Successful Unlock for Non-Continuous Sand of Tight Gas Reservoir using Horizontal Wells

2021 ◽  
Author(s):  
Raed Mohamed Elmohammady ◽  
Mostafa Mahrous Ali ◽  
Hassan Elsayed Salem

Abstract Reservoir development in Safa Formation requires a lot of vertical wells in order to exploit the gas reserve in the formation which means high cost is needed because the heterogeneity in the formation is noticed due to sandstone is pinched out in different locations of the reservoir. So, vertical well may be sweep from limited area of the reservoir that make safa formation has less priority for new activities. Form all of that the plan was drilling horizontal wells with long horizontal section to recover great volume of gas from reservoir. In addition to reduction in number of drilling vertical wells in the reservoir. In contrast, the major constrains is the small thickness of reservoir that make drilling horizontal section is very difficult. The main characteristics of safa formation is non continuous sandstone in the whole reservoir with great heterogeneity that not controlled by any points in the reservoir for the distribution of sandstone. In addition, there are a lot of locations in safa formation that include lean intervals which have kaolinite, elite that are not capable for produce from sand. In other hand, there is another constrains beside the discontinuity of sand production is the heterogeneity of permeability properties of reservoir that change in wide range across the reservoir with minimum range of 0.01 md and increase in some locations to reach 100 md. From all of the previous, it is a big challenge in drilling horizontal wells with long horizontal section in thin reservoir thickness in order to access the best reservoir permeability and optimize the number of drilling wells based on this concept. This paper will discuss case study of unlock and development long horizontal section in gas reservoir characterized by its tightness. The main goal of this horizontal well to recover ultimate gas reserve from safa formation by horizontal section reached to 2000 meter with a challenge because it is abnormal to drill this large horizontal section in western desert of Egypt in reservoir thickness range from 5 meter to 30 meter as prognosis from other offset wells in case of there is no pitchout of the sandstone. After Drilling of first horizontal well, the results were unexpected because the well penetrates a large horizontal section of sandstone in safa formation. This section reached to around 1750 meter with average reservoir permeability between 10 – 20 md and the reservoir porosity about 13% with good hydrocarbon saturation that changes along this section from 75% to 80%. So, this well put on production with very stable gas production rate 20 MMSCFD. In this paper will discuss in details the different challenge that faced to unlock this tight gas reservoir and will discuss the performance of horizontal well production. In this paper will discuss the first horizontal well in safa formation and the longest horizontal section in western desert of Egypt in tight gas formation that has a lot of challenges and risks are faced. After success the concept of horizontal well in heterogeneous reservoir, the next plan is the development of this reservoir using several horizontal wells to recover the ultimate recovery of gas from safa formation.

Lithosphere ◽  
2021 ◽  
Vol 2021 (Special 1) ◽  
Author(s):  
Yue Peng ◽  
Tao Li ◽  
Yuxue Zhang ◽  
Yongjie Han ◽  
Dan Wu ◽  
...  

Abstract Multifractured horizontal wells are widely used in the development of tight gas reservoirs to improve the gas production and the ultimate reservoir recovery. Based on the heterogeneity characteristics of the tight gas reservoir, the homogeneous scheme and four typical heterogeneous schemes were established to simulate the production of a multifractured horizontal well. The seepage characteristics and production performance of different schemes were compared and analyzed in detail by the analysis of streamline distribution, pressure distribution, and production data. In addition, the effects of reservoir permeability level, length of horizontal well, and fracture half-length on the gas reservoir recovery were discussed. Results show that the reservoir permeability of the unfractured areas, which are located at both ends of the multifractured horizontal well, determines the seepage ability of the reservoir matrix, showing a significant impact on the long-term gas production. High reservoir permeability level, long horizontal well length, and long fracture half-length can mitigate the negative influence of heterogeneity on the gas production. Our research can provide some guidance for the layout of multifractured horizontal wells and fracturing design in heterogeneous tight gas reservoirs.


2021 ◽  
Vol 11 (4) ◽  
pp. 1873-1883
Author(s):  
P. Q. Lian ◽  
C. Y. Ma ◽  
T. Z. Duan ◽  
H. W. Zhao

AbstractThe development of multistage fracturing technology in horizontal wells is a great impulsion to the successful development of unconventional resources. The hydraulic fractures distribute regularly along the horizontal wellbore, forming a seepage channel for fluids in tight gas reservoir and greatly improving the productivity of horizontal wells. Based on Green function and Neumann product principle, we establish a flow model of fractured horizontal well coupled with anisotropic tight gas reservoir under both unsteady state and pseudo-steady state and propose a method to solve this model. The calculation results show that flow rate of horizontal well under the early unsteady state is larger than that under the pseudo-steady state. There is no interference among fractures in the early unsteady state, and flow rate is in direct proportion to fracture numbers. Affected by frictional and acceleration pressure drop, flow rate of the end fractures is obviously larger than other fractures in pseudo-steady state. The permeabilities in different directions have great influence on well flow rate distribution. With the increasing Kx, the interference between the fractures is reduced, and the flow distribution is more balanced. When Ky becomes larger, the interference between fractures are stronger, and the “U” shape distribution of the wellbore flow is more significant.


2015 ◽  
Author(s):  
Xiangji Dou ◽  
Xinwei Liao ◽  
Huawei Zhao ◽  
Tianyi Zhao ◽  
Zhiming Chen ◽  
...  

2015 ◽  
Author(s):  
Jian Zhou ◽  
Yijin Zeng ◽  
Tingxue Jiang ◽  
Baoping Zhang ◽  
Xudong Zhang

Sign in / Sign up

Export Citation Format

Share Document