Voltage-type Arc Suppression Method of Single-phase-to-ground Faults in Distribution Network Considering Line Impedance

2021 ◽  
Author(s):  
Qiong Liu ◽  
Wen Wang ◽  
Huaze Shi ◽  
Pan Lu ◽  
Meina Zhou
Keyword(s):  
Single Phase ◽  
Distribution Network ◽  
Suppression Method ◽  
Ground Faults

scholarly journals A novel fault section locating method based on distance matching degree in distribution network

2021 ◽  
Vol 6 (1) ◽  
Author(s):  
Zhenxing Li ◽  
Jialing Wan ◽  
Pengfei Wang ◽  
Hanli Weng ◽  
Zhenhua Li
Keyword(s):  
Single Phase ◽  
Distribution Network ◽  
Matlab Simulink ◽  
Grounding Resistance ◽  
Blind Zone ◽  
System Transition ◽  
Transition Resistance ◽  
Zero Sequence ◽  
Matching Degree ◽  
Amplitude Characteristics

AbstractFault section location of a single-phase grounding fault is affected by the neutral grounding mode of the system, transition resistance, and the blind zone. A fault section locating method based on an amplitude feature and an intelligent distance algorithm is proposed to eliminate the influence of the above factors. By analyzing and comparing the amplitude characteristics of the zero-sequence current transient components at both ends of the healthy section and the faulty section, a distance algorithm with strong abnormal data immune capability is introduced in this paper. The matching degree of the amplitude characteristics at both ends of the feeder section are used as the criterion and by comparing with the set threshold, the faulty section is effectively determined. Finally, simulations using Matlab/Simulink and PSCAD/EMTDC show that the proposed section locating method can locate the faulty section accurately, and is not affected by grounding mode, grounding resistance, or the blind zone.

scholarly journals Location of Single Phase to Ground Faults in Distribution Networks Based on Synchronous Transients Energy Analysis

2020 ◽  
Vol 11 (1) ◽  
pp. 774-785 ◽  
Author(s):  
Xuewen Wang ◽  
Hengxu Zhang ◽  
Fang Shi ◽  
Qiuwei Wu ◽  
Vladimir Terzija ◽  
...  
Keyword(s):  
Single Phase ◽  
Energy Analysis ◽  
Distribution Networks ◽  
Ground Faults

MULTI UNITS OF SINGLE PHASE DISTRIBUTED GENERATION COMBINED WITH BATTERY ENERGY STORAGE FOR PHASE POWER BALANCING IN DISTRIBUTION NETWORK

2016 ◽  
Vol 78 (10-4) ◽  
Author(s):  
Amirullah Amirullah ◽  
Mochamad Ashari ◽  
Ontoseno Penangsan ◽  
Adi Soeprijanto
Keyword(s):  
Energy Storage ◽  
Single Phase ◽  
Low Voltage ◽  
Distribution Network ◽  
Battery Energy Storage ◽  
Current Harmonics ◽  
Line Current ◽  
Distributed Generators ◽  
Distribution Line ◽  
Battery Energy

Randomly installed distributed generators (DGs) in households may cause unbalanced line current in a distribution network. This research presents a battery energy system for balancing of line current in a distribution network involving multi units of single phase photovoltaic (PV) distributed generators (DGs). In this paper, the PV generators were simulated consisting of a buck-boost DC/DC converter and single phase DC/AC inverter. It was connected to the distribution line through the low voltage 220 volt 50 Hz. The proposed phase balancing system uses battery energy storage and three single phase bidirectional inverters. The inverter is capable of injecting current or absorbing power from the line to the battery. This inverter operation is arranged to balance each distribution line separately, as well as to improve other power quality parameters, such as voltage and current harmonics. Simulation results show that the system was capable of improving the unbalanced line current from 15.59 % to 11, 48 % and unbalanced line voltage from 1.76 % to 0.58 %. The system was able for increasing current harmonics from 0.98 % to 1.03% and voltage harmonics from 38.96% to 39.08%.

Sign in / Sign up

Export Citation Format

Share Document