Surface-enhanced Raman detection of CW agents in water using gold sol gel substrates

Author(s):  
W. Ranjith Premasiri ◽  
Richard H. Clarke ◽  
M. Edward Womble
Author(s):  
F. J. García-Rodríguez ◽  
J. González-Hernández ◽  
F. Pérez-Robles ◽  
Y. V. Vorobiev ◽  
A. Manzano-Ramírez ◽  
...  

Sensors ◽  
2021 ◽  
Vol 21 (23) ◽  
pp. 7912
Author(s):  
Verena Weber ◽  
Laura Brigo ◽  
Giovanna Brusatin ◽  
Giovanni Mattei ◽  
Danilo Pedron ◽  
...  

This paper reports on the fabrication and characterization of a plasmonic/sol-gel sensor for the detection of aromatic molecules. The sol-gel film was engineered using polysilsesquioxanes groups to capture the analyte, through π-π interaction, and to concentrate it close to the plasmonic surface, where Raman amplification occurs. Xylene was chosen as an analyte to test the sensor. It belongs to the general class of volatile organic compounds and can be found in water or in the atmosphere as pollutants released from a variety of processes; its detection with SERS is typically challenging, due to its low affinity toward metallic surfaces. The identification of xylene was verified in comparison with that of other aromatic molecules, such as benzene and toluene. Investigations were carried out on solutions of xylene in cyclohexane, using concentrations in the range from 0 to 800 mM, to evaluate the limit of detection (LOD) of about 40 mM.


2005 ◽  
Vol 59 (5) ◽  
pp. 654-660 ◽  
Author(s):  
Stuart Farquharson ◽  
Alan Gift ◽  
Paul Maksymiuk ◽  
Frank Inscore

Detection of chemical agents as poisons in water supplies not only requires μg/L sensitivity, but also requires the ability to distinguish their hydrolysis products. We have been investigating the ability of surface-enhanced Raman spectroscopy (SERS) to detect chemical agents at these concentrations. Here we expand these studies and present the SERS spectra of the nerve agent VX (ethyl S-2-diisopropylamino ethyl methylphosphonothioate) and its hydrolysis products, ethyl S-2-diisopropylamino methylphosphonothioate, 2-(diisopropylamino) ethanethiol, ethyl methylphosphonic acid, and methylphosphonic acid. Vibrational mode assignments for the observed SERS peaks are also provided. Overall, each of these chemicals produces a series of peaks between 450 and 900 cm−1 that are sufficiently unique to allow identification. SERS measurements were performed in silver-doped sol-gel-filled capillaries that are being developed as part of an extractive point sensor.


Crystals ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 439
Author(s):  
Jesús Alberto Garibay’Alvarado ◽  
Simón Yobanny Reyes-López

Surface Enhanced Infrared Absorption Spectroscopy and Surface Enhanced Raman Spectroscopy are analytic techniques that have not been massively adopted since there are issues that still need to be solved with regard to the nature of the signal enhancement substrates used. The sol–gel method for the obtention of ceramics provides an alternative for the production of said substrates. Ceramics are very wear- and heat-resistant, properties that can be used for their regeneration, and through the sol–gel method, ceramics can be produced with high purity as well as can be fashioned in many ways through different techniques, which can be helpful in the pursuit of reproducibility. This paper discusses the different advantages of sol–gel ceramics, their use in the electrospinning technique, and their application in infrared and Raman surface-enhanced spectroscopy.


Sign in / Sign up

Export Citation Format

Share Document