scholarly journals Flow Patterns and Frictional Pressure Drop in Gas-Liquid Two-Phase Flow in Vertical Capillary Channels with Rectangular Cross Section.

1997 ◽  
Vol 63 (606) ◽  
pp. 452-460 ◽  
Author(s):  
Hideo IDE ◽  
Hirohisa MATSUMURA ◽  
Yuji TANAKA ◽  
Tohru FUKANO
Keyword(s):  
Pressure Drop ◽  
Cross Section ◽  
Two Phase Flow ◽  
Rectangular Cross Section ◽  
Flow Patterns ◽  
Phase Flow ◽  
Two Phase ◽  
Frictional Pressure Drop

Experimental Investigation on Flow Patterns and Frictional Pressure Drop of Downward Air-Water Two-Phase Flow in Vertical Pipes

2013 ◽  
Author(s):  
Yuqing Xue ◽  
Huixiong Li ◽  
Tianyou Sheng ◽  
Changjiang Liao
Keyword(s):  
Pressure Drop ◽  
Flow Pattern ◽  
Oil Recovery ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Vertical Pipe ◽  
Two Phase Flows ◽  
Two Phase ◽  
Frictional Pressure Drop

A large amount of air need be transported into the reservoir in the deep stratum to supply oxygen to some microbes in Microbial Enhanced Oil Recovery (MEOR). Air-water two-phase flows downward along vertical pipeline during the air transportation. Base on the experiment data described in this paper, the characteristics of air-water two phase flow patterns were investigated. The flow pattern map of air-water two phase flows in the pipe with inner diameter of 65 mm was drawn, criterions of flow pattern transition were discussed, and the dynamic signals of the pressure and the differential pressure of the two phase flow were recorded to characterize the three basic flow regimes indirectly. The frictional pressure drop of downward flow in vertical pipe must not be disregarded contrast with upward two phase flow in the vertical pipe because the buoyancy must be overcame when the gas flows downward along pipe, and there would be a maximum value of frictional when the flow pattern translated from slug flow to churn flow.

Flow Patterns and Frictional Pressure Drop of Gas-Liquid Two-Phase Flow in Microchannels

2016 ◽  
Vol 2016 (0) ◽  
pp. J0540102
Author(s):  
Hideo IDE ◽  
Takayuki UMENO ◽  
Eiji KINOSHITA ◽  
Takeshi OhTAKA ◽  
Ryo KUROSHIMA
Keyword(s):  
Pressure Drop ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Phase Flow ◽  
Two Phase ◽  
Frictional Pressure Drop

Flow Characteristics and Frictional Pressure Drops of Gas-Liquid Two-Phase Flow in Mini-Micro Pipes and at Vena Contract and Expansion

2007 ◽  
Author(s):  
Hiroyasu Ohtake ◽  
Hideyasu Ohtaki ◽  
Yasuo Koizumi
Keyword(s):  
Pressure Drop ◽  
Flow Pattern ◽  
Two Phase Flow ◽  
Liquid Velocity ◽  
Flow Patterns ◽  
Experimental Results ◽  
Phase Flow ◽  
Two Phase ◽  
Pressure Drops ◽  
Frictional Pressure Drop

The frictional pressure drops and two-phase flow patterns of gas-liquid two-phase flow in mini-micro pipes and at vena contract and expansion were investigated experimentally. Test liquid was water; test gas was argon. The diameter of the test mini-pipe was 0.5, 0.25 and 0.12 mm, respectively. The pressure drop data and the flow pattern were collected over 2.1 < Ug < 92.5 m/s for the superficial gas velocity and 0.03 < Ul < 10 m/s for the superficial liquid velocity. The experimental results show that the flow patterns were slug, churn, ring and annular flows; pure bubbly flow pattern was not observed in a range of the present experimental conditions. The two-phase friction multiplier data for D > 0.5 mm showed to be in good agreement with the conventional correlations. On the other hand, the two-phase friction multiplier data for D < 0.25 mm differed from the calculated values by the conventional correlations. Then, thickness of liquid film around a gas plug and size of gas core were estimated and the effect of frictional pressure drop on channel size was discussed through Knudsen Number of gas and instability on liquid-gas interface. The coefficients of sudden enlargement and sudden contraction in mini-pipes for the gas-water two-phase flow were modified from the present experimental results.

Flow Patterns and Pressure Drop in Air/Water Two-Phase Flow in Horizontal Helicoidal Pipes

1995 ◽  
Vol 117 (4) ◽  
pp. 720-726 ◽  
Author(s):  
A. Awwad ◽  
R. C. Xin ◽  
Z. F. Dong ◽  
M. A. Ebadian ◽  
H. M. Soliman
Keyword(s):  
Pressure Drop ◽  
Two Phase Flow ◽  
Helix Angle ◽  
Flow Patterns ◽  
Current Data ◽  
Phase Flow ◽  
Air Velocity ◽  
Two Phase ◽  
Frictional Pressure Drop ◽  
Flow Pressure

An experimental investigation is conducted for air/water two-phase flow in horizontal helicoidal pipes. The helicoidal pipes are constructed of 25.4 mm I.D. Tygon tubing wrapped around cylindrical concrete forms with outside diameters of 62 cm and 124 cm. The helix angles of the helicoidal pipes vary from 1 to 20 deg. The experiments are performed for superficial water velocity in a range of UL = 0.008 ~ 2.2 m/s and for superficial air velocity in a range of UG = 0.2 ~ 50 m/s. The flow patterns are discerned and recorded photographically. The pressure drop of the air/water two-phase flow in the coils is measured and the Lockhart-Martinelli approach is used to analyze the data. The results are presented in the form of frictional pressure drop multipliers versus the Lockhart-Martinelli parameter. It was found that the flow patterns differ greatly from those of the straight pipe, and that the frictional pressure drop multipliers depend on both the Lockhart-Martinelli parameter and the flow rates. The correlation of the frictional pressure drop has been provided based on the current data. Furthermore, it was also found that the helix angle of the helicoidal pipe had almost no effect on the air/water two-phase flow pressure drop in the present experimental ranges.

Two-Phase Flow and Heat Transfer in Rectangular Micro-Channels

2003 ◽  
Author(s):  
Weilin Qu ◽  
Seok-Mann Yoon ◽  
Issam Mudawar
Keyword(s):  
Heat Transfer ◽  
Pressure Drop ◽  
Flow Pattern ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Heat Sinks ◽  
Phase Flow ◽  
Micro Channel ◽  
Two Phase ◽  
Micro Channels

Knowledge of flow pattern and flow pattern transitions is essential to the development of reliable predictive tools for pressure drop and heat transfer in two-phase micro-channel heat sinks. In the present study, experiments were conducted with adiabatic nitrogen-water two-phase flow in a rectangular micro-channel having a 0.406 × 2.032 mm cross-section. Superficial velocities of nitrogen and water ranged from 0.08 to 81.92 m/s and 0.04 to 10.24 m/s, respectively. Flow patterns were first identified using high-speed video imaging, and still photos were then taken for representative patterns. Results reveal that the dominant flow patterns are slug and annular, with bubbly flow occurring only occasionally; stratified and churn flow were never observed. A flow pattern map was constructed and compared with previous maps and predictions of flow pattern transition models. Annual flow is identified as the dominant flow pattern for conditions relevant to two-phase micro-channel heat sinks, and forms the basis for development of a theoretical model for both pressure drop and heat transfer in micro-channels. Features unique to two-phase micro-channel flow, such as laminar liquid and gas flows, smooth liquid-gas interface, and strong entrainment and deposition effects are incorporated into the model. The model shows good agreement with experimental data for water-cooled heat sinks.

Evaluation Analysis of Prediction Methods for Two-Phase Flow Pressure Drop in Mini-Channels

2008 ◽  
Author(s):  
Licheng Sun ◽  
Kaichiro Mishima
Keyword(s):  
Pressure Drop ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Turbulent Region ◽  
Frictional Pressure Drop ◽  
New Correlation ◽  
Mini Channels ◽  
Flow Pressure ◽  
Better Than

2092 data of two-phase flow pressure drop were collected from 18 published papers of which the working fluids include R123, R134a, R22, R236ea, R245fa, R404a, R407C, R410a, R507, CO2, water and air. The hydraulic diameter ranges from 0.506 to 12mm; Relo from 10 to 37000, and Rego from 3 to 4×105. 11 correlations and models for calculating the two-phase frictional pressure drop were evaluated based upon these data. The results show that the accuracy of the Lockhart-Martinelli method, Mishima and Hibiki correlation, Zhang and Mishima correlation and Lee and Mudawar correalion in the laminar region is very close to each other, while the Muller-Steinhagen and Heck correlation is the best among the evaluated correlations in the turbulent region. A modified Chisholm correlation was proposed, which is better than all of the evaluated correlations in the turbulent region and its mean relative error is about 29%. For refrigerants only, the new correlation and Muller-Steinhagen and Heck correlation are very close to each other and give better agreement than the other evaluated correlations.

Two-Phase Flow Through Square and Circular Microchannels—Effects of Channel Geometry

2004 ◽  
Vol 126 (4) ◽  
pp. 546-552 ◽  
Author(s):  
Peter M.-Y. Chung ◽  
Masahiro Kawaji ◽  
Akimaro Kawahara ◽  
Yuichi Shibata
Keyword(s):  
Pressure Drop ◽  
Void Fraction ◽  
Two Phase Flow ◽  
Flow Characteristics ◽  
Separated Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Channel Geometry ◽  
Frictional Pressure Drop ◽  
Channel Shape

An adiabatic experiment was conducted to investigate the effect of channel geometry on gas-liquid two-phase flow characteristics in horizontal microchannels. A water-nitrogen gas mixture was pumped through a 96 μm square microchannel and the resulting flow pattern, void fraction and frictional pressure drop data were compared with those previously reported by the authors for a 100 μm circular microchannel. The pressure drop data were best estimated using a separated-flow model and the void fraction increased non-linearly with volumetric quality, regardless of the channel shape. However, the flow maps exhibited transition boundaries that were shifted depending on the channel shape.

Sign in / Sign up

Export Citation Format

Share Document