scholarly journals Analytic Solutions for the Two-phase Navier-Stokes Equations with Surface Tension and Gravity

2011 ◽  
pp. 507-540 ◽  
Author(s):  
Jan Prüss ◽  
Gieri Simonett
Keyword(s):  
Surface Tension ◽  
Stokes Equations ◽  
Analytic Solutions ◽  
Navier Stokes ◽  
Two Phase ◽  
Navier Stokes Equations

scholarly journals Time-Decay Estimates for Linearized Two-Phase Navier–Stokes Equations with Surface Tension and Gravity

Mathematics ◽  
2021 ◽  
Vol 9 (7) ◽  
pp. 761
Author(s):  
Hirokazu Saito
Keyword(s):  
Surface Tension ◽  
Stokes Equations ◽  
Navier Stokes ◽  
Dimensional Euclidean Space ◽  
Decay Estimates ◽  
Time Decay ◽  
Two Phase ◽  
Navier Stokes Equations ◽  
Linearized Equations ◽  
Estimates Of Solutions

The aim of this paper is to show time-decay estimates of solutions to linearized two-phase Navier-Stokes equations with surface tension and gravity. The original two-phase Navier-Stokes equations describe the two-phase incompressible viscous flow with a sharp interface that is close to the hyperplane xN=0 in the N-dimensional Euclidean space, N≥2. It is well-known that the Rayleigh–Taylor instability occurs when the upper fluid is heavier than the lower one, while this paper assumes that the lower fluid is heavier than the upper one and proves time-decay estimates of Lp-Lq type for the linearized equations. Our approach is based on solution formulas for a resolvent problem associated with the linearized equations.

Numerical Modeling of Evolution of Boundary Between Incompressible Gas and Liquid in Two-Dimensional Region

2006 ◽  
Vol 4 ◽  
pp. 224-236
Author(s):  
A.S. Topolnikov
Keyword(s):  
Numerical Modeling ◽  
Interphase Boundary ◽  
Incompressible Liquid ◽  
Stokes Equations ◽  
Numerical Code ◽  
Navier Stokes ◽  
Two Phase ◽  
Navier Stokes Equations ◽  
Incompressible Media ◽  
Good Agreement

The paper is devoted to numerical modeling of Navier–Stokes equations for incompressible media in the case, when there exist gas and liquid inside the rectangular calculation region, which are separated by interphase boundary. The set of equations for incompressible liquid accounting for viscous, gravitational and surface (capillary) forces is solved by finite-difference scheme on the spaced grid, for description of interphase boundary the ideology of Level Set Method is used. By developed numerical code the set of hydrodynamic problems is solved, which describe the motion of two-phase incompressible media with interphase boundary. As a result of numerical simulation the solutions are obtained, which are in good agreement with existing analytical and experimental solutions.

NUMERICAL SIMULATION OF ISOTHERMAL AND THERMAL TWO-PHASE FLOWS USING PHASE-FIELD MODELING

2007 ◽  
Vol 18 (04) ◽  
pp. 536-545 ◽  
Author(s):  
NAOKI TAKADA ◽  
AKIO TOMIYAMA
Keyword(s):  
Phase Field ◽  
Stokes Equations ◽  
Density Ratio ◽  
Navier Stokes ◽  
Phase Field Modeling ◽  
Two Phase Flows ◽  
Two Phase ◽  
Navier Stokes Equations ◽  
Field Modeling ◽  
High Density Ratio

For interface-tracking simulation of two-phase flows in various micro-fluidics devices, we examined the applicability of two versions of computational fluid dynamics method, NS-PFM, combining Navier-Stokes equations with phase-field modeling for interface based on the van der Waals-Cahn-Hilliard free-energy theory. Through the numerical simulations, the following major findings were obtained: (1) The first version of NS-PFM gives good predictions of interfacial shapes and motions in an incompressible, isothermal two-phase fluid with high density ratio on solid surface with heterogeneous wettability. (2) The second version successfully captures liquid-vapor motions with heat and mass transfer across interfaces in phase change of a non-ideal fluid around the critical point.

scholarly journals Do the Volume-of-Fluid and the Two-Phase Euler Compete for Modeling a Spillway Aerator?

Water ◽  
2021 ◽  
Vol 13 (21) ◽  
pp. 3092
Author(s):  
Lourenço Sassetti Mendes ◽  
Javier L. Lara ◽  
Maria Teresa Viseu
Keyword(s):  
Stokes Equations ◽  
Cost Benefit ◽  
Volume Of Fluid ◽  
Navier Stokes ◽  
Type Model ◽  
Two Phase ◽  
Navier Stokes Equations ◽  
Entrained Air ◽  
Computational Resources ◽  
Mesh Convergence

Spillway design is key to the effective and safe operation of dams. Typically, the flow is characterized by high velocity, high levels of turbulence, and aeration. In the last two decades, advances in computational fluid dynamics (CFD) made available several numerical tools to aid hydraulic structures engineers. The most frequent approach is to solve the Reynolds-averaged Navier–Stokes equations using an Euler type model combined with the volume-of-fluid (VoF) method. Regardless of a few applications, the complete two-phase Euler is still considered to demand exorbitant computational resources. An assessment is performed in a spillway offset aerator, comparing the two-phase volume-of-fluid (TPVoF) with the complete two-phase Euler (CTPE). Both models are included in the OpenFOAM® toolbox. As expected, the TPVoF results depend highly on the mesh, not showing convergence in the maximum chute bottom pressure and the lower-nappe aeration, tending to null aeration as resolution increases. The CTPE combined with the k–ω SST Sato turbulence model exhibits the most accurate results and mesh convergence in the lower-nappe aeration. Surprisingly, intermediate mesh resolutions are sufficient to surpass the TPVoF performance with reasonable calculation efforts. Moreover, compressibility, flow bulking, and several entrained air effects in the flow are comprehended. Despite not reproducing all aspects of the flow with acceptable accuracy, the complete two-phase Euler demonstrated an efficient cost-benefit performance and high value in spillway aerated flows. Nonetheless, further developments are expected to enhance the efficiency and stability of this model.

Sign in / Sign up

Export Citation Format

Share Document