EFFECT OF CHARACTERISTIC DIMENSION OF SURFACE STRUCTURE AND PARTICLES ON THE CONTACT LINE MOTION OF SESSILE SUSPENDED DROPLET EVAPORATION

2018 ◽  
Author(s):  
Yutaka Yamda ◽  
Akihiko Horibe
2008 ◽  
Vol 138 (2) ◽  
pp. 101-120 ◽  
Author(s):  
Khellil Sefiane ◽  
Jennifer Skilling ◽  
Jamie MacGillivray

1995 ◽  
Vol 102 (3) ◽  
pp. 256-270 ◽  
Author(s):  
Ann T. Shih ◽  
Constantine M. Megaridis

2019 ◽  
Vol 3 (4) ◽  
pp. 60 ◽  
Author(s):  
Kostoglou ◽  
Karapantsios

In real life, sessile droplets usually have a three-dimensional shape, making it difficult to understand their forced wetting behavior, both from an experimental and a theoretical perspective. Even in the case of spreading under quasi-static conditions, where the droplet shape is described by the Young–Laplace equation, there is no fundamental approach to describe the contact line evolution. In the present work, a few existing approaches on this issue are analyzed and assessed. It is shown that an experimentally inspired fixed shape for the contact line of droplets that are spreading under the action of tangential forces can be considered equivalent to a theory for contact line motion. There is a lack of experimental data for contact line evolution under arbitrary scenarios of forces. Such data will be very helpful for the further development of the suggested approach to contact line motion. Of particular interest is the case of small contact angle droplets, for which a top view can clearly indicate the contact line location. On the contrary, in such droplets, the direct experimental measurement of contact angle profile is very difficult. This must be estimated theoretically; thus, a special approach has been developed here for this purpose.


Author(s):  
Artur Lutfurakhmanov ◽  
Yechun Wang ◽  
Douglas L. Schulz

A new capillary-based lithography technique of liquid droplet deposition is further developed. Main advantage of this method in comparison with others techniques is that it is non-invasive both to the substrate and to the writing tip. The method is studied both theoretically and experimentally. To adequately describe bridge dynamics between the capillary and the substrate, proper boundary conditions must be set in the model for the liquid-surface interface. Based on literature review, two laws of contact line motion are identified: Tanner’s law and Blake’s equation. These two approaches are tested in multiple experiments with different retraction speeds from 3 microns/s to 300 microns/s. Analysis of the experimental data show that both Tanner’s and Blake’s equation can describe the correlation between the contact line velocity and the dynamic contact angle. In addition, both laws are employed in the direct numerical simulation of the bridge dynamics using 3D spectral boundary element method. Modeling results are compared with experimental data and show good agreement.


2013 ◽  
Vol 1 (2) ◽  
pp. 84-91 ◽  
Author(s):  
Katherine M. Smyth ◽  
Adam T. Paxson ◽  
Hyuk-Min Kwon ◽  
Kripa K. Varanasi

2011 ◽  
Vol 66 (14) ◽  
pp. 3452-3458 ◽  
Author(s):  
M.R. Kamali ◽  
J.J.J. Gillissen ◽  
S. Sundaresan ◽  
H.E.A. Van den Akker

Sign in / Sign up

Export Citation Format

Share Document