Numerical Simulation of a Low Reynolds Number Airfoil

2013 ◽  
Vol 390 ◽  
pp. 141-146
Author(s):  
Yu Fu Wang ◽  
Guo Quan Tao ◽  
Ze Hai Wang ◽  
Zhe Wu

In this paper, a low Reynolds number airfoil (S1223) is the objective of the study. The Navier-Stokes equations were established to simulate the complex flow around a low Reynolds number airfoil, in which the turbulence model was used. The complex flow around the airfoil was simulated at 2x105 Reynolds number and its aerodynamic characteristics were analyzed. The relationship among lift coefficient, drag coefficient and angle of attack was studied.

1998 ◽  
Vol 120 (2) ◽  
pp. 257-262 ◽  
Author(s):  
Peter Gerlinger ◽  
Dieter Bru¨ggemann

A multigrid method for convergence acceleration is used for solving coupled fluid and turbulence transport equations. For turbulence closure a low-Reynolds-number q-ω turbulence model is employed, which requires very fine grids in the near wall regions. Due to the use of fine grids, convergence of most iterative solvers slows down, making the use of multigrid techniques especially attractive. However, special care has to be taken on the strong nonlinear turbulent source terms during restriction from fine to coarse grids. Due to the hyperbolic character of the governing equations in supersonic flows and the occurrence of shock waves, modifications to standard multigrid techniques are necessary. A simple and effective method is presented that enables the multigrid scheme to converge. A strong reduction in the required number of multigrid cycles and work units is achieved for different test cases, including a Mack 2 flow over a backward facing step.


2021 ◽  
Author(s):  
Shima Yazdani ◽  
Erfan Salimipour ◽  
Ayoob Salimipour

Abstract The present paper numerically investigates the performance of a Co-Flow Jet (CFJ) on the static and dynamic stall control of the NACA 0024 airfoil at Reynolds number 1.5 × 105. The two-dimensional Reynolds-averaged Navier-Stokes equations are solved using the SST k-ω turbulence model. The results show that the lift coefficients at the low angles of attack (up to α = 15̊) are significantly increased at Cµ = 0.06, however for the higher momentum coefficients, it is not seen an improvement in the aerodynamic characteristics. Also, the dynamic stall for a range of α between 0̊ and 20̊ at the mentioned Reynolds number and with the reduced frequency of 0.15 for two CFJ cases with Cµ = 0.05 and 0.07 are investigated. For the case with Cµ = 0.07, the lift coefficient curve did not present a noticeable stall feature compared to Cµ = 0.05. The effect of this active flow control by increasing the Reynolds numbers from 0.5 × 105 to 3 × 105 is also investigated. At all studied Reynolds numbers, the lift coefficient enhances as the momentum coefficient increases where its best performance is obtained at the angle of attack α = 15̊.


Author(s):  
Donghwi Lee ◽  
Taku Nonomura ◽  
Akira Oyama ◽  
Kozo Fujii

In this study, two-dimensional laminar simulation (2-D Lam), two-dimensional Reynolds Averaged Navier-Stokes simulation with the Spalart-Allmaras turbulence model (2-D RANS(SA)), and implicit three-dimensional large-eddy simulation (3-D LES) are performed for NACA0012, NACA0006, and Ishii airfoils at Rec = 3.0 × 104. The relation between a predictability of airfoil aerodynamic characteristics and a dependence of airfoil geometry shape of each numerical method is evaluated at the low Reynolds number. Although little discrepancy is observed for the lift coefficient predictability, significant differences are presented in terms of the separation and reattachment points predictability depending on the numerical methods. The 2-D Lam simulation can predict the lift coefficients as well as the separation and reattachment points qualitatively as similar to the 3-D LES results except for the high angle of attack which is accompanied by the massive separation. The 2-D RANS(SA), the weak nonlinearity and stall phenomena for the lift coefficients are observed. A good predictability of the separation point are shown, however, it cannot be estimated the reattachment points due to the trend to predict widely for the separation region. The predictabilities of each numerical method appear regardless of the airfoil shapes.


2007 ◽  
Vol 23 (4) ◽  
pp. 423-432 ◽  
Author(s):  
S.-H. Lee ◽  
Tzuyin Wu

AbstractIn this paper, the drag force on a sphere moving constantly along the centerline of a circular pipe filled with viscous fluid (the falling-sphere problem) under low Reynolds number condition is investigated via numerical calculation. The incompressible Navier-Stokes equations are formulated in a pseudocompressibility form. The numerical scheme makes use of finite-volume method and the numerical flux terms are evaluated using the Total-Variation Diminishing (TVD) strategy commonly applied to the compressible flow. Steady solution is obtained by marching (iterating) in time until the artificial time derivative of pressure term in the continuity equation drops to zero.In the calculation, six different Reynolds number (Re) ranging from 0.1 to 1 and seven different pipe-to-sphere diameter ratios (D/d) ranging from 5 to 40 are selected to study the pipe-wall effect. In each case, the drag force on the sphere is evaluated and the results are compared with the existing approximate theoretical values derived from correcting the Stokes' formula. Both results agree in trend, but with noticeable deviation in values, particularly for cases with large pipe-to-sphere diameter ratios. The deviation is due to the fact that theoretical values were based on the solution to the linearized Navier-Stokes equations (Stokes' creeping-flow equations), while the fully nonlinear form of the Navier-Stokes equations are adopted in the present calculations. Finally, a least-square regression technique is applied to collapse the calculated results into a single expression exhibiting the functional relationship between the drag force, Reynolds number (Re), and the pipe-to-sphere diameter ratio (D/d).


Sign in / Sign up

Export Citation Format

Share Document