Site-Specific Activity of Pt Single Crystal Surfaces for Oxygen Reduction Reaction

2020 ◽  
Vol MA2020-01 (38) ◽  
pp. 1689-1689
Author(s):  
Guangdong Liu ◽  
Zhenhua Zeng ◽  
Huiqiu Deng ◽  
Andrew J. Steinbach ◽  
Jeffrey Greeley
Nanomaterials ◽  
2018 ◽  
Vol 8 (11) ◽  
pp. 955 ◽  
Author(s):  
Jing Liu ◽  
Jiao Yin ◽  
Bo Feng ◽  
Tao Xu ◽  
Fu Wang

The Pt particles within diameters of 1–3 nm known as Pt nanoclusters (NCs) are widely considered to be satisfactory oxygen reduction reaction (ORR) catalysts due to higher electrocatalytic performance and cost effectiveness. However, the utilization of such smaller Pt NCs is always limited by the synthesis strategies, stability and methanol tolerance of Pt. Herein, unprotected Pt NCs (~2.2 nm) dispersed on carbon nanotubes (CNTs) were prepared via a modified top-down approach using liquid Li as a solvent to break down the bulk Pt. Compared with the commercial Pt/C, the resultant Pt NCs/CNTs catalyst (Pt loading: 10 wt.%) exhibited more desirable ORR catalytic performance in 0.1 M HClO4. The specific activity (SA) and mass activity (MA) at 0.9 V for ORR over Pt NCs/CNTs were 2.5 and 3.2 times higher than those over the commercial Pt/C (Pt loading: 20 wt.%). Meanwhile, the Pt NCs/CNTs catalyst demonstrated more satisfactory stability and methanol tolerance. Compared with the obvious loss (~69%) of commercial Pt/C, only a slight current decrease (~10%) was observed for Pt NCs/CNTs after the chronoamperometric measurement for 2 × 104 s. Hence, the as-prepared Pt NCs/CNTs material displays great potential as a practical ORR catalyst.


2018 ◽  
Vol 9 (1) ◽  
Author(s):  
Tomoaki Kumeda ◽  
Hiroo Tajiri ◽  
Osami Sakata ◽  
Nagahiro Hoshi ◽  
Masashi Nakamura

2011 ◽  
Vol 1311 ◽  
Author(s):  
Wisam J. Khudhayer ◽  
Nancy Kariuki ◽  
Deborah Myers ◽  
Ali Shaikh ◽  
Tansel Karabacak

ABSTRACTIn this work, we investigated the electrocatalytic oxygen reduction reaction (ORR) activity of vertically aligned, single-layer, carbon-free, and single crystal Pt nanorod arrays utilizing cyclic voltammetry (CV) and rotating-disk electrode (RDE) techniques. A glancing angle deposition (GLAD) technique was used to fabricate 200 nm long Pt nanorods, which corresponds to Pt loading of 0.16 mg/cm2, on glassy carbon (GC) electrode at a glancing angle of 85° as measured from the substrate normal. An electrode comprised of conventional carbon-supported Pt nanoparticles (Pt/C) was also prepared for comparison with the electrocatalytic ORR activity and stability of Pt nanorods. CV results showed that the Pt nanorod electrocatalyst exhibits a more positive oxide reduction peak potential compared to Pt/C, indicating that GLAD Pt nanorods are less oxophilic. In addition, a series of CV cycles in acidic electrolyte revealed that Pt nanorods are significantly more stable against electrochemically-active surface area loss than Pt/C. Moreover, room temperature RDE results demonstrated that GLAD Pt nanorods exhibit higher area-specific ORR activity than Pt/C. The enhanced electrocatalytic ORR activity of Pt nanorods is attributed to their larger crystallite size, single-crystal property, and the dominance of (110) crystal planes on the large surface area nanorods sidewalls, which has been found to be the most active plane for ORR. However, the Pt nanorods showed lower mass specific activity than the Pt/C electrocatalyst due to the large diameter of the Pt nanorods.


RSC Advances ◽  
2017 ◽  
Vol 7 (9) ◽  
pp. 5214-5221 ◽  
Author(s):  
Yejian Xue ◽  
He Miao ◽  
Shanshan Sun ◽  
Qin Wang ◽  
Shihua Li ◽  
...  

Ag doping is one of the best methods for improving the catalytic activity of LaMnO3 perovskites, and the mass specific activity of LAM-30 (La0.7Ag0.3MnO3) can reach 48.0 mA mg−1 which is about 32 times that of LAM-0 (LaMnO3).


Sign in / Sign up

Export Citation Format

Share Document