Evidence for a Structural Transition to a Superprotonic CsH2PO4 Phase Under High Pressure

2006 ◽  
Vol 929 ◽  
Author(s):  
Cristian E. Botez ◽  
Russell R. Chianelli ◽  
Jianzhong Zhang ◽  
Jiang Qian ◽  
Yusheng Zhao ◽  
...  

ABSTRACTWe have used synchrotron X-ray powder diffraction (SXRPD) to investigate the structural behavior of cesium dihydrogen phosphate upon heating. Temperature-resolved data collected at ambient-pressure demonstrate that a transition from the room-temperature monoclinic phase (P21/m; a=7.90Å, b=6.39Å, c=4.87Å, and β=107.64°) to a high-temperature cubic phase (Pm3m; a=4.96Å) occurs at T=237°C. The high-temperature phase is not stable under ambient-pressure conditions, even in the absence of further heating. On the other hand, SXRPD measurements carried out under high-pressure (∼1GPa) evidence a transition from monoclinic to a stable cubic phase (Pm3m, a=4.88Å) at a temperature within the 255°C-275°C range. A 1000-fold increase in the proton conductivity (indicating the transition to the superprotonic phase) was previously observed under the same non-ambient conditions. Therefore, our results represent strong evidence that the superprotonic behavior in cesium dihydrogen phosphate is associated with a monoclinic-to-cubic polymorphic structural transition and not with chemical modifications.

2016 ◽  
Vol 840 ◽  
pp. 375-380
Author(s):  
Meor Yusoff Meor Sulaiman ◽  
Khaironie Mohamed Takip ◽  
Ahmad Khairulikram Zahari

The high temperature phase transition of zirconia produced from commercial zirconyl chloride chemical was compared with that produced from a Malaysian zircon mineral. Zirconyl chloride was produced from zircon by using the hydrothermal fusion method. Initial XRD diffractogram of these samples at room temperature show that they are of amorphous structure. High temperature XRD studies was then performed on these samples; heated up to 1500°C. The XRD diffractograms shows that the crystalline structure of tetragonal zirconia was first observed and the monoclinic zirconia becomes more visible at higher heating temperature.


2004 ◽  
Vol 24 (1) ◽  
pp. 111-116 ◽  
Author(s):  
G. Ferlat ◽  
D. Martínez-García ◽  
A. San Miguel ◽  
A. Aouizerat ◽  
V. Muñoz-Sanjosé

1982 ◽  
Vol 37 (11) ◽  
pp. 1487-1488 ◽  
Author(s):  
Jürgen Evers ◽  
Gilbert Oehlinger ◽  
Armin Weiss

The high pressure-high temperature phase of CaSi2 is a representative of the α-ThSi2 type of structure. Single crystals grown at 40 kbar and 1000 °C enabled a structural refinement which leads to interatomic distances Si-Si: 229.9(1) pm (1 × ) and 240.0(1) pm (2 × ), Ca-Si: 309.4(4) pm (4 x ) and 323.9(4) pm (8 × ), Ca-Ca: 400.3(3) pm (4 × ) and 428.3(3) pm (4 × ).


Sign in / Sign up

Export Citation Format

Share Document