Permafrost monitoring by reprocessing and repeating historical geoelectrical measurements

Author(s):  
Christian Hauck ◽  
Christin Hilbich ◽  
Coline Mollaret ◽  
Cécile Pellet

<p>Geophysical methods and especially electrical techniques have been used for permafrost detection and monitoring since more than 50 years. In the beginning, the use of Vertical Electrical Soundings (VES) allowed the detection of ice-rich permafrost due to the clear contrast between the comparatively low-resistive active layer and the high-resistive permafrost layer below. Only after the development of 2-dimensional tomographic measurement and processing techniques (Electrical Resistivity Tomography, ERT), in the late 1990’s, electrical imaging was widely applied for a large range of different permafrost applications, including ice content quantification and permafrost monitoring over different spatial scales. Regarding ERT monitoring, the comparatively large efforts needed for continuous and long-term measurements implies that there are still only few continuous ERT monitoring installations in permafrost terrain worldwide. One of the exceptions is a network of six permafrost sites in the Swiss Alps that have been constantly monitored in the context of the Swiss Permafrost Monitoring Network (PERMOS) since 2005, enabling the analysis of the long-term change in the ground ice content and associated thawing and freezing processes (Mollaret et al. 2019).</p><p>On the contrary, a much larger number (estimated to be > 500) of permafrost sites exist worldwide, where singular ERT (or VES) measurements have been performed in the past - many of them published in the scientific literature. These data sets are neither included in a joint database nor have they been analysed in an integrated way. Within a newly GCOS Switzerland-funded project we address this important historical data source. Whereas singular ERT data from different permafrost occurrences are not easily comparable due to the local influence of the geologic material on the obtained electrical resistivities, their use as baseline for repeated measurements and subsequent processing and interpretation in a climatic context is highly promising and can be effectuated with low efforts.</p><p>In this presentation we will show evidence that singular ERT surveys in permafrost terrain can indeed be repeated and jointly processed after long time spans of up to 20 years, yielding a climate signal of permafrost change at various sites and on different landforms. Examples are given from various field sites in Europe and Antarctica, and the results are validated with borehole data, where available. We believe that a joint international data base of historical ERT surveys and their repetitions would add an important data source available for permafrost studies in the context of climate change.</p><p> </p><p>Mollaret, C., Hilbich, C., Pellet, C., Flores-Orozco, A., Delaloye, R. and Hauck, C. (2019): Mountain permafrost degradation documented through a network of permanent electrical resistivity tomography sites. The Cryosphere, 13 (10), 2557-2578.</p>

2017 ◽  
Vol 11 (6) ◽  
pp. 2957-2974 ◽  
Author(s):  
Benjamin Mewes ◽  
Christin Hilbich ◽  
Reynald Delaloye ◽  
Christian Hauck

Abstract. Geophysical methods are often used to characterize and monitor the subsurface composition of permafrost. The resolution capacity of standard methods, i.e. electrical resistivity tomography and refraction seismic tomography, depends not only on static parameters such as measurement geometry, but also on the temporal variability in the contrast of the geophysical target variables (electrical resistivity and P-wave velocity). Our study analyses the resolution capacity of electrical resistivity tomography and refraction seismic tomography for typical processes in the context of permafrost degradation using synthetic and field data sets of mountain permafrost terrain. In addition, we tested the resolution capacity of a petrophysically based quantitative combination of both methods, the so-called 4-phase model, and through this analysed the expected changes in water and ice content upon permafrost thaw. The results from the synthetic data experiments suggest a higher sensitivity regarding an increase in water content compared to a decrease in ice content. A potentially larger uncertainty originates from the individual geophysical methods than from the combined evaluation with the 4-phase model. In the latter, a loss of ground ice can be detected quite reliably, whereas artefacts occur in the case of increased horizontal or vertical water flow. Analysis of field data from a well-investigated rock glacier in the Swiss Alps successfully visualized the seasonal ice loss in summer and the complex spatially variable ice, water and air content changes in an interannual comparison.


2016 ◽  
Author(s):  
Benjamin Mewes ◽  
Christin Hilbich ◽  
Reynald Delaloye ◽  
Christian Hauck

Abstract. Geophysical methods are often used to characterise and monitor the subsurface composition of permafrost. The resolution capacity of standard methods, i.e. Electrical Resistivity Tomography and Refraction Seismic Tomography, depends hereby not only on static parameters such as measurement geometry, but also on the temporal variability in the contrast of the geophysical variables (electrical resistivity and P-wave velocity). Our study analyses the resolution capacity of Electrical Resistivity Tomography and Refraction Seismic Tomography for typical processes in the context of permafrost degradation using synthetic and field data sets of mountain permafrost terrain. In addition, we tested especially the resolution capacity of a petrophysically-based quantitative combination of both methods, the so-called 4-phase model, and by this analysed the expected changes in water and ice content upon permafrost thaw. The results from the synthetic data experiments suggest a higher sensitivity regarding increasing water content compared to decreased ice content, and potentially larger uncertainty for the individual geophysical methods than for the combined evaluation with the 4-phase model. In the latter, ground ice loss can be detected quite reliably, whereas artefacts occur in the case of increased horizontal or vertical water flow. Analysis of field data from a well-investigated rock glacier in the Swiss Alps successfully visualised the seasonal ice loss in summer, and the complex spatially variable ice-, water- and air content changes in an interannual comparison.


2018 ◽  
Author(s):  
Coline Mollaret ◽  
Christin Hilbich ◽  
Cécile Pellet ◽  
Adrian Flores-Orozco ◽  
Reynald Delaloye ◽  
...  

Abstract. Mountain permafrost is sensitive to climate change and is expected to gradually degrade in response to the ongoing atmospheric warming trend. Long-term monitoring the permafrost thermal state is a key task, but it is problematic where temperatures are close to 0 °C. The energy exchange is indeed often dominantly related to latent heat effects associated with phase change (ice/water), rather than ground warming or cooling. Consequently, it is difficult to detect significant spatio-temporal variations of ground properties (e.g. ice-water ratio) that occur during the freezing/thawing process with point scale temperature monitoring alone. Hence, electrical methods have become popular in permafrost investigations as the resistivities of ice and water differ by several orders of magnitude, theoretically allowing a clear distinction between frozen and unfrozen ground. In this study we present an assessment of mountain permafrost evolution using long-term electrical resistivity tomography monitoring (ERTM) from a network of permanent sites in the Central Alps. The time series consist of more than 1000 data sets from six sites, where resistivities have been measured on a regular basis for up to twenty years. We identify systematic sources of error and apply automatic filtering procedures during data processing. In order to constrain the interpretation of the results, we analyse inversion results and long-term resistivity changes in comparison with existing borehole temperature time series. Our results show that the resistivity data set provides the most valuable insights at the melting point. A prominent permafrost degradation trend is evident for the longest time series (19 years), but also detectable for shorter time series (about a decade) at most sites. In spite of the wide range of morphological, climatological and geological differences between the sites, the observed inter-annual resistivity changes and long-term tendencies are similar for all sites of the network.


2019 ◽  
Vol 13 (10) ◽  
pp. 2557-2578 ◽  
Author(s):  
Coline Mollaret ◽  
Christin Hilbich ◽  
Cécile Pellet ◽  
Adrian Flores-Orozco ◽  
Reynald Delaloye ◽  
...  

Abstract. Mountain permafrost is sensitive to climate change and is expected to gradually degrade in response to the ongoing atmospheric warming trend. Long-term monitoring of the permafrost thermal state is a key task, but problematic where temperatures are close to 0 ∘C because the energy exchange is then dominantly related to latent heat effects associated with phase change (ice–water), rather than ground warming or cooling. Consequently, it is difficult to detect significant spatio-temporal variations in ground properties (e.g. ice–water ratio) that occur during the freezing–thawing process with point scale temperature monitoring alone. Hence, electrical methods have become popular in permafrost investigations as the resistivities of ice and water differ by several orders of magnitude, theoretically allowing a clear distinction between frozen and unfrozen ground. In this study we present an assessment of mountain permafrost evolution using long-term electrical resistivity tomography monitoring (ERTM) from a network of permanent sites in the central Alps. The time series consist of more than 1000 datasets from six sites, where resistivities have been measured on a regular basis for up to 20 years. We identify systematic sources of error and apply automatic filtering procedures during data processing. In order to constrain the interpretation of the results, we analyse inversion results and long-term resistivity changes in comparison with existing borehole temperature time series. Our results show that the resistivity dataset provides valuable insights at the melting point, where temperature changes stagnate due to latent heat effects. The longest time series (19 years) demonstrates a prominent permafrost degradation trend, but degradation is also detectable in shorter time series (about a decade) at most sites. In spite of the wide range of morphological, climatological, and geological differences between the sites, the observed inter-annual resistivity changes and long-term tendencies are similar for all sites of the network.


2021 ◽  
Vol 11 (6) ◽  
pp. 2448
Author(s):  
Alex Sendrós ◽  
Aritz Urruela ◽  
Mahjoub Himi ◽  
Carlos Alonso ◽  
Raúl Lovera ◽  
...  

Water percolation through infiltration ponds is creating significant synergies for the broad adoption of water reuse as an additional non-conventional water supply. Despite the apparent simplicity of the soil aquifer treatment (SAT) approaches, the complexity of site-specific hydrogeological conditions and the processes occurring at various scales require an exhaustive understanding of the system’s response. The non-saturated zone and underlying aquifers cannot be considered as a black box, nor accept its characterization from few boreholes not well distributed over the area to be investigated. Electrical resistivity tomography (ERT) is a non-invasive technology, highly responsive to geological heterogeneities that has demonstrated useful to provide the detailed subsurface information required for groundwater modeling. The relationships between the electrical resistivity of the alluvial sediments and the bedrock and the difference in salinity of groundwater highlight the potential of geophysical methods over other more costly subsurface exploration techniques. The results of our research show that ERT coupled with implicit modeling tools provides information that can significantly help to identify aquifer geometry and characterize the saltwater intrusion of shallow alluvial aquifers. The proposed approaches could improve the reliability of groundwater models and the commitment of stakeholders to the benefits of SAT procedures.


2021 ◽  
Author(s):  
Riccardo Scandroglio ◽  
Till Rehm ◽  
Jonas K. Limbrock ◽  
Andreas Kemna ◽  
Markus Heinze ◽  
...  

<p>The warming of alpine bedrock permafrost in the last three decades and consequent reduction of frozen areas has been well documented. Its consequences like slope stability reduction put humans and infrastructures at high risk. 2020 in particular was the warmest year on record at 3000m a.s.l. embedded in the warmest decade.</p><p>Recently, the development of electrical resistivity tomography (ERT) as standard technique for quantitative permafrost investigation allows extended monitoring of this hazard even allowing including quantitative 4D monitoring strategies (Scandroglio et al., in review). Nevertheless thermo-hydro-mechanical dynamics of steep bedrock slopes cannot be totally explained by a single measurement technique and therefore multi-approach setups are necessary in the field to record external forcing and improve the deciphering of internal responses.</p><p>The Zugspitze Kammstollen is a 850m long tunnel located between 2660 and 2780m a.s.l., a few decameters under the mountain ridge. First ERT monitoring was conducted in 2007 (Krautblatter et al., 2010) and has been followed by more than one decade of intensive field work. This has led to the collection of a unique multi-approach data set of still unpublished data. Continuous logging of environmental parameters such as rock/air temperatures and water infiltration through joints as well as a dedicated thermal model (Schröder and Krautblatter, in review) provide important additional knowledge on bedrock internal dynamics. Summer ERT and seismic refraction tomography surveys with manual and automated joints’ displacement measurements on the ridge offer information on external controls, complemented by three weather stations and a 44m long borehole within 1km from the tunnel.</p><p>Year-round access to the area enables uninterrupted monitoring and maintenance of instruments for reliable data collection. “Precisely controlled natural conditions”, restricted access for researchers only and logistical support by Environmental Research Station Schneefernerhaus, make this tunnel particularly attractive for developing benchmark experiments. Some examples are the design of induced polarization monitoring, the analysis of tunnel spring water for isotopes investigation, and the multi-annual mass monitoring by means of relative gravimetry.</p><p>Here, we present the recently modernized layout of the outdoor laboratory with the latest monitoring results, opening a discussion on further possible approaches of this extensive multi-approach data set, aiming at understanding not only permafrost thermal evolution but also the connected thermo-hydro-mechanical processes.</p><p> </p><p> </p><p>Krautblatter, M. et al. (2010) ‘Temperature-calibrated imaging of seasonal changes in permafrost rock walls by quantitative electrical resistivity tomography (Zugspitze, German/Austrian Alps)’, Journal of Geophysical Research: Earth Surface, 115(2), pp. 1–15. doi: 10.1029/2008JF001209.</p><p>Scandroglio, R. et al. (in review) ‘4D-Quantification of alpine permafrost degradation in steep rock walls using a laboratory-calibrated ERT approach (in review)’, Near Surface Geophysics.</p><p>Schröder, T. and Krautblatter, M. (in review) ‘A high-resolution multi-phase thermo-geophysical model to verify long-term electrical resistivity tomography monitoring in alpine permafrost rock walls (Zugspitze, German/Austrian Alps) (submitted)’, Earth Surface Processes and Landforms.</p>


Sign in / Sign up

Export Citation Format

Share Document