The Readiness Levels of Japan Supported Biomass Energy Conversion Technology Development Projects in Emerging Southeast Asia: Verification of the J-TRA Results

Author(s):  
Issui Ihara ◽  
Andante Hadi Pandyaswargo ◽  
Hiroshi Onoda
2016 ◽  
Vol 136 (10) ◽  
pp. 769-772 ◽  
Author(s):  
Toru Sasaki ◽  
Nobuhiro Harada ◽  
Takashi Kikuchi ◽  
Kazumasa Takahashi

2020 ◽  
Vol 9 (1) ◽  
pp. 22
Author(s):  
Sathiabama T. T. Thirugnana ◽  
Abu Bakar Jaafar ◽  
Takeshi Yasunaga ◽  
Tsutomu Nakaoka ◽  
Yasuyuki Ikegami ◽  
...  

The Malaysian Government has set a target of achieving 20% penetration of Renewable Energy (RE) in the energy mix spectrum by 2025. In order to get closer to the target, Ocean Thermal Energy Conversion (OTEC) aligned with solar PV, biogas and biomass energy sources must be evaluated and comprehended. Hybrid OTEC systems consisting of energy and water production are currently under research and validation. Therefore, for the construction of a commercial OTEC plant, 1 MW or 2.5 MW, the choice of a strategic location or potential site is vital. In this paper, oceanographic data such as seawater temperature, depth, salinity and dissolved oxygen obtained from the Japan Oceanographic Data Center (JODC) for Semporna, Tawau, Kudat, Pulau Layang-Layang and Pulau Kalumpang in Sabah, Malaysia, are reported. The RE available from the Exclusive Economic Zone (EEZ) on the coast of Sabah was estimated based on the JODC data obtained. There were no remarkable differences in temperatures between the five sites, which were reported as approximately 27 °C at the surface and 7 °C at depths below 600 m. The surface salinities below 100 m at those sites were slightly lower than the deeper waters, where the salinity increased up to approximately 34.5 PSU. Dissolved oxygen data from the Pulau Kalumpang site showed a slight increment to approximately 4.7 mL/L at depth intervals below 50 m, before declining steadily to approximately 1.7 mL/L along with the depth. The temperature-salinity profiles of the Malaysian sites were congruent with those of Palau, Kumejima and Okinawa, but not with that of Fiji, where the salinity profile showed a distinct variation at the relative depth (below 200 m). Estimates of RE using two different methods were used to prove the potential of OTEC in Malaysia.


2017 ◽  
Vol 114 ◽  
pp. 7107-7117 ◽  
Author(s):  
Nagasree Garapati ◽  
Benjamin M. Adams ◽  
Jeffrey M. Bielicki ◽  
Philipp Schaedle ◽  
Jimmy B. Randolph ◽  
...  

2018 ◽  
Vol 169 ◽  
pp. 281-291 ◽  
Author(s):  
Bijun Wu ◽  
Meng Li ◽  
Rukang Wu ◽  
Tianxiang Chen ◽  
Yunqiu Zhang ◽  
...  

1980 ◽  
Vol 11 (3) ◽  
pp. 85-93
Author(s):  
A. J.A. Sparrius

Technology-intensive innovation is fraught with all sorts of uncertainties - uncertainties which can neither be averted nor ignored but have to be managed. This paper discusses techniques on how to handle such uncertainties in high-technology development projects under conditions of severe time pressure. The key lies in postponing decision-making if uncertainty is intolerably high, and structuring the development project in such a manner that progress is not delayed, while taking steps to rapidly and systematically reduce the uncertainty. These techniques turn out to be simple but profound.Tegnologie-intensiewe innovasie word gekenmerk deur allerlei soorte onsekerhede - onsekerhede wat nog vermy nog verontagsaam kan word. Hierdie artikel bespreek tegnieke vir die hantering van sulke onsekerhede in hoe-tegnologie ontwikkelingsprojekte onder ernstige tydsdruk. Die sleutel le in die uitstel van besluitneming indien die onsekerhede ontoelaatbaar groot is, en in die strukturering van die ontwikkelingsprojek in so 'n wyse dat vordering nie belemmer word nie, terwyl stappe geneem word om die onsekerhede vinnig maar stelselmatig uit die weg te ruim. Hierdie tegnieke blyk eenvoudig dog diepgaande te wees.


Sign in / Sign up

Export Citation Format

Share Document