scholarly journals EVALUATION OF DEVELOPMENT LENGTH BASED ON AN E-DEFENSE SHAKE TABLE EXPERMENT ON REINFORCED CONCRETE BRIDGE COLUMN WITH TERMINATION OF LONGITUDINAL BARS

2009 ◽  
Vol 65 (1) ◽  
pp. 434-441
Author(s):  
Tomohiro SASAKI ◽  
Kazuhiko KAWASHIMA
Keyword(s):  
Reinforced Concrete ◽  
Concrete Bridge ◽  
Shake Table ◽  
Development Length ◽  
Reinforced Concrete Bridge ◽  
Bridge Column

Failure Analysis of Reinforced Concrete Bridge Column Using Cohesive and Adhesive Interfaces

2006 ◽  
Vol 321-323 ◽  
pp. 716-719 ◽  
Author(s):  
In Kyu Rhee ◽  
Hee Up Lee ◽  
Jun S. Lee ◽  
Woo Kim
Keyword(s):  
Reinforced Concrete ◽  
Failure Analysis ◽  
Interfacial Crack ◽  
Concrete Columns ◽  
Crack Model ◽  
Concrete Bridge ◽  
Reinforced Concrete Columns ◽  
Reinforced Concrete Bridge ◽  
Bridge Column ◽  
The University

This study examines the performance of adhesive and cohesive interfacial crack model in assessing the brittle shear behavior of reinforced concrete bridge columns. The quarter-scale reinforced concrete columns tested at the University of California at San Diego by Xiao et al. (1993) to explore the ductility of reinforced concrete columns under cyclic loading. The three columns R-1, R-3 and R-5 with different transverse reinforcement are considered for finite element failure analysis.

Non-Linear Dynamic Analysis of a Reinforced Concrete Bridge Column under Vehicle Impact Loading

2015 ◽  
Vol 764-765 ◽  
pp. 1189-1193 ◽  
Author(s):  
Jae Ha Lee ◽  
Woo Seok Kim ◽  
Kyeong Jin Kim ◽  
Soo Bong Park
Keyword(s):  
Reinforced Concrete ◽  
Impact Analysis ◽  
Failure Modes ◽  
Concrete Bridge ◽  
Reinforced Concrete Bridge ◽  
Dynamic Movement ◽  
Vehicle Impact ◽  
Bridge Column ◽  
Fixed Condition ◽  
The Impact

3D nonlinear impact analysis of a reinforced concrete bridge column under truck impact loadings was performed in this study. Three different boundary conditions were considered in order to investigate the effect of superstructures for the integral column during the impact. A fixed condition at bottom and restrained in a loading direction at top (Model I) showed the largest damaged area and dominant failure mode of the column was shear. However, Model II (Model I with released at top) showed smaller damage and dominant failure modes were flexure rather than shear. In Model III, it was found that the superstructure intensifies the shear and flexural damages to the column due to the dynamic movement of the superstructures

Sign in / Sign up

Export Citation Format

Share Document