scholarly journals OSOAA: a vector radiative transfer model of coupled atmosphere-ocean system for a rough sea surface application to the estimates of the directional variations of the water leaving reflectance to better process multi-angular satellite sensors data over the ocean

2015 ◽  
Vol 23 (21) ◽  
pp. 27829 ◽  
Author(s):  
Malik Chami ◽  
Bruno Lafrance ◽  
Bertrand Fougnie ◽  
Jacek Chowdhary ◽  
Tristan Harmel ◽  
...  
Keyword(s):  
Radiative Transfer ◽  
Sea Surface ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Surface Application ◽  
Satellite Sensors ◽  
Rough Sea Surface ◽  
Rough Sea

scholarly journals Improving Satellite-Derived Sea Surface Temperature Accuracies Using Water Vapor Profile Data

2011 ◽  
Vol 28 (1) ◽  
pp. 85-93 ◽  
Author(s):  
Ian J. Barton
Keyword(s):  
Water Vapor ◽  
Radiative Transfer ◽  
Surface Temperature ◽  
Sea Surface Temperature ◽  
Satellite Data ◽  
Sea Surface ◽  
Radiative Transfer Model ◽  
Clear Correlation ◽  
Transfer Model ◽  
The Difference

Abstract Analyses based on atmospheric infrared radiative transfer simulations and collocated ship and satellite data are used to investigate whether knowledge of vertical atmospheric water vapor distributions can improve the accuracy of sea surface temperature (SST) estimates from satellite data. Initially, a simulated set of satellite brightness temperatures generated by a radiative transfer model with a large maritime radiosonde database was obtained. Simple linear SST algorithms are derived from this dataset, and these are then reapplied to the data to give simulated SST estimates and errors. The concept of water vapor weights is introduced in which a weight is a measure of the layer contribution to the difference between the surface temperature and that measured by the satellite. The weight of each atmospheric layer is defined as the layer water vapor amount multiplied by the difference between the SST and the midlayer temperature. Satellite-derived SST errors are then plotted against the difference in the sum of weights above an altitude of 2.5 km and that below. For the simple two-channel (with typical wavelengths of 11 and 12 μm) analysis, a clear correlation between the weights differences and the SST errors is found. A second group of analyses using ship-released radiosondes and satellite data also show a correlation between the SST errors and the weights differences. The analyses suggest that, for an SST derived using a simple two-channel algorithm, the accuracy may be improved if account is taken of the vertical distribution of water vapor above the ocean surface. For SST estimates derived using algorithms that include data from a 3.7-μm channel, there is no such correlation found.

Rough Sea-Surface Model for Vector Radiative Transfer of Coupled Ocean-Atmosphere System

2010 ◽  
Vol 30 (3) ◽  
pp. 618-624
Author(s):  
何贤强 He Xianqiang ◽  
潘德炉 Pan Delu ◽  
白雁 Bai Yan ◽  
朱乾坤 Zhu Qiankun ◽  
龚芳 Gong Fang ◽  
...  
Keyword(s):  
Radiative Transfer ◽  
Sea Surface ◽  
Surface Model ◽  
Atmosphere System ◽  
Ocean Atmosphere ◽  
Rough Sea Surface ◽  
Rough Sea

scholarly journals Effect of Out-of-Band Response in NOAA-16 AVHRR Channel 3b on Top-of-Atmosphere Radiances Calculated with the Community Radiative Transfer Model

2009 ◽  
Vol 26 (9) ◽  
pp. 1968-1972 ◽  
Author(s):  
Quanhua Liu ◽  
Xingming Liang ◽  
Yong Han ◽  
Paul van Delst ◽  
Yong Chen ◽  
...  
Keyword(s):  
High Resolution ◽  
Radiative Transfer ◽  
Surface Temperature ◽  
Sea Surface Temperature ◽  
Surface Wind ◽  
Sea Surface ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Absorption Bands ◽  
Clear Sky

Abstract The Community Radiative Transfer Model (CRTM) developed at the Joint Center for Satellite Data Assimilation (JCSDA) is used in conjunction with a daily sea surface temperature (SST) and the National Centers for Environmental Prediction (NCEP) Global Forecast System (GFS) atmospheric data and surface wind to calculate clear-sky top-of-atmosphere (TOA) brightness temperatures (BTs) in three Advanced Very High Resolution Radiometer (AVHRR) thermal infrared channels over global oceans. CRTM calculations are routinely performed by the sea surface temperature team for four AVHRR instruments on board the National Oceanic and Atmospheric Administration (NOAA) satellites NOAA-16, NOAA-17, and NOAA-18 and the Meteorological Operation (MetOp) satellite MetOp-A, and they are compared with clear-sky TOA BTs produced by the operational AVHRR Clear-Sky Processor for Oceans (ACSPO). It was observed that the model minus observation (M−O) bias in the NOAA-16 AVHRR channel 3b (Ch3b) centered at 3.7 μm experienced a discontinuity of ∼0.3 K when a new CRTM version 1.1 (v.1.1) was implemented in ACSPO processing in September 2008. No anomalies occurred in any other AVHRR channel or for any other platform. This study shows that this discontinuity is caused by the out-of-band response in NOAA-16 AVHRR Ch3b and by using a single layer to the NCEP GFS temperature profiles above 10 hPa for the alpha version of CRTM. The problem has been solved in CRTM v.1.1, which uses one of the six standard atmospheres to fill in the missing data above the top pressure level in the input NCEP GFS data. It is found that, because of the out-of-band response, the NOAA-16 AVHRR Ch3b has sensitivity to atmospheric temperature at high altitudes. This analysis also helped to resolve another anomaly in the absorption bands of the High Resolution Infrared Radiation Sounder (HIRS) sensor, whose radiances and Jacobians were affected to a much greater extent by this CRTM inconsistency.

A vector radiative transfer model for sea-surface salinity retrieval from space: a non-raining case

2018 ◽  
Vol 39 (22) ◽  
pp. 8361-8385 ◽  
Author(s):  
Xu-Chen Jin ◽  
De-Lu Pan ◽  
Xian-Qiang He ◽  
Yan Bai ◽  
Palanisamy Shanmugam ◽  
...  
Keyword(s):  
Radiative Transfer ◽  
Sea Surface ◽  
Sea Surface Salinity ◽  
Radiative Transfer Model ◽  
Transfer Model ◽  
Surface Salinity
Sign in / Sign up

Export Citation Format

Share Document