fixed-point representation

Author(s):  
Martin H. Weik
2015 ◽  
Vol 32 (04) ◽  
pp. 1550023 ◽  
Author(s):  
Lu Liu ◽  
Di-Rong Chen

In this paper, we consider the problem of finding the sparsest solution to underdetermined linear systems. Unlike the literatures which use the ℓ1 regularization to approximate the original problem, we consider the ℓ2/3 regularization which leads to a better approximation but a nonconvex, nonsmooth, and non-Lipschitz optimization problem. Through developing a fixed point representation theory associated with the two thirds thresholding operator for ℓ2/3 regularization solutions, we propose a fixed point iterative thresholding algorithm based on two thirds norm for solving the k-sparsity problems. Relying on the restricted isometry property, we provide subsequentional convergence guarantee for this fixed point iterative thresholding algorithm on recovering a sparse signal. By discussing the preferred regularization parameters and studying the phase diagram, we get an adequate and efficient algorithm for the high-dimensional sparse signal recovery. Finally, comparing with the existing algorithms, such as the standard ℓ1 minimization, the iterative reweighted ℓ2 minimization, the iterative reweighted ℓ1 minimization, and iterative Half thresholding algorithm, we display the results of the experiment which indicate that the two thirds norm fixed point iterative thresholding algorithm applied to sparse signal recovery and large scale imageries from noisy measurements can be accepted as an effective solver for ℓ2/3 regularization.


MATEMATIKA ◽  
2017 ◽  
Vol 33 (1) ◽  
pp. 55
Author(s):  
Jalaluddin Morris Abdullah

From a linear program and its asymmetric dual, invariant primal and dual problems are constructed. Regular mappings are defined between the solution spaces of the original and invariant problems. The notion of centrality is introduced and subsets of regular mappings are shown to be inversely related surjections of central elements, thus representing the original problems as invariant problems. A fixed-point problem involving an idempotent symmetric matrix is constructed from the invariant problems and the notion of centrality carried over to it; the non-negative central fixed-points are shown to map one-to-one to the central solutions to the invariant problems, thus representing the invariant problems as a fixed-point problem and, by transitivity, the original problems as a fixed-point problem.


2018 ◽  
Vol 22 (2) ◽  
pp. 649-660 ◽  
Author(s):  
Je Sen Teh ◽  
Kaijun Tan ◽  
Moatsum Alawida

Author(s):  
Luiz W. P. Biscainho ◽  
Paulo S. R. Diniz ◽  
Mauro F. de Carvalho

This paper addresses the effects of the quantization of an audio signal on the Least-Squares (LS) estimate of its autoregressive (AR) model. First, three topics are reviewed: the statistical description of the quantization error in terms of the number of bits used in fixed-point representation for a signal; the LS estimation of the AR model for a signal; and the relation between Minimum Mean-Square Error (MMSE) solutions for the AR model obtained from noisy and noiseless signals. The sensitivity of the associated generator filter poles localization (expressed by magnitudes and phases) to the deviation of the model parameters is examined. Through the interconnection of these aspects, the deviation of the model coefficients is described in terms of the number of bits used to represent the signal to be modeled, which allows for model correction. Conclusions about peculiarities of the pole deviation of the generator filter are drawn.


ACTA IMEKO ◽  
2015 ◽  
Vol 4 (3) ◽  
pp. 53
Author(s):  
Alberto Oliveri ◽  
Mark Butcher ◽  
Alessandro Masi ◽  
Marco Storace

<p>In this paper a piecewise affine virtual sensor is used for the estimation of the motor-side current of hybrid stepper motors, which actuate the LHC (Large Hadron Collider) collimators at CERN. The estimation is performed starting from measurements of the current in the driver, which is connected to the motor by a long cable (up to 720 m). The measured current is therefore affected by noise and ringing phenomena. The proposed method does not require a model of the cable, since it is only based on measured data and can be used with cables of different length. A circuit architecture suitable for FPGA implementation has been designed and the effects of fixed point representation of data are analyzed.</p>


Sign in / Sign up

Export Citation Format

Share Document