A new deterministic method for groundwater mapping using a digital elevation model

2013 ◽  
Vol 13 (4) ◽  
pp. 1146-1153 ◽  
Author(s):  
Tamás Ács ◽  
Zoltán Simonffy
Keyword(s):  
Digital Elevation Model ◽  
Groundwater Level ◽  
Ground Surface ◽  
Terrestrial Ecosystems ◽  
Groundwater Depth ◽  
Deterministic Method ◽  
Groundwater Levels ◽  
Geostatistical Methods ◽  
Digital Elevation ◽  
Elevation Model

Accurate knowledge of groundwater levels and flow conditions in the vicinity of groundwater-dependent terrestrial ecosystems (GWDTE-s) is required for identifying groundwater dependency and comparing the present situation with the optimal one, as part of the status assessment of groundwaters according to the EU Water Framework Directive. Geostatistical methods (like kriging or cokriging) may result in an unrealistic groundwater level map if only a few measured data are available. In this paper a new, grid-based, deterministic method (GSGW-model) is introduced. The aim of the model is to calculate groundwater depth within the required accuracy from sparse data of monitoring wells. The basic principle of the GSGW-model is that the groundwater table is a smoothed replica of the ground surface. Hence, changes in the groundwater level between two grid points are calculated as a function of the digital elevation model (DEM) and soil properties. The GSGW-model was tested in the Nyírség region (Hungary). Results were compared with those gained by ordinary kriging and cokriging. It has been concluded that kriging overestimates the groundwater level in the low part of the test area, where wetlands are located, while the maps produced by the GSGW-model are a better fit of the real variability, providing more reliable estimates of groundwater depth in GWDTE-s as well.

Transpiration of Acacia plantation under managed tropical peatland in Riau, Sumatra

2021 ◽  
Author(s):  
Yogi Suardiwerianto ◽  
Sofyan Kurnianto ◽  
Adibtya Asyhari ◽  
Tubagus Muhamad Risky ◽  
Muhammad Fikky Hidayat ◽  
...  
Keyword(s):  
Transpiration Rate ◽  
Groundwater Level ◽  
Large Scale ◽  
Hydrological Modeling ◽  
Ground Surface ◽  
Terrestrial Ecosystems ◽  
Ratio Method ◽  
Flow Measurements ◽  
Groundwater Levels ◽  
Relative Contribution

<p>Transpiration is a key process in the terrestrial ecosystems linking water, carbon, and energy exchanges between the vegetation and the atmosphere. However, the understanding of transpiration rate, its spatiotemporal dynamics, and the controlling factors in tropical peatlands are still constrained by limited measurements. This study aims to investigate the transpiration rates at the stand level of Acacia plantation under different groundwater levels. The measurements were performed at two large-scale lysimeter plots with groundwater level of 40 and 80 cm below the ground surface. The transpiration rate was quantified based on sap flow measurements from 16 trees with different diameters at breast height using heat ratio method. The initial results indicate that the transpiration rate was closely correlated to the meteorological parameters, including atmospheric vapor pressure deficit and solar radiation. The two plots with different groundwater level regimes exhibit the same diurnal pattern of transpiration rate yet shows differences in their magnitude. The findings from this study will improve the understanding about relative contribution of transpiration to the total water balance under different groundwater levels. Further, an ongoing measurement of above and below-ground biomass growth and hydrological modeling work will advance the knowledge on plant-water interaction from this ecosystem.</p>

Evaluation of NDWI and MNDWI for assessment of waterlogging by integrating digital elevation model and groundwater level

2014 ◽  
Vol 30 (6) ◽  
pp. 650-661 ◽  
Author(s):  
Kanwar Vivek Singh ◽  
Raj Setia ◽  
Shashikanta Sahoo ◽  
Avinash Prasad ◽  
Brijendra Pateriya
Keyword(s):  
Digital Elevation Model ◽  
Groundwater Level ◽  
Digital Elevation ◽  
Elevation Model

Evaluation of rainfall-induced large-scale landslide potential using Scoops3D

2020 ◽  
Author(s):  
Jie-Lun Chiang ◽  
Chia-Ming Kuo
Keyword(s):  
Digital Elevation Model ◽  
Groundwater Level ◽  
Large Scale ◽  
The United States ◽  
Equilibrium Analysis ◽  
Slope Aspect ◽  
Seismic Zone ◽  
Landslide Area ◽  
Digital Elevation ◽  
Elevation Model

<p>Taiwan is located in the Pacific volcanic seismic zone and frequently suffers from landslides and debris flow caused by typhoons. On average, there are four typhoons which may cause tremendous disasters such as massive landslides in Taiwan mainly from July to September every year. The aim of this study is to evaluate the development of large-scale landslide area under various cumulative rainfalls. The study area of this study is Liouquei, Kaohsiung in southern Taiwan. Firstly, the relationship of rainfall and groundwater level were built. The equation of change of groundwater level and rainfall is h=38.2R, R<sup>2</sup>=0.83. Then, 10m digital elevation model (10m-dem) was used to evaluate elevation, slope, aspect and etc. Finally, geology and 10m-dem were used to build Scoops3D model of Liouquei area.</p><p>Scoops3D, which is released by the United States geological survey (USGS), evaluates slope stability throughout a digital landscape represented by a digital elevation model (DEM). The program uses a three-dimensional (3D) method of columns limit-equilibrium analysis to assess the stability of many potential landslides (typically millions) within a user-defined size range. We simulated the potential landslide area under a cumulative rainfall in 24 hours from 800mm~1600mm. The results show that landslide area contributed 65%~76% of the entire potential large-scale landslide area.</p>

scholarly journals Experimental Analysis of Srtm Model by Image Processing and Geostatistical Methods

2018 ◽  
Vol 7 (4.7) ◽  
pp. 250 ◽  
Author(s):  
M. V. Kuzyakina ◽  
D. A. Gura ◽  
Yu. A. Mishchenko ◽  
D. A. Gordienko
Keyword(s):  
Image Processing ◽  
Digital Elevation Model ◽  
Experimental Analysis ◽  
Geostatistical Methods ◽  
Digital Elevation ◽  
Different Types ◽  
Elevation Model ◽  
Bicubic Interpolation

This article compares the image processing and geostatistical methods of GIS. They proposed the application of these methods to restore the quality of the well-known digital elevation model SRTM degraded sections using the example of the Krasnodar Territory. The conclusions are drawn also about the quality of modeling for test sites with different types of relief – flat, hilly and mountain. The best results were achieved for the method of bicubic interpolation. 

STUDY OF THE LANDSLIDE MORPHOLOGY BASED ON GNSS DATA AND AIRBORNE SOUNDING (ON THE EXAMPLE OF A SECTION OF THE PROTVA RIVER VALLEY)

2018 ◽  
Vol 12 (5-6) ◽  
pp. 50-57 ◽  
Author(s):  
I. S. Voskresensky ◽  
A. A. Suchilin ◽  
L. A. Ushakova ◽  
V. M. Shaforostov ◽  
A. L. Entin ◽  
...  
Keyword(s):  
Digital Elevation Model ◽  
Geodetic Network ◽  
Aerial Survey ◽  
River Valley ◽  
Ease Of Use ◽  
Digital Elevation ◽  
Loose Deposits ◽  
Positioning Method ◽  
Landslide Body ◽  
Elevation Model

To use unmanned aerial vehicles (UAVs) for obtaining digital elevation models (DEM) and digital terrain models (DTM) is currently actively practiced in scientific and practical purposes. This technology has many advantages: efficiency, ease of use, and the possibility of application on relatively small area. This allows us to perform qualitative and quantitative studies of the progress of dangerous relief-forming processes and to assess their consequences quickly. In this paper, we describe the process of obtaining a digital elevation model (DEM) of the relief of the slope located on the bank of the Protva River (Satino training site of the Faculty of Geography, Lomonosov Moscow State University). To obtain the digital elevation model, we created a temporary geodetic network. The coordinates of the points were measured by the satellite positioning method using a highprecision mobile complex. The aerial survey was carried out using an unmanned aerial vehicle from a low altitude (about 40–45 m). The processing of survey materials was performed via automatic photogrammetry (Structure-from-Motion method), and the digital elevation model of the landslide surface on the Protva River valley section was created. Remote sensing was supplemented by studying archival materials of aerial photography, as well as field survey conducted immediately after the landslide. The total amount of research results made it possible to establish the causes and character of the landslide process on the study site. According to the geomorphological conditions of formation, the landslide refers to a variety of landslideslides, which are formed when water is saturated with loose deposits. The landslide body was formed with the "collapse" of the blocks of turf and deluvial loams and their "destruction" as they shifted and accumulated at the foot of the slope.

Sign in / Sign up

Export Citation Format

Share Document