scholarly journals Proposal of High Gain, Reduced Stress with Low-Duty-Cycle Two-Input Boost Converter for Renewable Energy Systems

2016 ◽  
Vol 07 (04) ◽  
pp. 489-496 ◽  
Author(s):  
L. Chitra ◽  
M. Karpagam ◽  
K. Saranyadevi
Keyword(s):  
Renewable Energy ◽  
Duty Cycle ◽  
Energy Systems ◽  
High Gain ◽  
Boost Converter ◽  
Renewable Energy Systems ◽  
Low Duty Cycle

scholarly journals Multi-Input Boost Converter for Parallel Connected Renewable Energy Systems

2020 ◽  
Vol 18 ◽  
pp. 403-408
Author(s):  
R.H.M. Ali ◽  
◽  
K.A. Khan ◽  
M. Khalid ◽  
A.A. Khan ◽  
...  
Keyword(s):  
Renewable Energy ◽  
Energy Systems ◽  
Boost Converter ◽  
Renewable Energy Systems

scholarly journals Efficient Topology for DC-DC Boost Converter Based on Charge Pump Capacitor for Renewable Energy System

2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
Muhammad Zeeshan Malik ◽  
Vineet Tirth ◽  
Amjad Ali ◽  
Ajmal Farooq ◽  
Ali Algahtani ◽  
...  
Keyword(s):  
Renewable Energy ◽  
Rural Areas ◽  
Renewable Energy Sources ◽  
Charge Pump ◽  
Energy Systems ◽  
Energy System ◽  
Boost Converter ◽  
Photovoltaic System ◽  
Experimental Result ◽  
Renewable Energy Systems

In an attempt to meet the global demand, renewable energy systems (RES) have gained an interest in it due to the availability of the resources, especially solar photovoltaic system that has been an importance since many years because of per watt cost reduction, improvement in efficiency, and abundant availability. Photovoltaic system in remote and rural areas is very useful where a grid supply is unavailable. In this scenario, power electronic converters are an integral part of the renewable energy systems particularly for electronic devices which are operated from renewable energy sources and energy storage system (fuel cell and batteries). In this article, a new topology of charge pump capacitor (CPC) which is based on high voltage gain technique DC-DC boost converter (DCBC) with dynamic modeling is proposed. To testify the efficacy of the introduced topology, a prototype has been developed in a laboratory, where input was given 10VDC and 80VDC output voltage achieved at the load side. Furthermore, the experimental result shows that the voltage stress of MOSFET switches is very less in comparison with the conventional boost converter with the same parameters as the proposed converter.

A novel non-isolated high step-up DC–DC boost converter using single switch for renewable energy systems

2020 ◽  
Vol 102 (2) ◽  
pp. 811-829 ◽  
Author(s):  
M. Premkumar ◽  
C. Kumar ◽  
A. Anbarasan ◽  
R. Sowmya
Keyword(s):  
Renewable Energy ◽  
Energy Systems ◽  
Boost Converter ◽  
Renewable Energy Systems
Sign in / Sign up

Export Citation Format

Share Document