Optimal design of structures with variable support conditions

1975 ◽  
Vol 15 (1) ◽  
pp. 85-101 ◽  
Author(s):  
Z. Mróz ◽  
G. I. N. Rozvany
Keyword(s):  
Optimal Design ◽  
Support Conditions ◽  
Variable Support

Sensitivity analysis of sandwich beams and plates accounting for variable support conditions

2013 ◽  
Vol 61 (1) ◽  
pp. 201-210 ◽  
Author(s):  
R. Studziński ◽  
Z. Pozorski ◽  
A. Garstecki
Keyword(s):  
Sensitivity Analysis ◽  
Adjoint Variable Method ◽  
Adjoint Variable ◽  
Practical Applications ◽  
The Core ◽  
State Of Stress ◽  
Thin Steel ◽  
Influence Of Temperature On ◽  
Support Conditions ◽  
Variable Support

Abstract The paper addresses the problems of the sensitivity analysis and optimal design of multi-span sandwich panels with a soft core and flat thin steel facings. The response functional is formulated in a general form allowing wide practical applications. Sensitivity gradients of this functional with respect to dimensional, material and support parameters are derived using adjoint variable method. These operators account for the jump of the slope of a Timoshenko beam or a Reissner plate at the position of concentrated active load or reaction, thus extending the sensitivity operators known in literature. The jump of slope is the effect of shear deformation of the core. Special attention is focussed on sensitivity and optimisation allowing for variable support position and stiffness, because local phenomena observed in supporting area of sandwich plates often initiate failure mechanisms. Introducing optimally located elastic supports allows to reduce the unfavourable influence of temperature on the state of stress. Several examples illustrate the application of derived sensitivity operators and demonstrate their exactness

OPTIMAL DESIGN OF MULTISPAN CONTINUOUS CABLES WITH GENERAL SUPPORT CONDITIONS

1987 ◽  
Vol 12 (4) ◽  
pp. 299-314 ◽  
Author(s):  
C. J. GOH ◽  
C. M. WANG ◽  
K. L. TEO
Keyword(s):  
Optimal Design ◽  
General Support ◽  
Support Conditions

Crack divergence phenomena in tempered glass

2020 ◽  
Vol 13 (3) ◽  
pp. 115-129
Author(s):  
Shin’ichi Aratani
Keyword(s):  
Optimal Design ◽  
High Speed ◽  
Glass Plate ◽  
Acute Angle ◽  
Divergence Angle ◽  
High Speed Photography ◽  
Tempered Glass ◽  
Thick Glass

High speed photography using the Cranz-Schardin camera was performed to study the crack divergence and divergence angle in thermally tempered glass. A tempered 3.5 mm thick glass plate was used as a specimen. It was shown that two types of bifurcation and branching existed as the crack divergence. The divergence angle was smaller than the value calculated from the principle of optimal design and showed an acute angle.

G Optimal Design in Non linear Models to Increase Silicon Oxide Purity Levels and Electrical Conductivity

2018 ◽  
pp. 150-155
Author(s):  
Muklas Rivai
Keyword(s):  
Electrical Conductivity ◽  
Optimal Design ◽  
Linear Models ◽  
Silicon Oxide ◽  
Information Matrix ◽  
Relevant Information ◽  
Non Linear

Optimal design is a design which required in determining the points of variable factors that would be attempted to optimize the relevant information so that fulfilled the desired criteria. The optimal fulfillment criteria based on the information matrix of the selected model.

Sign in / Sign up

Export Citation Format

Share Document