Tomographic Reconstruction and Efficient Rendering of Refractive Gas Flows

2009 ◽  
pp. 145-154 ◽  
Author(s):  
Ivo Ihrke ◽  
Kai Berger ◽  
Bradley Atcheson ◽  
Marcus Magnor ◽  
Wolfgang Heidrich
Keyword(s):  
Tomographic Reconstruction ◽  
Gas Flows

In Situ Observation of Catalyzed Gasification of Graphite by Nickel

1981 ◽  
Vol 39 ◽  
pp. 76-77
Author(s):  
R. T. K. Baker ◽  
R. D. Sherwood
Keyword(s):  
Objective Lens ◽  
In Situ Observation ◽  
Gas Flows ◽  
Catalytic Gasification ◽  
Television Camera ◽  
Viewing Screen ◽  
Fuels And Chemicals ◽  
Gasification Of Carbon ◽  
Transmission Microscope

The catalytic gasification of carbon at high temperature by microscopic size metal particles is of fundamental importance to removal of coke deposits and conversion of refractory hydrocarbons into fuels and chemicals. The reaction of metal/carbon/gas systems can be observed by controlled atmosphere electron microscopy (CAEM) in an 100 KV conventional transmission microscope. In the JEOL gas reaction stage model AGl (Fig. 1) the specimen is positioned over a hole, 200μm diameter, in a platinum heater strip, and is interposed between two apertures, 75μm diameter. The control gas flows across the specimen and exits through these apertures into the specimen chamber. The gas is further confined by two apertures, one in the condenser and one in the objective lens pole pieces, and removed by an auxiliary vacuum pump. The reaction zone is <1 mm thick and is maintained at gas pressure up to 400 Torr and temperature up to 1300<C as measured by a Pt-Pt/Rh 13% thermocouple. Reaction events are observed and recorded on videotape by using a Philips phosphor-television camera located below a hole in the center of the viewing screen. The overall resolution is greater than 2.5 nm.

Design and calibration of an IVEM for general 3-dimensional imaging of non-diffracting materials

1992 ◽  
Vol 50 (2) ◽  
pp. 1040-1041
Author(s):  
Neil Rowlands ◽  
Jeff Price ◽  
Michael Kersker ◽  
Seichi Suzuki ◽  
Steve Young ◽  
...  
Keyword(s):  
3D Imaging ◽  
Tomographic Reconstruction ◽  
Three Dimensional ◽  
3 Dimensional ◽  
3D Microstructure ◽  
Image Translation ◽  
Digital Correlation ◽  
On Line ◽  
Mechanical Stage ◽  
Projection Angle

Three-dimensional (3D) microstructure visualization on the electron microscope requires that the sample be tilted to different positions to collect a series of projections. This tilting should be performed rapidly for on-line stereo viewing and precisely for off-line tomographic reconstruction. Usually a projection series is collected using mechanical stage tilt alone. The stereo pairs must be viewed off-line and the 60 to 120 tomographic projections must be aligned with fiduciary markers or digital correlation methods. The delay in viewing stereo pairs and the alignment problems in tomographic reconstruction could be eliminated or improved by tilting the beam if such tilt could be accomplished without image translation.A microscope capable of beam tilt with simultaneous image shift to eliminate tilt-induced translation has been investigated for 3D imaging of thick (1 μm) biologic specimens. By tilting the beam above and through the specimen and bringing it back below the specimen, a brightfield image with a projection angle corresponding to the beam tilt angle can be recorded (Fig. 1a).

Methods for three-dimensional reconstruction of cellular components within a thick section

1986 ◽  
Vol 44 ◽  
pp. 18-21
Author(s):  
J. Frank ◽  
B. F. McEwen ◽  
M. Radermacher ◽  
C. L. Rieder
Keyword(s):  
Tilt Angle ◽  
Tomographic Reconstruction ◽  
3D Structure ◽  
Three Dimensional ◽  
Thick Section ◽  
Three Dimensional Reconstruction ◽  
Axis Ratio ◽  
Dimensional Reconstruction ◽  
Cellular Components

The tomographic reconstruction from multiple projections of cellular components, within a thick section, offers a way of visualizing and quantifying their three-dimensional (3D) structure. However, asymmetric objects require as many views from the widest tilt range as possible; otherwise the reconstruction may be uninterpretable. Even if not for geometric obstructions, the increasing pathway of electrons, as the tilt angle is increased, poses the ultimate upper limitation to the projection range. With the maximum tilt angle being fixed, the only way to improve the faithfulness of the reconstruction is by changing the mode of the tilting from single-axis to conical; a point within the object projected with a tilt angle of 60° and a full 360° azimuthal range is then reconstructed as a slightly elliptic (axis ratio 1.2 : 1) sphere.

Practical electron tomography

1995 ◽  
Vol 53 ◽  
pp. 742-743
Author(s):  
C.L. Woodcock
Keyword(s):  
Electron Tomography ◽  
Tomographic Reconstruction ◽  
Three Dimensional ◽  
3D Shape ◽  
Computational Resources ◽  
Shape Of Particles

Despite the potential of the technique, electron tomography has yet to be widely used by biologists. This is in part related to the rather daunting list of equipment and expertise that are required. Thanks to continuing advances in theory and instrumentation, tomography is now more feasible for the non-specialist. One barrier that has essentially disappeared is the expense of computational resources. In view of this progress, it is time to give more attention to practical issues that need to be considered when embarking on a tomographic project. The following recommendations and comments are derived from experience gained during two long-term collaborative projects.Tomographic reconstruction results in a three dimensional description of an individual EM specimen, most commonly a section, and is therefore applicable to problems in which ultrastructural details within the thickness of the specimen are obscured in single micrographs. Information that can be recovered using tomography includes the 3D shape of particles, and the arrangement and dispostion of overlapping fibrous and membranous structures.

TOMOGRAPHIC RECONSTRUCTION OF ASYMMETRIC SPRAYS FROM A TWIN-HOLE AIR SHROUD INJECTOR

1997 ◽  
Vol 7 (2) ◽  
pp. 183-197 ◽  
Author(s):  
Changhyuk Lee ◽  
Suk Ho Chung
Keyword(s):  
Tomographic Reconstruction
Sign in / Sign up

Export Citation Format

Share Document