scholarly journals Modal Analysis of Directional Coupler and Its Equivalent Circuit

2019 ◽  
Vol 8 (4) ◽  
pp. 103-107
Author(s):  
M. Mohammadi
Keyword(s):  
Modal Analysis ◽  
Equivalent Circuit ◽  
Rectangular Waveguide ◽  
Directional Coupler ◽  
Equivalent Circuit Model ◽  
Circuit Model ◽  
Mode Matching ◽  
Ansoft Hfss ◽  
X Band ◽  
Matching Technique

A modal analysis for the directional coupler is presented in this paper. The analysis is based on the mode-matching technique. The theory is verified by Ansoft HFSS software at a directional coupler with standard X-band (WR 90) rectangular waveguide ports. Element values of equivalent circuit model are computed by using the S-parameters obtained from the presented method in this paper. In addition this paper has corrected two formulations used in two previous works which have been published.

Modal analysis based equivalent circuit model and its verification for a single cMUT cell

2017 ◽  
Vol 27 (3) ◽  
pp. 035001 ◽  
Author(s):  
S P Mao ◽  
X Rottenberg ◽  
V Rochus ◽  
P Czarnecki ◽  
P Helin ◽  
...  
Keyword(s):  
Modal Analysis ◽  
Equivalent Circuit ◽  
Equivalent Circuit Model ◽  
Circuit Model

scholarly journals Coaxially Fed Hexagonal Patch Antenna for C- and X-Band Applications with Reduced-Ground Plane

2019 ◽  
Vol 17 (2) ◽  
pp. 136-143 ◽  
Author(s):  
Abhishek Joshi ◽  
Rahul Singhal
Keyword(s):  
Equivalent Circuit ◽  
Patch Antenna ◽  
Ground Plane ◽  
Equivalent Circuit Model ◽  
Circuit Model ◽  
Impedance Bandwidth ◽  
X Band

The consequence of reduced ground plane in a coaxially-fed hexagonal antenna, on impedance and radiation is analyzed and presented here. Measured and simulated impedance results for a designed antenna are compared with the equivalent circuit model in this paper. The reduction in ground plane excited frequencies in upper C-band and lower X-band. The designed hexagonal antenna uses a substrate with a dimension of 32×33.5 mm2 along with a reduced ground plane of area, 10.44×24.44 mm2. The proposed antenna has a 285 MHz and 380 MHz impedance bandwidth in C-band and X-band respectively. The designed antenna with reduced ground plane works well for C-band and X-band applications.

An Equivalent Circuit Model for Vertical Comb Drive MEMS Optical Scanner Controlled by Pulse Width Modulation

2012 ◽  
Vol 132 (1) ◽  
pp. 1-9 ◽  
Author(s):  
Satoshi Maruyama ◽  
Muneki Nakada ◽  
Makoto Mita ◽  
Takuya Takahashi ◽  
Hiroyuki Fujita ◽  
...  
Keyword(s):  
Equivalent Circuit ◽  
Pulse Width ◽  
Pulse Width Modulation ◽  
Equivalent Circuit Model ◽  
Circuit Model ◽  
Comb Drive ◽  
Optical Scanner

scholarly journals A Novel, Improved Equivalent Circuit Model for Double-Sided Linear Induction Motor

Electronics ◽  
2021 ◽  
Vol 10 (14) ◽  
pp. 1644
Author(s):  
Qian Zhang ◽  
Huijuan Liu ◽  
Tengfei Song ◽  
Zhenyang Zhang
Keyword(s):  
Finite Element ◽  
Finite Element Model ◽  
Equivalent Circuit ◽  
Skin Effect ◽  
Equivalent Circuit Model ◽  
Element Model ◽  
Circuit Model ◽  
End Effects ◽  
3D Finite Element ◽  
Linear Induction

A novel, improved equivalent circuit model of double-sided linear induction motors (DLIMs) is proposed, which takes the skin effect and the nonzero leakage reactance of the secondary, longitudinal, and transverse end effects into consideration. Firstly, the traditional equivalent circuit with longitudinal and transverse end effects are briefly reviewed. Additionally, the correction coefficients for longitudinal and transverse end effects derived by one-dimensional analysis models are given. Secondly, correction factors for skin effect, which reflects the inhomogeneous air gap magnetic field vertically, and the secondary leakage reactance are derived by the quasi-two-dimensional analysis model. Then, the proposed equivalent circuit is presented, and the excitation reactance and secondary resistance are modified by the correction coefficients derived from the three analytical models. Finally, a three-dimensional (3D) finite element model is used to verify the proposed equivalent circuit model under varying air gap width and frequency, and the results are also compared with that of the traditional equivalent circuit models. The calculated thrust characteristics by the proposed equivalent circuit and 3D finite element model are experimentally validated under a constant voltage–frequency drive.

Mesh Dependency on a Partial Element Equivalent Circuit Model for an NI HTS Coil

2021 ◽  
Vol 31 (5) ◽  
pp. 1-5
Author(s):  
Chaemin Im ◽  
Geonyoung Kim ◽  
Jeseok Bang ◽  
Kibum Choi ◽  
Soobin An ◽  
...  
Keyword(s):  
Equivalent Circuit ◽  
Equivalent Circuit Model ◽  
Circuit Model ◽  
Mesh Dependency ◽  
Partial Element Equivalent Circuit ◽  
Partial Element
Sign in / Sign up

Export Citation Format

Share Document