Evaluation of Fatigue Properties and Change of Stiffness in Injection Molded Plate of Short Carbon Fiber Reinforced Plastics

2019 ◽  
Vol 2019 (0) ◽  
pp. OS2116
Author(s):  
Hiromu TSUCHIHASHI ◽  
Kenichi SHIMIZU ◽  
Keisuke IWAHORI ◽  
Keisuke TANAKA
Keyword(s):  
Carbon Fiber ◽  
Fatigue Properties ◽  
Fiber Reinforced ◽  
Short Carbon Fiber ◽  
Carbon Fiber Reinforced Plastics ◽  
Reinforced Plastics ◽  
Injection Molded ◽  
Fiber Reinforced Plastics ◽  
Carbon Fiber Reinforced ◽  
Short Carbon

scholarly journals Evaluation of Internal Stress in Short-Carbon-Fiber Reinforced Plastics by Transmission X-Ray Diffraction

2016 ◽  
Vol 65 (9) ◽  
pp. 657-664 ◽  
Author(s):  
Kenichi SHIMIZU ◽  
Yuki KOIKE ◽  
Daiki YAMADA ◽  
Kazuya OHARADA ◽  
Keisuke TANAKA ◽  
...  
Keyword(s):  
Carbon Fiber ◽  
Internal Stress ◽  
Fiber Reinforced ◽  
X Ray Diffraction ◽  
Short Carbon Fiber ◽  
X Ray ◽  
Carbon Fiber Reinforced Plastics ◽  
Reinforced Plastics ◽  
Fiber Reinforced Plastics ◽  
Short Carbon

INCREASING SENSITIVITY OF EDDY CURRENT NON-DESTRUCTIVE TESTING OF DELAMINATION IN CARBON-FIBER REINFORCED PLASTICS

2021 ◽  
pp. 28-37
Author(s):  
P. N. Shkatov ◽  
G. A. Didin ◽  
A. A. Ermolaev
Keyword(s):  
Carbon Fiber ◽  
Eddy Current ◽  
Calculation Model ◽  
Fiber Reinforced ◽  
Destructive Testing ◽  
Carbon Fiber Reinforced Plastics ◽  
Reinforced Plastics ◽  
Fiber Reinforced Plastics ◽  
Carbon Fiber Reinforced ◽  
The Difference

The paper is concerned with increasing sensitivity of eddy current nondestructive testing of most dangerous delamination in carbon-fiber reinforced plastics (CFRP). Increased sensitivity is achieved by separate registration and comparison of eddy current signals obtained from a set of stratifications of carbon fibers with the same orientation. The separation of eddy current signals is possible due to pronounced anisotropy of the electrical conductivity of the layers dominant in the direction of the fibers of the corresponding layer. Eddy-current signals are registered by eddy current probes with maximum sensitivity in a given angular direction. Prior to the scan eddy current signals of the probe are leveled on a defect-free area. The influence of the working gap on the difference between the eddy current signals of the probe is suppressed by normalizing it according to one of the signals. The analysis of the registered signals from delamination has been performed using an approximate calculation model. The reliability of the obtained results has been confirmed by comparison with experimental results and calculations using the finite element method.

Sign in / Sign up

Export Citation Format

Share Document