Case Studies of Accidents Taking Place When Using Compliant Fuel in 2-Stroke Low Speed Diesel Engines, and How to Prevent These Mishaps

2021 ◽  
Vol 56 (3) ◽  
pp. 401-404
Author(s):  
Daiki Murayama
2020 ◽  
Vol 94 (1) ◽  
pp. 143-154
Author(s):  
Khudyakov S. A. ◽  
Ignatenko A.V.
Keyword(s):  

Fuel ◽  
2019 ◽  
Vol 258 ◽  
pp. 116133 ◽  
Author(s):  
Xinyi Zhou ◽  
Tie Li ◽  
Yijie Wei ◽  
Sichen Wu

MTZ worldwide ◽  
2002 ◽  
Vol 63 (4) ◽  
pp. 24-26
Author(s):  
Matthias Amoser
Keyword(s):  

Author(s):  
Yifan Men ◽  
Jason B. Martz ◽  
Eric Curtis ◽  
Guoming G. Zhu

Abstract Modern diesel engines are normally turbocharged in order to achieve desired fuel economy and meet emission requirements. The well-known “turbo-lag”, delayed engine torque response to driver’s demand, is the main disadvantage for turbocharged engines operated under transient conditions. In addition, at low engine speed, the peak engine output torque is heavily limited by the available turbine energy. As a result, turbocharged engines have degraded peak torque at low speed and slow transient responses in general. Various technologies (variable geometry turbine, electrically assisted turbocharger, hydraulically assisted turbocharger, etc.) have been developed to improve transient response and low-speed torque performance. This paper presents a numerical study of an electrically assisted boosting (eBoost) system for a turbocharged diesel engine through 1-D simulations. This study focuses on two main areas: the electrical compensation at steady-state and turbo-lag reduction under transient operation. It is shown that the eBoost system is capable of increasing engine fuel economy at mid-speed and greatly improving low-speed peak torque. In addition, the eBoost system improves engine transient performance by reducing response time up to 60%.


Author(s):  
Nagaraj Nayak ◽  
A. D. Dani ◽  
P. A. Lakshminarayanan ◽  
M. K. Gajendra Babu

Wear is a characteristic of the engine system and a wide variety of conditions causes wear and damage of engine parts. In the current work, wear of the engine components are classified on the basis of fretting and adhesive phenomenon. In this regard, we formalized the knowledge of wear of inlet valve and liner quantitatively on the basis of operational and design aspects. Since there are many design and operational variables, the most important variables are selected and tuned by adding new features to the empirical models. Therefore, in the present work case studies on critical engine parts like inlet valve and liner are made to improve the wear behavior of the special components.


Sign in / Sign up

Export Citation Format

Share Document