Improvement of Residential Buildings Walls Operation Thermal Mode

Author(s):  
Alla Kariuk ◽  
Victoria Rubel ◽  
Victor Pashynskyi ◽  
Stanislav Dzhyrma
Author(s):  
Domenico Prisinzano ◽  
Alessandro Federici ◽  
Amalia Martelli ◽  
Chiara Martini ◽  
Roberto Moneta

2019 ◽  
pp. 27-33
Author(s):  
Aleksei K. Solovyov ◽  
Bi Guofu

The term “window” in architecture usually stands for an opening in a wall or roof for penetration of natural light, sunrays and fresh air in premises. Recently, the requirement of contact with environment is added to this condition. It is especially relevant for residential buildings where rooms are considered residential if they have windows. The energy consumption of a building depends on sizes, form and location of windows. In winter, windows cause huge heat losses, in summer, on the other hand, large heat enters a building via the windows and is required to be removed by means of air conditioning. Moreover, windows are used for penetration of natural light in premises, which assists in saving of large amounts of power for artificial illumination. This article discusses partial solving the problem of the energy efficiency of residential buildings by determining the most efficient area of windows in terms of energy spending for compensation of heat losses via windows in winter, elimination of heat penetration through them in summer and energy losses for artificial lighting throughout the year. The analysis of the results of calculation of power consumption for residential premises in conditions of monsoon climate of the Russian Far East and Northern areas of China (PRC) is provided.


2018 ◽  
pp. 155-162 ◽  
Author(s):  
Sergei S. Kapitonov ◽  
Anastasia V. Kapitonova ◽  
Sergei Yu. Grigorovich ◽  
Sergei A. Medvedev ◽  
Taher Sobhy

In the article, the electrical and thermal processes in the LED lamp with varied parameters are investigated. Voltage and current measurements on all LEDs of the luminaire are carried out in the nominal operating mode. The power allocated to each LED is determined. The calculation of the LED crystal temperature was carried out using the developed thermal LED model based on the results of the measurements and by using “Multisim” program. It has been established that the temperature of the crystals of individual LEDs in the luminaire differ significantly, which leads to unfavourable thermal conditions for them and an increased likelihood of premature failure.


Sign in / Sign up

Export Citation Format

Share Document