Introduction. The overwhelming majority of construction areas are characterized by difficult engineering and geological conditions, represented by the presence of weak soils at the base. There are construction sites on which a large thickness of fill soil is observed. In these conditions, designers apply: soil consolidation, soil reinforcement, significant deepening of the underground part of buildings, etc. This article presents the formulation and solution of the problems of interaction of reinforced concrete piles with weak soils, as well as the interaction of soil piles with bulk soils as part of a pile-slab foundation, which allow one to determine the reduced deformation modulus and the bedding value.
Materials and methods. To describe the change in shear stresses depending on depth, a law was adopted in the form τ(z)=τ0е–αz. The solution is presented by analytical and numerical methods. The results obtained were compared by the analytical solution of the problem with the results obtained in the PLAXIS 3D software package.
Results. Regularities of the distribution of the total load on the pile-slab foundation between the pile field and the grillage have been obtained. The analytical solutions in the article are supported by the graphical part, performed using the Mathcad program. Numerical simulation of the problem was carried out in the PLAXIS 3D software package. The dependence of the settlement on the load, calculated by analytical and numerical methods, is shown. An expression is obtained for defining the stresses in different sections of the pile shaft and under the grillage slab. The theoretical and practical aspects of the construction of crushed stone piles are considered. The theoretical substantiation of compaction of bulk soils with crushed stone piles using a special technology is given. A dependence is obtained for determining the reduced modulus of deformation for bulk soil mass reinforced with soil piles.
Conclusions. Comparative evaluation of the results of solutions obtained by analytical and numerical methods showed good convergence. The solutions obtained can be used to preliminary determination of the settlement of piles as part of a pile-slab foundation. Selection of the optimal ratio of the pile length and its diameter allows the most effective use of the bearing capacity of the pile. For bulk soils, reinforced with soil piles, it is possible to select the optimal reduced modulus of deformation by varying the pitch of the soil piles.
Stress-strein state of weak and filled soils reinforced with reinforced concrete and soil piles, respectively
