Adaptive Power System Stabilizer Design For Interconnected Power Systems

Author(s):  
Farzin Shama
2016 ◽  
Vol 17 (5) ◽  
pp. 497-509 ◽  
Author(s):  
M. A. Ebrahim ◽  
H. S. Ramadan

Abstract The design of power system stabilizer (PSS) is load-dependent and needs continuous adjustment at each operating condition. This paper aims at introducing a robust non-fragile PSS for interconnected power systems. The proposed controller has the capability of adaptively tuning online its rule-base through a variable-structure direct adaptive control algorithm in order to rigorously attain the desired objectives. The PSS controller acts on damping the electromechanical modes of oscillations not only through a wide range of operating conditions but also in presence of different disturbances. Using MATLABTM-Simulink, simulation results significantly verify that the proposed controller provides favorable performance and efficiently contributes towards enhancing the system dynamic behavior when applied to the four machines two-area power system that mimics the typical system behavior in actual operation. The interaction between the variable-structure adaptive fuzzy-based power system stabilizer (VS-AFPSS) and the existed typical ones inside the interconnected power systems has been explicitly discussed. Compared to other conventional controllers, VS-AFPSS enables better damping characteristics to both local and inter-area oscillation modes considering different operating conditions and sever disturbances.


Energies ◽  
2018 ◽  
Vol 11 (12) ◽  
pp. 3466 ◽  
Author(s):  
Ashraf Khalil ◽  
Ang Swee Peng

The application of the phasor measurement units and the wide expansion of the wide area measurement units make the time delay inevitable in power systems. The time delay could result in poor system performance or at worst lead to system instability. Therefore, it is important to determine the maximum time delay margin required for the system stability. In this paper, we present a new method for determining the delay margin in the power system. The method is based on the analysis in the s-domain. The transcendental time delay characteristics equation is transformed to a frequency dependent equation. The spectral radius is used to find the frequencies at which the roots cross the imaginary axis. The crossing frequencies are determined through the sweeping test and the binary iteration algorithm. A single machine infinite bus system equipped with automatic voltage regulator and power system stabilizer is chosen as a case study. The delay margin is calculated for different values of the power system stabilizer (PSS) gain, and it is found that increasing the PSS gain decreases the delay margin. The effectiveness of the proposed method has been proved through comparing it with the most recent published methods. The method shows its merit with less conservativeness and fewer computations.


Sign in / Sign up

Export Citation Format

Share Document