Measurement of Iron Content and Detection of Sulfate Ion in Traditional/ Industrial Canned Black Olives in Iran

2020 ◽  
Vol 16 (7) ◽  
pp. 1112-1118
Author(s):  
Tayebeh Asadi-Sharifi ◽  
Leila Peivasteh-Roudsari ◽  
Ebrahim Molaee-Aghaee ◽  
Shahrokh Nazmara ◽  
Parisa Sadighara ◽  
...  

Background: Black olive contains considerable concentrations of phenolic compounds, which can result in a higher antioxidant component compared with green olives. Sometimes, as food fraud, the use of unwanted substances has been observed such as iron sulfate or iron particles for blackening olives, eventually causing adverse effects on the tissues of the digestive tract, brain, kidney, and liver in the consumer. The main purpose of this study was to determine flavonoids, iron content and ion sulfate in canned black olives. Methods: Canned black olive from inland/imported and traditional/industrial samples were collected. The amount of iron, sulfate ion, and flavonoids content were measured by ICP-OES and spectrophotometer, respectively. Results: Industrial black olives (brand N) from Turkey showed the highest iron content (110.17 mg/kg) and traditional black olives purchased from Rudbar, showed the lowest iron content (6.72 mg/kg). These values were lower than the iron limit in canned black olives (150 mg/kg). The highest and lowest levels of sulfate were also found in the traditional black olive of Rudbar and industrial black olives of Greece, respectively. Sulfate amount was determined between 23.225-82.102 mg/kg. Traditional black olives of Roudbar had the highest flavonoid, and the lowest flavonoid content was shown by the industrial black olive of Turkey. The pH was in the range of 4.4-4.8, indicating that the pH of any of the samples was not higher than the standard maximum level. Conclusion: According to the results of this study, iron sulfate has not been added intentionally to the collected samples.

The natural remanent magnetization of rock fragments L2015,3,1 and L2015,3,11 was found to be < 3.5 x 10 -7 and < 40 x 10 -6 G cm 3 g -1 respectively. The former sample, from isothermal remanent magnetization (i.r.m.) measurements, contained very little iron, while the latter sample had a much higher iron content and exhibited i.r.m. characteristics similar to breccia samples from Apollo missions. Susceptibility and i.r.m. measurements have shown that Luna 16 fines contain about four times as much iron as Luna 20 samples and that the light fractions from the density separations contain about twice as much iron as the heavy fraction. Like the Apollo fines, the magnetic behaviour of Luna 16 and 20 fines is dominated by small iron particles, most of which are superparamagnetic and of grain size less than about 13 nm.


1998 ◽  
Vol 41 (2) ◽  
pp. 168-172 ◽  
Author(s):  
Kazuhisa MURATA ◽  
Hirobumi USHIJIMA ◽  
Kunio UCHIDA

Author(s):  
Alfred Baltz

As part of a program to develop iron particles for next generation recording disk medium, their structural properties were investigated using transmission electron microscopy and electron diffraction. Iron particles are a more desirable recording medium than iron oxide, the most widely used material in disk manufacturing, because they offer a higher magnetic output and a higher coercive force. The particles were prepared by a method described elsewhere. Because of their strong magnetic interaction, a method had to be developed to separate the particles on the electron microscope grids.


2001 ◽  
Vol 120 (5) ◽  
pp. A571-A571
Author(s):  
J SCHWARTZ ◽  
V FISHMAN ◽  
R THOMAS ◽  
J GAUGHN ◽  
K KOWDLEY ◽  
...  

2009 ◽  
Author(s):  
George Grote
Keyword(s):  

2009 ◽  
Author(s):  
George Grote
Keyword(s):  

2009 ◽  
Author(s):  
George Grote
Keyword(s):  

2009 ◽  
Author(s):  
George Grote
Keyword(s):  

Author(s):  
Connop Thirlwall
Keyword(s):  

2009 ◽  
Author(s):  
Connop Thirlwall
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document