Analysis on the Technical Solutions of the Heat Source of the Geothermal Heat Pump System

2014 ◽  
Vol 953-954 ◽  
pp. 650-654
Author(s):  
Chao Yi Tan ◽  
Hui Zhu ◽  
Hai Hua Hu ◽  
Meng Meng Wang ◽  
Han Qing Wang

Taking the geothermal heat pump system in the campus of Hunan University of Technology for example, three technical solutions of the heat source of the system were analyzed in terms of the condensing heat load, the annual unbalanced heat load and the energy efficiency ratio (EER) of the system. In addition, comparison was conducted among the solutions. The results indicate that the solution 3, which has a cold and hot water integrative unit and hot water unit connected in series, meanwhile has a cooling tower for auxiliary cooling, shows better performance among all the solutions. The analysis on the solution of heat source of geothermal heat pump system, which usually contains the analysis on the condensing heat load, annual unbalanced heat load and EER, is of great significance for the design and development of the geothermal heat pump system with lower coat and higher EER.

2020 ◽  
Vol 29 (1) ◽  
pp. 57-68
Author(s):  
Sergii V. Goshovskyi ◽  
Oleksii V. Zurian

The research is aimed to study the process of change in temperature mode dynamics for the Earth subsurface layer when heat is extracted with geothermal heat pump systems, reveal and disclose specifics of effect on the ecology caused by technologies using geothermal resources and give practical recommendations regarding further development of methods for designing heat pumps using low potential heat energy of soil based on the long-term forecast and efficacy assessment. Mathematical statistics and mathematical model methods were applied for assessment of economic and environmental effects. Methods based on principles of the theory of thermal conductivity, hydromechanics, theory of differential equations and mathematical analysis were applied for calculation of proposed systems and review of field observation findings. The authors had developed for research purposes an experimental geothermal heat pump system consisting of four structurally connected geothermal wells, each with installed U-shaped twin collectors of 200 m overall length, and a heat pump of 14 kW capacity with a heat energy battery for 300 L connected to the building heat-supply system. They also created a computer data archivation and visualisation system and devised a research procedure. The paper provides assessment of the effect caused by changes in the process operation mode of the heat pump system on the soil temperature near the geothermal well. As a result, the authors have found that the higher the intensity of heat energy extraction, the lower the soil temperature near the geothermal heat exchanger, in proportion to the load on the system. Moreover, it has been determined by experimental means that at critical loads on the geothermal heat exchanger the soil temperature is unable to keep up with regeneration and may reach negative values. The research also determined relation between inservice time and season of the system operation and temperature fluctuations of geothermal field. For example, it has been found by experimental means that the heat flow from the well is spread radially, from the well axis to its borders. Additionally, it has been proved that depending on the heat load value, the bed temperature is changed after the time of the first launch. For example, the geothermal field temperature has changed from the time of the first launch during 1-year operation by 0.5 °С in average. The research has proved that depending on the heat load value, under seasonal operation (heating only or cooling only) of the system, the soil temperature has decreased for five years by 2.5 °С and switched to quasi-steady state, meanwhile, stabilisation of the geothermal field in the state under 1-year operation (heating and cooling) occurred yet in the 2nd year of operation. In conclusion, the paper reasonably states that geothermal heat pump systems using vertical heat exchangers installed into the wells put no significant human-induced load on the environment. At the same time, still relevant are issues of scientific approach to development of the required configuration of the geothermal collector, methodology for its optimal placement and determination of efficacy depending on operation conditions.


Energies ◽  
2020 ◽  
Vol 13 (20) ◽  
pp. 5333
Author(s):  
Ji-Hyun Shin ◽  
Yoon-Bok Seong ◽  
Yong-In Kim ◽  
Young-Hum Cho

The installation and operation of geothermal systems increased due to the expectation of good cooling and heating performance due to stable heat source temperatures. In actual geothermal system operations, heat source temperature rises or falls due to an imbalance of heating and cooling energy usage. Problems of source side temperature result in reduced geothermal system performance. The purpose of this study is to develop hybrid geothermal system operation technology to stabilize temperature and improve system performance by utilizing auxiliary heat source system. The auxiliary heat source system is operated by comparing the performance when operating the geothermal heat pump system alone and the performance when operating the hybrid geothermal heat pump system. The performance of a hybrid geothermal system is determined by the circulating water temperature of the geothermal system and the circulating water temperature of the auxiliary heat source system. Hybrid geothermal heat pump system performance is predicted through numerical analysis and collection of hybrid geothermal system performance data at various temperature ranges through field test. An operating method was developed using the predicted performance as the changeover operating point of the hybrid geothermal heat pump system. When applying the development and operation technology, it handled about 11% more load than the existing geothermal system operation. The addition of an auxiliary heat source increases the initial investment cost compared to the existing geothermal system, but decreases energy consumption, confirming that the initial investment cost of 15.3 years is recovered.


2020 ◽  
Vol 133 ◽  
pp. 110282 ◽  
Author(s):  
Pooya Farzanehkhameneh ◽  
M. Soltani ◽  
Farshad Moradi Kashkooli ◽  
Masoud Ziabasharhagh

2005 ◽  
Vol 128 (1) ◽  
pp. 28-34 ◽  
Author(s):  
Onder Ozgener ◽  
Arif Hepbasli

The main objective in doing the present study is twofold, namely (i) to review briefly the utilization of geothermally heated greenhouses and geothermal heat pumps in Turkey, since the system studied utilizes both renewable energy resources and (ii) to present the Analytical Hierarchy Process (AHP) as a potential decision making method for use in a greenhouse integrated solar assisted geothermal heat pump system (GISAGHPS), which was installed in the Solar Energy Institute of Ege University, Izmir, Turkey. This investigation may also be regarded as the one of the limited studies on the application of the AHP method to GISAGHPs, as no studies on the GISAGHPS have appeared in the literature. In this context, an economic analysis is performed based on the life cycle costing technique first. The results are then evaluated by applying the AHP method to a study, which is a comparative study on the GISAGHPS and split system. The results indicated that the GISAGHPS is economically preferable to the conventional split heating/cooling system under Turkey’s conditions.


Energies ◽  
2020 ◽  
Vol 13 (18) ◽  
pp. 4850
Author(s):  
Hyeongjin Moon ◽  
Jae-Young Jeon ◽  
Yujin Nam

The building sector is an energy-consuming sector, and the development of zero-energy buildings (ZEBs) is necessary to address this. A ZEB’s active components include a system that utilizes renewable energy. There is a heat-pump system using geothermal energy. The system is available regardless of weather conditions and time, and it has attracted attention as a high-performance energy system due to its stability and efficiency. However, initial investment costs are higher than other renewable energy sources. To solve this problem, design optimization for the capacity of geothermal heat-pump systems should be performed. In this study, a capacity optimization design of a geothermal heat-pump system was carried out according to building load pattern, and emphasis was placed on cost aspects. Building load patterns were modeled into hospitals, schools, and apartments, and, as a result of optimization, the total cost over 20 years in all building load patterns was reduced.


Sign in / Sign up

Export Citation Format

Share Document