavior of a cooling system to reduce thermal fatigue cracks in aluminum injection molds

2020 ◽  
pp. 75-86
Author(s):  
Sergio Antonio Camargo ◽  
Lauro Correa Romeiro ◽  
Carlos Alberto Mendes Moraes
Keyword(s):  
Thermal Fatigue ◽  
Cooling System ◽  
Fatigue Cracks ◽  
Cooling Water ◽  
Thermal Conditions ◽  
Thermal Gradients ◽  
Ansys Software ◽  
Cooling Systems ◽  
Thermal Fatigue Cracks ◽  
Number Of Cycles

The present article aimed to test changes in cooling water temperatures of males, present in aluminum injection molds, to reduce failures due to thermal fatigue. In order to carry out this work, cooling systems were studied, including their geometries, thermal gradients and the expected theoretical durability in relation to fatigue failure. The cooling system tests were developed with the aid of simulations in the ANSYS software and with fatigue calculations, using the method of Goodman. The study of the cooling system included its geometries, flow and temperature of this fluid. The results pointed to a significant increase in fatigue life of the mold component for the thermal conditions that were proposed, with a significant increase in the number of cycles, to happen failures due to thermal fatigue.

Sign in / Sign up

Export Citation Format

Share Document