scholarly journals Affinity analysis using apriori algorithm to identify failure dependence in multi-component systems

2021 ◽  
Author(s):  
R.S Lopes ◽  
P Do ◽  
C.A.V Cavalcante ◽  
B Jung
Keyword(s):  
Apriori Algorithm ◽  
Component Systems ◽  
Failure Dependence

Role of boundaries in the crystallization of amorphous films

1988 ◽  
Vol 46 ◽  
pp. 626-627
Author(s):  
D. A. Smith
Keyword(s):  
Low Temperature ◽  
Amorphous State ◽  
Nucleation And Growth ◽  
Amorphous Films ◽  
Island Nucleation ◽  
Surface Steps ◽  
Transmission Electron ◽  
Component Systems ◽  
Temperature Deposition

The nucleation and growth processes which lead to the formation of a thin film are particularly amenable to investigation by transmission electron microscopy either in situ or subsequent to deposition. In situ studies have enabled the observation of island nucleation and growth, together with addition of atoms to surface steps. This paper is concerned with post-deposition crystallization of amorphous alloys. It will be argued that the processes occurring during low temperature deposition of one component systems are related but the evidence is mainly indirect. Amorphous films result when the deposition conditions such as low temperature or the presence of impurities (intentional or unintentional) preclude the atomic mobility necessary for crystallization. Representative examples of this behavior are CVD silicon grown below about 670°C, metalloids, such as antimony deposited at room temperature, binary alloys or compounds such as Cu-Ag or Cr O2, respectively. Elemental metals are not stable in the amorphous state.

Automatic Tread Gaging Machine

1979 ◽  
Vol 7 (1) ◽  
pp. 31-39
Author(s):  
G. S. Ludwig ◽  
F. C. Brenner
Keyword(s):  
Experimental Tests ◽  
Automatic Machine ◽  
Wear Rates ◽  
Handling Device ◽  
Straight Line ◽  
Component Systems ◽  
Before And After ◽  
Good Repeatability ◽  
The Difference ◽  
Straight Lines

Abstract An automatic tread gaging machine has been developed. It consists of three component systems: (1) a laser gaging head, (2) a tire handling device, and (3) a computer that controls the movement of the tire handling machine, processes the data, and computes the least-squares straight line from which a wear rate may be estimated. Experimental tests show that the machine has good repeatability. In comparisons with measurements obtained by a hand gage, the automatic machine gives smaller average groove depths. The difference before and after a period of wear for both methods of measurement are the same. Wear rates estimated from the slopes of straight lines fitted to both sets of data are not significantly different.

scholarly journals 9.1.2 Coupling component systems towards systems of systems

2008 ◽  
Vol 18 (1) ◽  
pp. 996-1010 ◽  
Author(s):  
Frédéric Autran ◽  
Jean-Philippe Auzelle ◽  
Denise Cattan ◽  
Jean-Luc Garnier ◽  
Dominique Luzeaux ◽  
...  
Keyword(s):  
Systems Of Systems ◽  
Component Systems
Sign in / Sign up

Export Citation Format

Share Document