Studies of Physicochemical and Catalytic Properties of Mixed Oxide CuO-Fe2O3-Al2O3 for Reactions of Deep Oxidation

2017 ◽  
Vol 17 (4) ◽  
pp. 315-323 ◽  
Author(s):  
A. V. Fedorov ◽  
D. Yu. Ermakov ◽  
V. V. Kaichev ◽  
J. A. Bulavchenko ◽  
V. A. Yakovlev
Author(s):  
Tran Thi Thu Huyen ◽  
Dang Thi Minh Hue ◽  
Nguyen Thi Tuyet Mai ◽  
Tran Thi Luyen ◽  
Nguyen Thi Lan

Gases of m-xylene is one of the popurlar toxic pollutants in the exhaust gases, it is emitted into the environment from factories and engines because the fuel in the engine does not burn completely. The best solution in order to remove this toxic gases of m-xylene to protect the environment is transforming them completely into CO2 and H2O by catalysts. Perovskite of LaMnO3 is one of the catalysts that was synthesized and studied the catalytic properties in total oxidation of m-xylene in our previous report. Obtained results showed that the LaMnO3 perovskite has good catalytic characterizations such as large surface area and the amount of α-oxygen adsorbed on the catalyst is large too. So, it exhibits a good catalytic activity in total oxidation of m-xylene at relatively low reaction temperature. In present work, the reaction order  and kinetics of this reaction are determined. The obtained results demonstrated that the reaction order value with respect to m-xylene is equal to about 1, to oxygene is proximately equal to 0 and the order of reaction is equal to about 1. Based on reaction order data, it was thought that the pathway of m-xylene oxidation by air oxygen  over LaMnO3 may be followed through which the Langmuir - Hinshelwood mechanism. Keywords Catalyst, perovskite, oxidation, m-xylene, kinetics References [1] Penã M.A and Fierro J.L.G (2001), << Chemical Stuctures and Performance of Perovskite Oxide>>, Chem. Rev, 101, pp 1981-2018. [2] Seiyama T., Yamazoe N. and Eguchi K. (1985), <<Characterization and Activity of some Mixed Metal Oxide Catalysts>>, Ind. Eng. Chem. Prod. Res. Dev., 24, pp. 19-27.[3] [3] Van Santen R. A., Neurock M. (2006), Molecular Heterogeneous catalysis, Wiley – VCH, pp.62-244. [4] Petrovics, Terlecki - Baricevic A., Karanovic Lj., Kirilov - Stefanov P. , Zdujic M., Dondur V., Paneva D., Mitov I., Rakic V. (2008), <<LaMO3 (M = Mg, Ti, Fe) perovskite type oxides : Preparation, Characterization and Catalytic Properties in Methane deep Oxidation>>, Appl. Catal. B, Env., 79, pp. 186-198. [5] Spinicci R., Tofanari A., Faticanti M., Pettiti I. and Porta P. (2001), <<Hexane Total Oxidation on LaMO3 (M = Mn, Co, Fe) perovskite-type oxides>>, J. Mole. Catal., 176, pp. 247-252. [6] Trần Thị Thu Huyền, Nguyễn Thị Minh Hiền, Nguyễn Hữu Phú (2006), <<Study on the preparation of perovskite oxides La1-xSrxMnO3 (x = 0; 0,3; 0,5) by sol - gel citrate method and their catalytic activity for m-xylene toltal oxidation>>, Hội nghị xúc tác và hấp phụ toàn quốc lần thứ IV, Tp. Hồ Chí Minh, Tr. 477-482.[7] Trần Thị Thu Huyền, Nguyễn Thị Minh Hiền, Nguyễn Hữu Phú (2009), <<Nghiên cứu động học của phản ứng oxi hóa hoàn toàn m-xylen trên các xúc tác perovskit LaMnO3 và La0,7A0,3MnO3 (A = Sr, Ca, Mg)>>, Tạp chí Hóa học, T.47 (6A), Tr 132-136.[8] Geoffrey C. Bond, Catherine Louis, David T. Thompson (2006), <<Catalysis by Gold>>, Catalytic Science Series-Vol.6.


1993 ◽  
Vol 63-65 ◽  
pp. 731-735 ◽  
Author(s):  
C MAZZOCCHIA ◽  
A KADDOURI ◽  
R ANOUCHINSKY ◽  
M SAUTEL ◽  
G THOMAS

2009 ◽  
Vol 361 (1-2) ◽  
pp. 106-116 ◽  
Author(s):  
K. Jirátová ◽  
J. Mikulová ◽  
J. Klempa ◽  
T. Grygar ◽  
Z. Bastl ◽  
...  
Keyword(s):  

RSC Advances ◽  
2014 ◽  
Vol 4 (71) ◽  
pp. 37679-37686 ◽  
Author(s):  
Abbas Teimouri ◽  
Bahareh Najari ◽  
Alireza Najafi Chermahini ◽  
Hossein Salavati ◽  
Mahmoud Fazel-Najafabadi

Molybdenum oxide catalysts with MoO3 loadings ranging from 6.6 to 25 wt% supported on ZrO2–γ-Al2O3 (1 : 1 wt%) mixed oxide were prepared by a wet impregnation method.


1998 ◽  
Vol 16 (1) ◽  
pp. 21-32 ◽  
Author(s):  
G.A. El-Shobaky ◽  
A.M. Ghozza ◽  
N.M. Deraz

Ferric–nickel/aluminium mixed oxide solids have the formula Fe2O3–0.42NiO/Al2O3 were treated with Li2O (0.75–3 mol%) and heated in air for 4 h at 500°C and 800°C, respectively. The effects of this treatment on the surface characteristics of these solids and their catalytic properties in relation to CO oxidation by O2 have been investigated. The results reveal that Li2O doping at 0.75 mol% concentration resulted in an increase of 24% and 18%, respectively, in the value of the specific surface areas, SBET, of the solids precalcined at 500°C and 800°C, while the addition of 3 mol% Li2O led to a slight decrease of ca. 10% in the SBET value of the same solids. In contrast, irrespective of whether the doping process involved solids precalcined at 500°C or 800°C, a significant decrease of 37% and 78%, respectively, was observed in the catalytic activity of these materials. This decrease in catalytic activity was not accompanied by any appreciable change in the magnitude of the activation energy for the catalytic reaction, i.e. Li2O doping brings about a decrease in the concentration of catalytically active sites without changing their energetic nature.


2005 ◽  
Vol 238 (1-2) ◽  
pp. 127-134 ◽  
Author(s):  
Sergio L. González-Cortés ◽  
Tian-Cun Xiao ◽  
Pedro M.F.J. Costa ◽  
Serbia M.A. Rodulfo-Baechler ◽  
Malcolm L.H. Green

Sign in / Sign up

Export Citation Format

Share Document