Entropy- and Boundary Layer Instability of Hypersonic Cone Flows-Effects of Mean Flow Variations

1995 ◽  
pp. 197-204 ◽  
Author(s):  
Ewald Kufner ◽  
Uwe Dallmann
Keyword(s):  
Boundary Layer ◽  
Mean Flow ◽  
Boundary Layer Instability

The three-dimensional nature of boundary-layer instability

1962 ◽  
Vol 12 (1) ◽  
pp. 1-34 ◽  
Author(s):  
P. S. Klebanoff ◽  
K. D. Tidstrom ◽  
L. M. Sargent
Keyword(s):  
Boundary Layer ◽  
Wave Motion ◽  
Three Dimensional ◽  
Mean Flow ◽  
Linear Effect ◽  
Non Linear Effect ◽  
Theoretical Approaches ◽  
Boundary Layer Instability ◽  
Non Linear ◽  
Dimensional Wave

An experimental investigation is described in which principal emphasis is given to revealing the nature of the motions in the non-linear range of boundary-layer instability and the onset of turbulence. It has as its central purpose the evaluation of existing theoretical considerations and the provision of a sound physical model which can be taken as a basis for a theoretical approach. The experimental method consisted of introducing, in a two-dimensional boundary layer on a flat plate at ‘incompressible’ speeds, three-dimensional disturbances under controlled conditions using the vibrating-ribbon technique, and studying their growth and evolution using hot-wire methods. It has been definitely established that longitudinal vortices are associated with the non-linear three-dimensional wave motions. Sufficient data were obtained for an evaluation of existing theoretical approaches. Those which have been considered are the generation of higher harmonics, the interaction of the mean flow and the Reynold stress, the concave streamline curvature associated with the wave motion, the vortex loop and the non-linear effect of a three-dimensional perturbation. It appears that except for the latter they do not adequately describe the observed phenomena. It is not that they are incorrect or may not play a role in some aspect of the local behaviour, but from the over-all point of view the results suggest that it is the non-linear effect of a three-dimensional perturbation which dominates the behaviour. A principal conclusion to be drawn is that a new perspective, one that takes three-dimensionality into account, is required in connexion with boundary-layer instability. It is demonstrated that the actual breakdown of the wave motion into turbulence is a consequence of a new instability which arises in the aforementioned three-dimensional wave motion. This instability involves the generation of ‘hairpin’ eddies and is remarkably similar in behaviour to ‘inflexional’ instability. It is also shown that the results obtained from the study of controlled disturbances are equally applicable to ‘natural’ transition.

scholarly journals Boundary layer instability over a rotating slender cone under non-axial inflow

2021 ◽  
Vol 910 ◽  
Author(s):  
Sumit Tambe ◽  
Ferry Schrijer ◽  
Arvind Gangoli Rao ◽  
Leo Veldhuis
Keyword(s):  
Boundary Layer ◽  
Boundary Layer Instability

Abstract

scholarly journals Energy dissipation caused by boundary layer instability at vanishing viscosity – ERRATUM

2018 ◽  
Vol 857 ◽  
pp. 952-952
Author(s):  
Natacha Nguyen van yen ◽  
Matthias Waidmann ◽  
Rupert Klein ◽  
Marie Farge ◽  
Kai Schneider
Keyword(s):  
Boundary Layer ◽  
Energy Dissipation ◽  
Vanishing Viscosity ◽  
Boundary Layer Instability

Acoustic receptivity and evolution of two-dimensional and oblique disturbances in a Blasius boundary layer

2001 ◽  
Vol 432 ◽  
pp. 69-90 ◽  
Author(s):  
RUDOLPH A. KING ◽  
KENNETH S. BREUER
Keyword(s):  
Boundary Layer ◽  
Surface Roughness ◽  
Acoustic Wave ◽  
Three Dimensional ◽  
Two Dimensional ◽  
Surface Waviness ◽  
S Wave ◽  
Boundary Layer Instability ◽  
Blasius Boundary Layer ◽  
Tollmien Schlichting

An experimental investigation was conducted to examine acoustic receptivity and subsequent boundary-layer instability evolution for a Blasius boundary layer formed on a flat plate in the presence of two-dimensional and oblique (three-dimensional) surface waviness. The effect of the non-localized surface roughness geometry and acoustic wave amplitude on the receptivity process was explored. The surface roughness had a well-defined wavenumber spectrum with fundamental wavenumber kw. A planar downstream-travelling acoustic wave was created to temporally excite the flow near the resonance frequency of an unstable eigenmode corresponding to kts = kw. The range of acoustic forcing levels, ε, and roughness heights, Δh, examined resulted in a linear dependence of receptivity coefficients; however, the larger values of the forcing combination εΔh resulted in subsequent nonlinear development of the Tollmien–Schlichting (T–S) wave. This study provides the first experimental evidence of a marked increase in the receptivity coefficient with increasing obliqueness of the surface waviness in excellent agreement with theory. Detuning of the two-dimensional and oblique disturbances was investigated by varying the streamwise wall-roughness wavenumber αw and measuring the T–S response. For the configuration where laminar-to-turbulent breakdown occurred, the breakdown process was found to be dominated by energy at the fundamental and harmonic frequencies, indicative of K-type breakdown.

Data Analysis Methods for Stereo PIV of a High Aspect Ratio Flexible Cylinder

2007 ◽  
Author(s):  
D. Furey ◽  
P. Atsavapranee ◽  
K. Cipolla
Keyword(s):  
Boundary Layer ◽  
Data Analysis ◽  
Aspect Ratio ◽  
High Aspect Ratio ◽  
Particle Image Velocimetry Data ◽  
Flow Fields ◽  
Mean Flow ◽  
Boundary Flow ◽  
The Mean ◽  
Cylinder Flow

Stereo Particle Image velocimetry data was collected over high aspect ratio flexible cylinders (L/a = 1.5 to 3 × 105) to evaluate the axial development of the turbulent boundary layer where the boundary layer thickness becomes significantly larger than the cylinder diameter (δ/a>>1). The flexible cylinders are approximately neutrally buoyant and have an initial length of 152 m and radii of 0.45 mm and 1.25 mm. The cylinders were towed at speeds ranging from 3.8 to 15.4 m/sec in the David Taylor Model Basin. The analysis of the SPIV data required a several step procedure to evaluate the cylinder boundary flow. First, the characterization of the flow field from the towing strut is required. This evaluation provides the residual mean velocities and turbulence levels caused by the towing hardware at each speed and axial location. These values, called tare values, are necessary for comparing to the cylinder flow results. Second, the cylinder flow fields are averaged together and the averaged tare fields are subtracted out to remove strut-induced ambient flow effects. Prior to averaging, the cylinder flow fields are shifted to collocate the cylinder within the field. Since the boundary layer develops slowly, all planes of data occurring within each 10 meter increment of the cylinder length are averaged together to produce the mean boundary layer flow. Corresponding fields from multiple runs executed using the same experimental parameters are also averaged. This flow is analyzed to evaluate the level of axisymmetry in the data and determine if small changes in cylinder angle affect the mean flow development. With axisymmetry verified, the boundary flow is further averaged azimuthally around the cylinder to produce mean boundary layer profiles. Finally, the fluctuating velocity levels are evaluated for the flow with the cylinder and compared to the fluctuating velocity levels in the tare data. This paper will first discuss the data analysis techniques for the tare data and the averaging methods implemented. Second, the data analysis considerations will be presented for the cylinder data and the averaging and cylinder tracking techniques. These results are used to extract relevant boundary layer parameters including δ, δ* and θ. Combining these results with wall shear and momentum thickness values extracted from averaged cylinder drag data, the boundary layer can be well characterized.

Experimental and Theoretical Investigation of the Supersonic Boundary Layer Stability on the Swept Wing

2008 ◽  
Vol 3 (3) ◽  
pp. 34-38
Author(s):  
Sergey A. Gaponov ◽  
Yuri G. Yermolaev ◽  
Aleksandr D. Kosinov ◽  
Nikolay V. Semionov ◽  
Boris V. Smorodsky
Keyword(s):  
Boundary Layer ◽  
Three Dimensional ◽  
Leading Edge ◽  
Supersonic Boundary Layer ◽  
Mean Flow ◽  
Swept Wing ◽  
Wing Model ◽  
Dimensional Boundary ◽  
The Stability ◽  
Good Agreement

Theoretical and an experimental research results of the disturbances development in a swept wing boundary layer are presented at Mach number М = 2. In experiments development of natural and small amplitude controllable disturbances downstream was studied. Experiments were carried out on a swept wing model with a lenticular profile at a zero attack angle. The swept angle of a leading edge was 40°. Wave parameters of moving disturbances were determined. In frames of the linear theory and an approach of the local self-similar mean flow the stability of a compressible three-dimensional boundary layer is studied. Good agreement of the theory with experimental results for transversal scales of unstable vertices of the secondary flow was obtained. However the calculated amplification rates differ from measured values considerably. This disagreement is explained by the nonlinear processes observed in experiment

Sign in / Sign up

Export Citation Format

Share Document