Gas formation from a solid fuel burning in a fluidized bed

1988 ◽  
Vol 54 (3) ◽  
pp. 296-300 ◽  
Author(s):  
V. A. Munts ◽  
A. P. Baskakov ◽  
A. A. Ashikhmin
Keyword(s):  
Fluidized Bed ◽  
Solid Fuel ◽  
Gas Formation ◽  
Fuel Burning

Modeling of Solid Fuel Combustion in Furnaces with a Circulating Fluidized Bed

2008 ◽  
Vol 39 (1) ◽  
pp. 65-78
Author(s):  
Yu. S. Teplitskii ◽  
V. A. Borodulya ◽  
V. I. Kovenskii ◽  
E. P. Nogotov
Keyword(s):  
Fluidized Bed ◽  
Solid Fuel ◽  
Circulating Fluidized Bed ◽  
Fuel Combustion ◽  
Solid Fuel Combustion

Contributions of biomass/solid fuel burning to blood pressure modification in women: A systematic review and meta‐analysis

2021 ◽  
Author(s):  
David T. Dillon ◽  
Gregory D. Webster ◽  
Joseph H. Bisesi
Keyword(s):  
Systematic Review ◽  
Blood Pressure ◽  
Solid Fuel ◽  
Meta Analysis ◽  
Fuel Burning

scholarly journals Carbonaceous aerosols contributed by traffic and solid fuel burning at a polluted rural site in Northwestern England

2011 ◽  
Vol 11 (4) ◽  
pp. 1603-1619 ◽  
Author(s):  
D. Liu ◽  
J. Allan ◽  
B. Corris ◽  
M. Flynn ◽  
E. Andrews ◽  
...  
Keyword(s):  
Solid Fuel ◽  
Mass Fraction ◽  
Organic Aerosol ◽  
Radiative Properties ◽  
Rural Site ◽  
Specific Information ◽  
Carbonaceous Aerosols ◽  
Traffic Emission ◽  
Aerosol Mass ◽  
Fuel Burning

Abstract. The experiment presented in this paper was conducted at the Holme Moss site, which is located in the southern Pennines region in Northwestern England during November–December 2006. The strong southwesterly wind during the experimental period, which enhanced the transport of urban pollutants from the conurbations of Greater Manchester and Liverpool, in addition to the seasonally increased nearby residential heating activities, made this site a receptor for pollutants from a range of sources. A factor analysis is applied to the mass spectra of organic matter (OM) measured by the Aerodyne Aerosol Mass Spectrometer (AMS) to attribute the pollutant sources. Besides the oxygenated organic aerosol (OOA), this site was found to contain a considerable fraction of primary organic aerosols (POA, mass fraction 50–70% within total mass of OM). The POA sources are attributed to be traffic emission and solid fuel burning, which are identified as hydrocarbon-like organic aerosol (HOA) and solid fuel organic aerosol (SFOA) respectively. There were strongly combined emissions of black carbon (BC) particles from both sources. The refractory BC component (rBC) was characterized by a single particle soot photometer. This site began to be influenced during the late morning by fresh traffic emissions, whereas solid fuel burning became dominant from late afternoon until night. A covariance analysis of rBC and POA was used to derive source specific emission factors of 1.61 μgHOA/μgrBC and 1.96 μgHOA/μgrBC. The absorbing properties of aerosols were characterized at multiple wavelengths (λ), and a stronger spectral dependence of absorption was observed when this site was significantly influenced by solid fuel burning. The rBC was estimated to contribute 3–16% of submicron aerosol mass. The single scattering albedo at λ = 700 nm (SSA700 nm) was significantly anti-correlated with the rBC mass fraction, but also associated with the BC mixing state. The BC incorporation/removal process therefore may play a role in modulating the radiative properties of aerosols at the site under the influence of fresh sources. Given that traffic and residential combustion of solid fuels are significant contributors of carbonaceous aerosols over Europe, these results provide important source-specific information on modeling the anthropogenic carbonaceous aerosols.

scholarly journals Research of low quality fuel burning in low-temperature fluidized bed

2013 ◽  
Vol 2 (1(10)) ◽  
pp. 8-11
Author(s):  
Юрій Олександрович Безносик ◽  
Валерій Олександрович Логвин ◽  
Катерина Олексіївна Корінчук
Keyword(s):  
Low Temperature ◽  
Fluidized Bed ◽  
Fuel Burning

THE FLUIDIZATION TECHNIQUE APPLIED TO DIRECT DISTILLATION OF OIL FROM BITUMINOUS SAND

1949 ◽  
Vol 27f (3) ◽  
pp. 104-111 ◽  
Author(s):  
P. E. Gishler
Keyword(s):  
Fluidized Bed ◽  
Oil Recovery ◽  
Slow Rate ◽  
Laboratory Scale ◽  
Gas Formation ◽  
Flash Distillation ◽  
Direct Distillation

The fluidized solids technique has been applied successfully to the flash distillation of oil from Alberta bituminous sand on a laboratory scale. At 500 °C. a 76% oil recovery was obtained. The remaining 24% produced approximately equal weights of coke and gaseous compounds. At temperatures below 460 °C. trouble was experienced in maintaining a fluidized bed because of the slow rate of distillation. As temperatures were increased above 500 °C. the yield of oil decreased, with a corresponding increase in gas formation.

Effect of fire whirlwind formation on solid fuel burning rates

1976 ◽  
Vol 12 (1) ◽  
pp. 33-40 ◽  
Author(s):  
Robert E. Martin ◽  
Dennis W. Pendleton ◽  
William Burgess
Keyword(s):  
Solid Fuel ◽  
Fuel Burning ◽  
Burning Rates
Sign in / Sign up

Export Citation Format

Share Document