Seismological tomography as source of composition evaluation for lithosphere and uppermost mantle

The Ligurian Basin is located north-west of Corsica at the transition from the western Alpine orogen to the Apennine system. The Back-arc basin was generated by the southeast retreat of the Apennines-Calabrian subduction zone. The opening took place from late Oligocene to Miocene. While the extension led to extreme continental thinning little is known about the style of back-arc rifting. Today, seismicity indicates the closure of this back-arc basin. In the basin, earthquake clusters occur in the lower crust and uppermost mantle and are related to re-activated, inverted, normal faults created during rifting.To shed light on the present day crustal and lithospheric architecture of the Ligurian Basin, active seismic data have been recorded on short period ocean bottom seismometers in the framework of SPP2017 4D-MB, the German component of AlpArray. An amphibious refraction seismic profile was shot across the Ligurian Basin in an E-W direction from the Gulf of Lion to Corsica. The profile comprises 35 OBS and three land stations at Corsica to give a complete image of the continental thinning including the necking zone.The majority of the refraction seismic data show mantle phases with offsets up to 70 km. The arrivals of seismic phases were picked and used to generate a 2-D P-wave velocity model. The results show a crust-mantle boundary in the central basin at ~12 km depth below sea surface. The P-wave velocities in the crust reach 6.6 km/s at the base. The uppermost mantle shows velocities >7.8 km/s. The crust-mantle boundary becomes shallower from ~18 km to ~12 km depth within 30 km from Corsica towards the basin centre. The velocity model does not reveal an axial valley as expected for oceanic spreading. Further, it is difficult to interpret the seismic data whether the continental lithosphere was thinned until the mantle was exposed to the seafloor. However, an extremely thinned continental crust indicates a long lasting rifting process that possibly did not initiate oceanic spreading before the opening of the Ligurian Basin stopped. The distribution of earthquakes and their fault plane solutions, projected along our seismic velocity model, is in-line with the counter-clockwise opening of the Ligurian Basin.

Download Full-text

Estimates of Q in central Asia as a function of frequency and depth using the coda of locally recorded earthquakes

Bulletin of the Seismological Society of America ◽

10.1785/bssa0720010129 ◽

1982 ◽

Vol 72 (1) ◽

pp. 129-149

Author(s):

S. W. Roecker ◽

B. Tucker ◽

J. King ◽

D. Hatzfeld

Keyword(s):

Frequency Dependence ◽

Central Asia ◽

Wide Frequency Range ◽

S Wave ◽

Uppermost Mantle ◽

Regional Heterogeneity ◽

S Waves ◽

Tectonic Processes ◽

Hindu Kush ◽

Attenuation Mechanism

abstract Digital recordings of microearthquake codas from shallow and intermediate depth earthquakes in the Hindu Kush region of Afghanistan were used to determine the attenuation factors of the S-wave coda (Qc) and primary S waves (Qβ). An anomalously rapid decay of the coda shortly after the S-wave arrival, observed also in a study of coda in central Asia by Rautian and Khalturin (1978), seems to be due primarily to depth-dependent variations in Qc. In particular, we deduce the average Qc in the crust and uppermost mantle (<100-km depth) is approximately four times lower than the deeper mantle (<400-km depth) over a wide frequency range (0.4 to 24 Hz). Further, while Qc generally increases with frequency at any depth, the degree of frequency dependence of Qc depends on depth. Except at the highest frequency studied here (∼48 Hz), the magnitude of Qc at a particular frequency increases with depth while its frequency dependence decreases. For similar depths, determinations of Qβ and Qc agree, suggesting a common wave composition and attenuation mechanism for S waves and codas. Comparison of these determinations of Qc in Afghanistan with those in other parts of the world shows that the degree of frequency dependence of Qc correlates with the expected regional heterogeneity. Such a correlation supports the prejudice that Qc is primarily influenced by scattering and suggests that tectonic processes such as folding and faulting are instrumental in creating scattering environments.

Download Full-text

Reconnaissance seismic refraction-reflection surveys in northwestern New Mexico

Bulletin of the Seismological Society of America ◽

10.1785/bssa0740041263 ◽

1984 ◽

Vol 74 (4) ◽

pp. 1263-1274

Author(s):

Lawrence H. Jaksha ◽

David H. Evans

Keyword(s):

New Mexico ◽

Wave Velocity ◽

Lower Crust ◽

Seismic Waves ◽

Seismic Refraction ◽

Velocity Model ◽

P Wave ◽

Uppermost Mantle ◽

P Wave Velocity ◽

Crustal Thinning

Abstract A velocity model of the crust in northwestern New Mexico has been constructed from an interpretation of direct, refracted, and reflected seismic waves. The model suggests a sedimentary section about 3 km thick with an average P-wave velocity of 3.6 km/sec. The crystalline upper crust is 28 km thick and has a P-wave velocity of 6.1 km/sec. The lower crust below the Conrad discontinuity has an average P-wave velocity of about 7.0 km/sec and a thickness near 17 km. Some evidence suggests that velocity in both the upper and lower crust increases with depth. The P-wave velocity in the uppermost mantle is 7.95 ± 0.15 km/sec. The total crustal thickness near Farmington, New Mexico, is about 48 km (datum = 1.6 km above sea level), and there is evidence for crustal thinning to the southeast.

Download Full-text