Detection Event Inception Point Algorithms Based on Instantaneous Point-on-wave Measurements

Author(s):  
Pavel Y. Kovalenko ◽  
Mihail D. Senyuk ◽  
Valentin I. Mukhin ◽  
Diana D. Kornilova
1983 ◽  
Vol 18 (1) ◽  
pp. 129-150 ◽  
Author(s):  
Mark K. Watson ◽  
R.R. Hudgins ◽  
P.L. Silveston

Abstract Internal wave motion was studied in a laboratory rectangular, primary clarifier. A photo-extinction device was used as a turbidimeter to measure concentration fluctuations in a small volume within the clarifier as a function of time. The signal from this device was fed to a HP21MX minicomputer and the power spectrum plotted from data records lasting approximately 30 min. Results show large changes of wave amplitude as frequency increases. Two distinct regions occur: one with high amplitudes at frequencies below 0.03 Hz, the second with very small amplitudes appears for frequencies greater than 0.1 Hz. The former is associated with internal waves, the latter with flow-generated turbulence. Depth, velocity in the clarifier and inlet suspended solids influence wave amplitudes and the spectra. A variation with position or orientation of the probe was not detected. Contradictory results were found for the influence of flow contraction baffles on internal wave amplitude.


2013 ◽  
pp. 857-860
Author(s):  
F.L. Scarf ◽  
F.V. Coroniti ◽  
C.F. Kennel ◽  
T.R. Sanderson ◽  
K-P Wenzel ◽  
...  

2021 ◽  
Author(s):  
Robert Edward Jensen ◽  
Val Swail ◽  
Richard Harry Bouchard

AbstractAn intra-measurement evaluation was undertaken, deploying a NOMAD buoy equipped with three National Data Buoy Center and two Environment and Climate Change Canada-AXYS sensor/payload packages off Monterey, California; a Datawell Directional Waverider buoy was deployed within 19 km of the NOMAD site. The six independent wave measurement systems reported hourly estimates of the frequency spectra, and when applicable, the four Fourier directional components. The integral wave parameters showed general agreement among the five sensors compared to the neighboring Datawell Directional Waverider, with the Inclinometer and the Watchman performing similarly to the more sophisticated 3DMG, HIPPY, and Triaxys sensor packages. As the Hm0 increased, all but the Inclinometer were biased low; however, even the Watchman reported reasonable wave measurements up to about 6–7 m, after which the Hm0 becomes negatively biased up to about a meter, comparable to previous studies. The parabolic fit peak spectral wave period, Tpp, results showed a large scatter, resulting from the complex nature of multiple swell wave systems compounded by local wind-sea development, exacerbated by a variable that can be considered as temporally unstable. The three directional sensors demonstrated that NOMAD buoys are capable of measuring directional wave properties along the western US coast, with biases of about 6 to 9 deg, and rms errors of approximately 30 deg. Frequency spectral evaluations found similarities in the shape, but a significant under estimation in the high frequency range. The results from slope analyses also revealed a positive bias in the rear face of the spectra, and a lack of invariance in frequency as suggested by theory.


2021 ◽  
Vol 121 ◽  
pp. 102457
Author(s):  
Vania M. Rodríguez-Herrejón ◽  
Alberto Ruiz ◽  
Carlos Rubio-González ◽  
Víctor H. López-Morelos ◽  
Jin-Yeon Kim ◽  
...  

Geophysics ◽  
2019 ◽  
Vol 84 (4) ◽  
pp. D161-D169
Author(s):  
Can Jiang ◽  
Xue-Lian Chen ◽  
Yuan-Da Su ◽  
Xiao-Ming Tang

Acoustic measurements in cased boreholes are important for cement-bond evaluation behind the casing. In conjunction with a recently developed acoustic-wave theory using slip-boundary modeling, we carried out an experimental study for different cement-bond conditions. Four different cased-hole models were constructed, where the interface between the casing and the cement, and that between the cement and the formation, are decoupled or partially bonded to simulate the different cement bond conditions. An acoustic system is placed in the borehole to measure extensional casing waves along the borehole. By extracting the attenuation and velocity of casing waves from the experimental data, the bonding conditions were analyzed and compared with the theoretical modeling. The results indicate that, compared with the free-pipe situation, the casing waves are attenuated when there is some degree of bonding (good or poor) between the casing and the formation. However, when the poor bonding occurs at the cement-formation interface, the casing wave indicates significant velocity reduction and dispersion, the degree of the velocity change varying with the bonding condition. This wave phenomenon is predicted by the slip-boundary modeling. By adjusting the slip-boundary parameters in the modeling, the experimental results can be quantitatively modeled. These results are also confirmed by cased-hole acoustic logging data examples. The theoretical model can therefore be used to interpret cased-borehole acoustic-wave measurements.


Sign in / Sign up

Export Citation Format

Share Document