Petroleum Systems Modelling for Unconventional Play Analysis in the Cooper Basin

2015 ◽  
Author(s):  
Lisa Hall* ◽  
Anthony J. Hill ◽  
Liuqi Wang ◽  
Dianne S. Edwards ◽  
Tehani J. Kuske ◽  
...  
2015 ◽  
Author(s):  
Sugandha Tewari ◽  
Kristijan (Duplo) Kornpihl ◽  
Deepak Rathee ◽  
Tekena West ◽  
Marjosbet Uzcategui-Salazar*

2007 ◽  
Vol 47 (1) ◽  
pp. 127 ◽  
Author(s):  
G. Ambrose ◽  
M. Scardigno ◽  
A.J. Hill

Prospective Middle–Late Triassic and Early Jurassic petroleum systems are widespread in central Australia where they have only been sparsely explored. These systems are important targets in the Simpson/Eromanga basins (Poolowanna Trough and surrounds), but the petroleum systems also extend into the northern and eastern Cooper Basin.Regional deposition of Early–Middle Triassic red-beds, which provide regional seal to the Permian petroleum system, are variously named the Walkandi Formation in the Simpson Basin, and the Arrabury Formation in the northern and eastern Cooper Basin. A pervasive, transgressive lacustrine sequence (Middle–Late Triassic Peera Peera Formation) disconformably overlies the red-beds and can be correlated over a distance of 500 km from the Poolowanna Trough into western Queensland, thus providing the key to unravelling Triassic stratigraphic architecture in the region. The equivalent sequence in the northern Cooper Basin is the Tinchoo Formation. These correlations allow considerable simplification of Triassic stratigraphy in this region, and demonstrate the wide lateral extent of lacustrine source rocks that also provide regional seal. Sheet-like, fluvial-alluvial sands at the base of the Peera Peera/Tinchoo sequence are prime reservoir targets and have produced oil at James–1, with widespread hydrocarbon shows occurring elsewhere including Poolowanna–1, Colson–1, Walkandi–1, Potiron–1 and Mackillop–1.The Early Jurassic Poolowanna Formation disconformably overlies the Peera Peera Formation and can be subdivided into two transgressive, fluvial-lacustrine cycles, which formed on a regional scale in response to distal sea level oscillations. Early Jurassic stratigraphic architecture in the Poolowanna Trough is defined by a lacustrine shale capping the basal transgressive cycle (Cycle 1). This shale partitions the Early Jurassic aquifer in some areas and significant hydrocarbon shows and oil recoveries are largely restricted to sandstones below this seal. Structural closure into the depositional edge of Cycle 1 is an important oil play.The Poolowanna and Peera Peera formations, which have produced minor oil and gas/condensate on test respectively in Poolowanna–1, include lacustrine source rocks with distinct coal maceral compositions. Significantly, the oil-bearing Early Jurassic sequence in Cuttapirrie–1 in the Cooper Basin correlates directly with the Cycle–1 oil pool in Poolowanna–1. Basin modelling in the latter indicates hydrocarbon expulsion occurred in the late Cretaceous (90–100 Ma) with migration into a subtle Jurassic age closure. Robust Miocene structural reactivation breached the trap leaving only minor remnants of water-washed oil. Other large Miocene structures, bound by reverse faults and some reflecting major inversion, have failed to encounter commercial hydrocarbons. Future exploration should target subtle Triassic to Jurassic–Early Cretaceous age structural and combination stratigraphic traps largely free of younger fault dislocation.


2016 ◽  
Vol 56 (2) ◽  
pp. 594
Author(s):  
Lisa Hall ◽  
Tehani Palu ◽  
Chris Boreham ◽  
Dianne Edwards ◽  
Tony Hill ◽  
...  

The Australian Petroleum Source Rocks Mapping project is a new study to improve understanding of the petroleum resource potential of Australia’s sedimentary basins. The Permian source rocks of the Cooper Basin, Australia’s premier onshore hydrocarbon-producing province, are the first to be assessed for this project. Quantifying the spatial distribution and petroleum generation potential of these source rocks is critical for understanding both the conventional and unconventional hydrocarbon prospectivity of the basin. Source rock occurrence, thickness, quality and maturity are mapped across the basin, and original source quality maps prior to the onset of generation are calculated. Source rock property mapping results and basin-specific kinetics are integrated with 1D thermal history models and a 3D basin model to create a regional multi-1D petroleum systems model for the basin. The modelling outputs quantify both the spatial distribution and total maximum hydrocarbon yield for 10 source rocks in the basin. Monte Carlo simulations are used to quantify the uncertainty associated with hydrocarbon yield and to highlight the sensitivity of results to each input parameter. The principal source rocks are the Permian coals and carbonaceous shales of the Gidgealpa Group, with highest potential yields from the Patchawarra Formation coals. The total generation potential of the Permian section highlights the significance of the basin as a world-class hydrocarbon province. The systematic workflow applied here demonstrates the importance of integrated geochemical and petroleum systems modelling studies as a predictive tool for understanding the petroleum resource potential of Australia’s sedimentary basins.


Sign in / Sign up

Export Citation Format

Share Document