scholarly journals Effect of Geological Heterogeneity on the Production Performance of a Multifractured Horizontal Well in Tight Gas Reservoirs

Lithosphere ◽  
2021 ◽  
Vol 2021 (Special 1) ◽  
Author(s):  
Yue Peng ◽  
Tao Li ◽  
Yuxue Zhang ◽  
Yongjie Han ◽  
Dan Wu ◽  
...  
Keyword(s):  
Horizontal Well ◽  
Horizontal Wells ◽  
Gas Production ◽  
Production Performance ◽  
Tight Gas ◽  
Gas Reservoirs ◽  
Gas Reservoir ◽  
Tight Gas Reservoirs ◽  
Reservoir Permeability ◽  
Half Length

Abstract Multifractured horizontal wells are widely used in the development of tight gas reservoirs to improve the gas production and the ultimate reservoir recovery. Based on the heterogeneity characteristics of the tight gas reservoir, the homogeneous scheme and four typical heterogeneous schemes were established to simulate the production of a multifractured horizontal well. The seepage characteristics and production performance of different schemes were compared and analyzed in detail by the analysis of streamline distribution, pressure distribution, and production data. In addition, the effects of reservoir permeability level, length of horizontal well, and fracture half-length on the gas reservoir recovery were discussed. Results show that the reservoir permeability of the unfractured areas, which are located at both ends of the multifractured horizontal well, determines the seepage ability of the reservoir matrix, showing a significant impact on the long-term gas production. High reservoir permeability level, long horizontal well length, and long fracture half-length can mitigate the negative influence of heterogeneity on the gas production. Our research can provide some guidance for the layout of multifractured horizontal wells and fracturing design in heterogeneous tight gas reservoirs.

Liquid loading in wellbores and its effect on cleanup period and well productivity in tight gas sand reservoirs

2010 ◽  
Vol 50 (1) ◽  
pp. 559
Author(s):  
Hassan Bahrami ◽  
M Reza Rezaee ◽  
Vamegh Rasouli ◽  
Armin Hosseinian
Keyword(s):  
Numerical Simulation ◽  
Gas Production ◽  
Production Performance ◽  
Tight Gas ◽  
Gas Reservoirs ◽  
Liquid Loading ◽  
Performance Modelling ◽  
Well Productivity ◽  
Tight Gas Reservoirs ◽  
Tight Gas Reservoir

Tight gas reservoirs normally have production problems due to very low matrix permeability and significant damage during well drilling, completion, stimulation and production. Therefore they might not flow gas to surface at optimum rates without advanced production improvement techniques. After well stimulation and fracturing operations, invaded liquids such as filtrate will flow from the reservoir into the wellbore, as gas is produced during well cleanup. In addition, there might be production of condensate with gas. The produced liquids when loaded and re-circulated downhole in wellbores, can significantly reduce the gas production rate and well productivity in tight gas formations. This paper presents assessments of tight gas reservoir productivity issues related to liquid loading in wellbores using numerical simulation of multiphase flow in deviated and horizontal wells. A field example of production logging in a horizontal well is used to verify reliability of the numerical simulation model outputs. Well production performance modelling is also performed to quantitatively evaluate water loading in a typical tight gas well, and test the water unloading techniques that can improve the well productivity. The results indicate the effect of downhole liquid loading on well productivity in tight gas reservoirs. It also shows how well cleanup is sped up with the improved well productivity when downhole circulating liquids are lifted using the proposed methods.

Successful Unlock for Non-Continuous Sand of Tight Gas Reservoir using Horizontal Wells

2021 ◽  
Author(s):  
Raed Mohamed Elmohammady ◽  
Mostafa Mahrous Ali ◽  
Hassan Elsayed Salem
Keyword(s):  
Horizontal Well ◽  
Horizontal Wells ◽  
Western Desert ◽  
Tight Gas ◽  
Vertical Wells ◽  
Gas Reservoir ◽  
Horizontal Section ◽  
Reservoir Permeability ◽  
Wide Range ◽  
Tight Gas Reservoir

Abstract Reservoir development in Safa Formation requires a lot of vertical wells in order to exploit the gas reserve in the formation which means high cost is needed because the heterogeneity in the formation is noticed due to sandstone is pinched out in different locations of the reservoir. So, vertical well may be sweep from limited area of the reservoir that make safa formation has less priority for new activities. Form all of that the plan was drilling horizontal wells with long horizontal section to recover great volume of gas from reservoir. In addition to reduction in number of drilling vertical wells in the reservoir. In contrast, the major constrains is the small thickness of reservoir that make drilling horizontal section is very difficult. The main characteristics of safa formation is non continuous sandstone in the whole reservoir with great heterogeneity that not controlled by any points in the reservoir for the distribution of sandstone. In addition, there are a lot of locations in safa formation that include lean intervals which have kaolinite, elite that are not capable for produce from sand. In other hand, there is another constrains beside the discontinuity of sand production is the heterogeneity of permeability properties of reservoir that change in wide range across the reservoir with minimum range of 0.01 md and increase in some locations to reach 100 md. From all of the previous, it is a big challenge in drilling horizontal wells with long horizontal section in thin reservoir thickness in order to access the best reservoir permeability and optimize the number of drilling wells based on this concept. This paper will discuss case study of unlock and development long horizontal section in gas reservoir characterized by its tightness. The main goal of this horizontal well to recover ultimate gas reserve from safa formation by horizontal section reached to 2000 meter with a challenge because it is abnormal to drill this large horizontal section in western desert of Egypt in reservoir thickness range from 5 meter to 30 meter as prognosis from other offset wells in case of there is no pitchout of the sandstone. After Drilling of first horizontal well, the results were unexpected because the well penetrates a large horizontal section of sandstone in safa formation. This section reached to around 1750 meter with average reservoir permeability between 10 – 20 md and the reservoir porosity about 13% with good hydrocarbon saturation that changes along this section from 75% to 80%. So, this well put on production with very stable gas production rate 20 MMSCFD. In this paper will discuss in details the different challenge that faced to unlock this tight gas reservoir and will discuss the performance of horizontal well production. In this paper will discuss the first horizontal well in safa formation and the longest horizontal section in western desert of Egypt in tight gas formation that has a lot of challenges and risks are faced. After success the concept of horizontal well in heterogeneous reservoir, the next plan is the development of this reservoir using several horizontal wells to recover the ultimate recovery of gas from safa formation.

Study and Apply of Seepage Law on Multi-Stage Fractured Horizontal Wells in Tight Gas Reservoirs

2014 ◽  
Vol 1030-1032 ◽  
pp. 1394-1398
Author(s):  
Ping Wang ◽  
Zhao Hui Xia ◽  
Wei Ding ◽  
Chao Bin Zhao ◽  
Yun Peng Hu ◽  
...  
Keyword(s):  
Scientific Evidence ◽  
Horizontal Wells ◽  
Tight Gas ◽  
Gas Reservoirs ◽  
Gas Reservoir ◽  
Tight Gas Reservoirs ◽  
Multi Stage ◽  
Tight Gas Reservoir ◽  
Commercial Value ◽  
Fractured Horizontal Wells

Because the extremely low permeability for tight gas reservoirs, lead to the way to seepage and the shape of production curves different with the convention reservoirs; this will increase the difficulty to develop the tight gas reservoirs; on the other hand, the convention exploit cannot recover the tight gas with commercial value, with this problem, the main solution is the technology of multi-stage fractured horizontal wells, the fractured can provide the channel for gas to transport, the horizontal wells can increase the seepage area of tight gas, it’s the guarantee to get the commercial value. But, at present, the study on the tight was dependent on the method of convention gas reservoirs, the production curve get from this method also the same with the convention gas reservoirs, in order to close with the really exploitation of tight gas reservoirs and provide the more accurate scientific evidence, we must study based on the feature of tight gas reservoir, in this situation, we can get the suitable production curves for tight gas reservoirs. This paper based on the feature of tight gas reservoir, combine with the model of multi-stage fractured horizontal wells, and get the production equation of tight gas, combine with the yield of discard time, we can get the type curve, and then get the C level reserves of region.

The Adaptability Study for Developing Tight Gas Reservoirs Using Horizontal Wells

2013 ◽  
Vol 423-426 ◽  
pp. 614-617 ◽  
Author(s):  
Shu Qing Peng ◽  
Wan Chun Zhao
Keyword(s):  
Optimization Model ◽  
Horizontal Wells ◽  
Tight Gas ◽  
Gas Reservoirs ◽  
Gas Reservoir ◽  
Tight Gas Reservoirs ◽  
Tight Gas Reservoir ◽  
Development Effectiveness

In order to improve the development effectiveness of tight gas reservoirs, in this paper, the adaptability study of well type for developing tight gas reservoirs using horizontal wells was conducted in view of the characters of tight gas reservoir, and the well type optimization model for different reservoirs was proposed. The development effectiveness of the different well type for different reservoirs was put forward, and the adaptability of different well type for different reservoirs was obtained. The basic foundation and method of well type optimization for tight gas reservoirs was obtained.

scholarly journals Modified Horizontal Well Productivity Model for a Tight Gas Reservoir Subjected to Non-Uniform Damage and Turbulence

Energies ◽  
2021 ◽  
Vol 14 (24) ◽  
pp. 8334
Author(s):  
Samuel O. Osisanya ◽  
Ajayi Temitope Ayokunle ◽  
Bisweswar Ghosh ◽  
Abhijith Suboyin
Keyword(s):  
Flow Rate ◽  
Horizontal Well ◽  
Horizontal Wells ◽  
Total Production ◽  
Tight Gas ◽  
Gas Reservoirs ◽  
Well Productivity ◽  
Tight Gas Reservoirs ◽  
Skin Factor ◽  
Tight Gas Reservoir

Tight gas reservoirs are finding greater interest with the advancement of technology and realistic prediction of flow rate and pressure from such wells are critical in project economics. This paper presents a modified productivity equation for tight gas horizontal wells by modifying the mechanical skin factor to account for non-uniform formation damage along with the incorporation of turbulence effect in the near-wellbore region. Hawkin’s formula for calculating skin factor considers the radius of damage as a constant value, which is less accurate in low-permeability tight gas reservoirs. This paper uses a multi-segment horizontal well approach to develop the local skin factors and the equivalent skin factor by equating the total production from the entire horizontal well to the sum of the flow from individual segmented damaged zones along the well length. Conical and horn-shaped damaged profiles are used to develop the equivalent skin used in the horizontal well productivity equation. The productivity model is applied to a case study involving the development of a tight gas field with horizontal wells. The influence of the horizontal well length, damaged zone permeability, drainage area, reservoir thickness, and wellbore diameter on the calculated equivalent skin (of a non-uniform skin distribution) and the flow rate (with turbulence and no turbulence) are investigated. The results obtained from this investigation show significant potential to assist in making practical decisions on the favorable parameters for the success of the field development in terms of equivalent skin factor, flow rate, and inflow performance relationships (IPR).

scholarly journals Prediction of water breakthrough time in horizontal Wells in edge water condensate gas reservoirs

2020 ◽  
Vol 213 ◽  
pp. 02009
Author(s):  
Quan Hua Huang ◽  
Xing Yu Lin
Keyword(s):  
Horizontal Well ◽  
Negative Impact ◽  
Horizontal Wells ◽  
Breakthrough Time ◽  
Gas Reservoirs ◽  
Gas Reservoir ◽  
Water Breakthrough ◽  
Calculation Results ◽  
Seepage Model ◽  
Reasonable Prediction

Horizontal Wells are often used to develop condensate gas reservoirs. When there is edge water in the gas reservoir, it will have a negative impact on the production of natural gas. Therefore, reasonable prediction of its water breakthrough time is of great significance for the efficient development of condensate gas reservoirs.At present, the prediction model of water breakthrough time in horizontal Wells of condensate gas reservoir is not perfect, and there are mainly problems such as incomplete consideration of retrograde condensate pollution and inaccurate determination of horizontal well seepage model. Based on the ellipsoidal horizontal well seepage model, considering the advance of edge water to the bottom of the well and condensate oil to formation, the advance of edge water is divided into two processes. The time when the first water molecule reaches the bottom of the well when the edge water tongue enters is deduced, that is, the time of edge water breakthrough in condensate gas reservoir.The calculation results show that the relative error of water breakthrough time considering retrograde condensate pollution is less than that without consideration, with a higher accuracy. The example error is less than 2%, which can be effectively applied to the development of edge water gas reservoir.

Sign in / Sign up

Export Citation Format

Share Document