LOCAL BUCKLING STRENGTH OF CORRODED ANGLE AND CHANNEL STEEL SHAPES AND ITS EVALUATION USING EFFECTIVE WIDTH THEORY

2018 ◽  
Keyword(s):  
Local Buckling ◽  
Effective Width ◽  
Buckling Strength ◽  
Steel Shapes

Local buckling capacity of C-shaped cold-formed steel sections with punched webs

1984 ◽  
Vol 11 (1) ◽  
pp. 1-7 ◽  
Author(s):  
Robert Loov
Keyword(s):  
Local Buckling ◽  
Effective Width ◽  
Test Results ◽  
Average Yield ◽  
Steel Sections ◽  
Load Tests ◽  
Cold Formed Steel ◽  
Stub Column ◽  
Best Fit ◽  
The Web

Load tests were carried out on 36 stub column samples of cold-formed steel studs having 38.1 mm wide × 44.5 mm long holes punched through their webs, steel thicknesses of 1.21–2.01 mm, and overall section depths of 63–204 mm. Based on these tests a best-fit equation for the effective width of the unstiffened portion of the web beside the holes has been developed. Suggested design equations have been proposed. The test results support the present equation for the average yield stress [Formula: see text] in Canadian Standards Association Standard S136-1974 but the present code equations for unstiffened plates are unduly conservative when applied to the design of the web adjacent to openings of the size considered.

scholarly journals Compression Test on Cold-Formed Steel Built-Up Back-to-Back Channels Stub Columns

2011 ◽  
Vol 201-203 ◽  
pp. 2900-2903 ◽  
Author(s):  
Chui Huon Tina Ting ◽  
Hieng Ho Lau
Keyword(s):  
Compression Test ◽  
Failure Modes ◽  
Local Buckling ◽  
Effective Width ◽  
Test Results ◽  
Direct Strength Method ◽  
Cold Formed Steel ◽  
Stub Column ◽  
Hot Rolled ◽  
Stub Columns

Built-up sections are used to resist load induced in a structure when a single section is not sufficient to carry the design load for example roof trusses. In current North American Specification, the provision has been substantially taken from research in hot-rolled built-up members connected with bolts or welds [1]. The aim of this paper is to investigate on built-up back-to-back channels stub columns experimentally and theoretically using Effective Width Method and Direct Strength Method. Compression test was performed on 5 lipped channel and 5 back-to-back channels stub columns fabricated from cold-formed steel sheets of 1.2mm thicknesses. The test results indicated that local buckling is the dominant failure modes of stub columns. Therefore, Effective Width Method predicts the capacity of stub columns compared to Direct Strength Method. When compared to the average test results, results based on EWM are 5% higher while results based on DSM are 12% higher for stub column.

Sign in / Sign up

Export Citation Format

Share Document