Creeping ultrasonic waves have long been successfully used for flaw detection of near-surface and near-bottom zones of metal products. However, due to the fact that the creeping wave generates a lateral transverse wave directed into the metal volume at the third critical angle, it is also possible to test internal defects in principle. At known velocities of propagation of longitudinal and transverse waves in the metal, the third critical angle is easily calculated. Therefore, the time of propagation of the ultrasonic signal along any trajectory between points on the surface and in the volume of the metal can be calculated. Usually, creeping waves are used to test products of plane-parallel shape. There are no cases of their application on curved surfaces in the literature. It is possible that the creeping wave can also propagate over a concave surface. The aim of the article is to test experimentally new ways of using creeping waves. The propagation trajectories of the creeping and lateral transverse waves were studied on a steel plate. The time of passage of the ultrasonic signal along such trajectories of different lengths was measured, and the measurement results were compared with the calculated time values. The measured and calculated values coincided with accuracy sufficient for the coherent accumulation of echo signals that passed through the metal part of the path by the creeping wave and another part of the path by the lateral transverse wave.The propagation of the creeping wave over a concave surface was studied on a steel sample with cylindrical faces of different radii. As a result, it turned out that on a concave surface, the creeping wave propagates at the same speed of longitudinal waves as on a flat surface, but it decays much more strongly with distance. Studies have shown that creeping waves can be used in ultrasonic tomography, where a preliminary calculation of the propagation trajectories of ultrasonic signals is required. The propagation of creeping waves over concave surfaces extends the capabilities of the TOFD method to the area of intube testing
Dominance of Creeping Wave Modes of Backscattered Field from a Conducting Sphere with Dielectric Coating
