ABSTRACTArc welding processes such Gas Tungsten (GTAW), Gas Metal (GMAW) and Submerged Arc (SAW) are typically used in order to produce a weld joint in stainless steels (SS). However, welding thermal cycle generates a sensitization by formation of chromium carbides. In addition, the heat affected zone (HAZ) is also susceptible to sensitization and fracture of the weldment. Weld bead geometric parameters such depth penetration, fusion zone (FZ) width and size of HAZ are mainly determined by welding operation parameters. This research work studies the influence of welding current, welding speed and arc gap on the width and grain size in the HAZ produced by a single pass of autogenous GTAW process applied to a plate butt-welded joint of AISI 304 SS. The welded specimens were prepared for analysis by light optical (LOM) and scanning electron (SEM) microscopies to identify the interfaces between FZ-HAZ and base material as well as the grain growth in the HAZ. Adams equation for 2-D heat distribution was used to estimate theoretically the width of the HAZ. Furthermore, computational simulation which solved a convective-diffusion problem of the volumetric heat applied during the weld pool formation allowed to correlate the thermal gradient and the molten material flow of the FZ with the welding depth penetration, and width and grain size in the HAZ. The results demonstrated that the high heat input generates an important grain growth in the HAZ caused by low heat diffusion in the adjacent material to the fusion line. Welding speed was the main factor in the thermal gradient changes. Simulation results indicate that outward recirculating flow in the molten metal produced by surface tension forces is responsible for the shallow penetration of the autogenous GTAW process. Theoretical and computational estimations of the HAZ are in good agreement with the experimental results.
Effect of the cooling rates on heat-affected zone of UNS S32304 duplex stainless steel welded by pulsed GTAW process