scholarly journals Influence assessment of the passive restraint system devices of the passenger locomotive on its dynamic loading during accidenton the railroad

Author(s):  
N. E. Naumenko ◽  
I. Yu. Khizha
Author(s):  
Edmundo Rodarte ◽  
Jerry L. Purswell ◽  
Robert Schlegel ◽  
Richard F. Krenek

There are a variety of conditions that can exist in the post-crash environment which make rapid escape necessary for survival or to avoid further injury. These include a post-crash fire, the vehicle going into the water, or avoiding being struck in a secondary collision. The National Highway Traffic Safety Administration (NHTSA) has defined this parameter vehicle escapeworthiness. It has been estimated in past research performed by the author for NHTSA that escapeworthiness becomes important in up to 7% of all vehicle crashes. Since escapeworthiness research was performed in the early 1970's, the advent of passive shoulder belt systems has made it necessary to again review the impact of this development on escapeworthiness. In particular, the inability of the occupants to release the passive restraint because the door cannot be opened after the crash, coupled with the inability to release the passive restraint due to its design or a lack of experience, or knowledge of how to release the passive restraint while the door is closed, creates a serious problem. Thus, the present study was performed to investigate the impact of passive restraint systems on the time required to escape from the vehicle under various conditions of available escape routes, and physical condition of the occupants. The experimental design included the variables of age, gender, escape route, level of incapacitation and type of passive restraint system. The times to effect an escape as well as the method of escaping were determined through videographic analysis of all escape trials. The findings demonstrated that the use of passive restraint systems increased the time to escape significantly, ranging from 37 to 65 percent for the respective conditions. This difference may determine whether a person survives or not after some post-crash conditions. The results have significance for the design of passive restraint systems for easy release, while at the same time not creating an incentive for some users to routinely leave the passive restraint unfastened.


2017 ◽  
Vol 23 (1) ◽  
pp. 85-99 ◽  
Author(s):  
Behrang Keshavarz ◽  
Alison C. Novak ◽  
Lawrence J. Hettinger ◽  
Thomas A. Stoffregen ◽  
Jennifer L. Campos

Author(s):  
Arda Ozdiler ◽  
suleyman dayan ◽  
Burc Gencel ◽  
Gulbahar Isık-Ozkol

This in vitro study evaluated the influence of taper angles on the internal conical connections of implant systems and of the application of chlorhexidine gel as an antibacterial agent or a polyvinyl siloxane (PVS) sealant on the reverse torque values of abutment screws after dynamic loading. The current study tested four implant systems with different taper angles (5.4°, 12°, 45°, and 60°). Specimens were divided into three groups: control (neither chlorhexidine gel filled nor silicone sealed), 2% chlorhexidine gel-filled or silicone-sealed group, and group subjected to a dynamic load of 50 N at 1 Hz for 500,000 cycles prior to reverse torque measurements. Quantitative positive correlation was observed between the taper angle degree and the percentage of tightening torque loss. However, this correlation was significant only for the 60° connection groups except in the group in which a sealant was applied ( p = 0.013 for the control group, p = 0.007 for the chlorhexidine group). Percentages of decrease in the torque values of the specimens with silicone sealant application were significantly higher compared with both the control and chlorhexidine groups ( p = 0.001, p = 0.002, p = 0.001, and p = 0.002, respectively, according to the increasing taper angles); the percentage of decrease in torque values due to chlorhexidine application was statistically insignificant when compared with the control group. The application of gel-form chlorhexidine as an antibacterial agent does not significantly affect the stability of the implant–abutment connection under dynamic loads. PVS sealants may cause screw loosening under functional loads.


2020 ◽  
Vol 49 (5) ◽  
pp. 439-445
Author(s):  
G. G. Savenkov ◽  
V. V. Stolyarov ◽  
A. V. Kuznetsov ◽  
Yu. I. Meshcheryakov
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document