staebler wronski effect
Recently Published Documents


TOTAL DOCUMENTS

164
(FIVE YEARS 1)

H-INDEX

20
(FIVE YEARS 0)

Energies ◽  
2019 ◽  
Vol 12 (15) ◽  
pp. 2876
Author(s):  
Fabio Ricco Galluzzo ◽  
Cosimo Gerardi ◽  
Andrea Canino ◽  
Salvatore Lombardo

The Staebler-Wronski effect in amorphous silicon based photovoltaic devices is responsible for degradation of their power conversion efficiency, within approximately the first one thousand hours of light soaking. Several experimental studies led to highlight the performance instability phenomena for the mentioned devices, underling that recovery and improvement of such performance are observable, by subjecting such devices (both of single-junction and tandem types) to DC reverse bias stresses under illumination, or to operation in the Maximum Power Point (MPP) under variable conditions of temperature and illumination. In this work, we present and discuss the results of novel recent outdoor tests on stabilized specimens (i.e., exposed to 1000 h extended light soaking, before our tests) of tandem amorphous/microcrystalline Si (a-Si/µc-Si) photovoltaic (PV) minimodules operating in their MPP, by analyzing the causes of the performance instability effects, systematically observed on a daily scale. During the mentioned tests, we have monitored the solar cell operating temperature and the incident solar spectrum at various times in different days to verify the effect of cell temperature and solar spectrum changes on the cell performances. The experimental results show a clear correlation between performance improvements of the photovoltaic modules and their thermal history during the outdoor tests, proving the interplay between defect build-up at a lower temperature and defect annealing at a higher temperature, taking place in the solar cells operated in MPP during conventional outdoor operation.


2013 ◽  
Vol 750-752 ◽  
pp. 970-973
Author(s):  
Chun Rong Xue ◽  
Xia Yun Sun

High-efficiency solar cells based on amorphous silicon technology are designed. Multi-junction amorphous silicon solar cells are discussed, how these are made and how their performance can be understood and optimized. Although significant amount of work has been carried out in the last twenty-five years, the Staebler-Wronski effect has limited the development of a-Si:H solar cells. As an alternative material, nc-Si:H has attracted remarkable attention. Taking advantage of a lower degradation in nc-Si:H than a-Si:H and a-SiGe:H alloys, the light induced degradation in triple junction structures has been minimized by designing a bottom-cell-limited current mismatching, and obtained a stable active-area cell efficiency. All this has been investigated in this paper.


2012 ◽  
Vol 1426 ◽  
pp. 57-62
Author(s):  
Ka-Hyun Kim ◽  
Erik V. Johnson ◽  
Samir Kasouit ◽  
Pere Roca i Cabarrocas

ABSTRACTHydrogenated polymorphous silicon (pm-Si:H) is one of the most promising candidates for a stable top cell material in multi-junction thin film solar cells. Solar cells using pm-Si:H as their absorbing layer show very interesting degradation kinetics when compared to hydrogenated amorphous silicon (a-Si:H), summarized by macroscopic structural changes and irreversible changes in solar cell characteristics, while nevertheless preserving a higher stabilized efficiency. Notably, pm-Si:H solar cells, once degraded, respond to neither annealing nor further light-soaking. Such results suggest a device degradation mechanism including structural changes, active hydrogen motion, and interface delamination mediated by fast hydrogen diffusion and accumulation at the interface. Interestingly, a similar behavior was reported for a-Si:H solar cells under severe light soaking conditions (at 350 °C or under 50 suns) while pm-Si:H solar cells show such behavior under 1 sun at 40 °C.


2010 ◽  
Vol 1245 ◽  
Author(s):  
Arno H.M. Smets ◽  
Chris R. Wronski ◽  
Miro Zeman ◽  
M. van de Sanden

AbstractIn the recent years more and more theoretical and experimental evidence have been found that the hydrogen bonded to silicon in dense hydrogenated amorphous silicon (a-Si:H) predominantly resides in hydrogenated divacancies. In this contribution we will philosophize about the option that the small fraction of divacancies, missing at least one of its bonded hydrogen, may correspond to some of the native and metastable defect states of a-Si:H. We will discuss that such defect entities are an interesting basis for new and alternative views on the origin of the SWE.


Sign in / Sign up

Export Citation Format

Share Document