Evidence for a compensation effect during the temperature-programmed reduction of copper oxide in hydrogen

1998 ◽  
Vol 63 (2) ◽  
pp. 209-217 ◽  
Author(s):  
Amedeo Andreini ◽  
Eduard K. Poels ◽  
Alfred Bliek
Keyword(s):  
Copper Oxide ◽  
Compensation Effect ◽  
Temperature Programmed Reduction ◽  
Temperature Programmed

Temperature-programmed reduction and x-ray photoelectron spectroscopy of copper oxide on alumina following exposure to sulfur dioxide and oxygen

1991 ◽  
Vol 30 (9) ◽  
pp. 2105-2113 ◽  
Author(s):  
Benoit Kartheuser ◽  
Benjamin K. Hodnett ◽  
Alfredo Riva ◽  
Gabriele Centi ◽  
Haris Matralis ◽  
...  
Keyword(s):  
Sulfur Dioxide ◽  
Copper Oxide ◽  
Photoelectron Spectroscopy ◽  
Temperature Programmed Reduction ◽  
X Ray ◽  
Temperature Programmed

scholarly journals Novel Nickel- and Magnesium-Modified Cenospheres as Catalysts for Dry Reforming of Methane at Moderate Temperatures

Catalysts ◽  
2019 ◽  
Vol 9 (12) ◽  
pp. 1066 ◽  
Author(s):  
Bogdan Samojeden ◽  
Marta Kamienowska ◽  
Armando Izquierdo Colorado ◽  
Maria Elena Galvez ◽  
Ilona Kolebuk ◽  
...  
Keyword(s):  
Supported Catalysts ◽  
Temperature Programmed Desorption ◽  
Catalytic Performance ◽  
Dry Reforming ◽  
Dry Reforming Of Methane ◽  
Temperature Programmed Reduction ◽  
Fly Ashes ◽  
Coal Fly Ashes ◽  
Temperature Programmed ◽  
Mg Content

Cenospheres from coal fly ashes were used as support in the preparation of Ni–Mg catalysts for dry reforming of methane. These materials were characterized by means of XRD, H2-temperature-programmed reduction (H2-TPR), CO2-temperature-programmed desorption (CO2-TPD), and low-temperature nitrogen sorption techniques. The cenosphere-supported catalysts showed relatively high activity and good stability in the dry reforming of methane (DRM) at 700 °C. The catalytic performance of modified cenospheres was found to depend on both Ni and Mg content. The highest activity at 750 °C and 1 atm was observed for the catalyst containing 30 wt % Mg and 10, 20, and 30 wt % Ni, yielding to CO2 and CH4 conversions of around 95%.

Temperature-programmed reduction of CuO−NiO/Al2O3 catalysts

1982 ◽  
Vol 21 (3) ◽  
pp. 295-298 ◽  
Author(s):  
T. Paryjczak ◽  
J. Rynkowski ◽  
K. Krzyzanowski
Keyword(s):  
Temperature Programmed Reduction ◽  
Temperature Programmed

Preparation of Silica-Supported Nickel Molybdenum Phosphides by Temperature-Programmed Reduction Technique

2007 ◽  
Vol 124-126 ◽  
pp. 1765-1768 ◽  
Author(s):  
So Yeon Lee ◽  
Yong Kul Lee ◽  
S.Ted Oyama ◽  
Seok Hee Lee ◽  
Hee Chul Woo
Keyword(s):  
Single Phase ◽  
Reduction Rate ◽  
Reduction Reaction ◽  
Molar Ratio ◽  
Infrared Spectrometry ◽  
Molybdenum Oxides ◽  
Temperature Programmed Reduction ◽  
X Ray Diffraction ◽  
Ammonium Hydrogen ◽  
Temperature Programmed

Silica supported nickel molybdenum phosphides (NiMoP/SiO2) were successfully prepared by temperature-programmed reduction (TPR) reaction of phosphorous-impregnated nickel molybdenum oxides (NiMoO4) precursors with hydrogen at relatively low temperatures (530 – 590 oC) and characterized by Fourier transform-Infrared spectrometry (FT-IR), X-ray diffraction (XRD), Electron probe microanalysis (EPMA) and Temperature-programmed reduction reaction (TPR). The process of solid transformation and properties of materials prepared from ammonium hydrogen phosphate (AMP)-impregnated samples were compared with those of phosphide made from phosphoric acid (PAC)-impregnated samples. Results show that the formation of a single NiMoP phase on silica significantly depends on reduction rates, phosphorous sources and phosphorous loadings. A single phase of NiMoP on SiO2 was particularly promoted at a below 5 oC/min of reduction rate and the starting molar ratio of Ni/Mo/P=1/1/1. A single phase of crystalline NiMoP on silica was produced from AMP-impregnated samples, while other phases of MoP, Ni2P, or NiMoP2 were appeared from PAC-impregnated samples with loading. The new phase of NiMoP2 was occurred with increasing phosphorous loading (above Ni/Mo/P=1/1/2.5) as a result of facilitated contact on the surface between the Ni-Mo bimetallic component and the phosphorous reagent

Hydrogen Adsorption Capacity Investigation of Ni-Co-Al Mixed Oxides

2014 ◽  
Vol 917 ◽  
pp. 360-364 ◽  
Author(s):  
M. Abdus Salam ◽  
Suriati Sufian
Keyword(s):  
Hydrogen Adsorption ◽  
Mixed Oxides ◽  
Textural Properties ◽  
Metal Dispersion ◽  
Temperature Programmed Reduction ◽  
Oxide Formation ◽  
Nickel Cobalt ◽  
Icp Ms ◽  
Temperature Programmed ◽  
Adsorption Desorption

Micro-mesoporous mixed oxides containing nickel, cobalt and aluminum have been synthesized using conventional coprecipitation method. FESEM and HRTEM analyses demonstrated the flower and hexagonal plate-like nanostructured of mixed oxides. Different mixed oxide formation, homogenous metal dispersion, textural properties were investigated using XRD, ICP-MS and BET (N2 adsorption-desorption) techniques. nanostructured mixed oxides exhibited 2.6 wt% hydrogen adsorption that were studied using temperature programmed reduction-adsorption-desorption (H2-TPR/TPD) and thermogravimetric and differential thermal analysis (TGA-DTA) techniques. Investigation corresponds that morphologies, textural properties and surface energy of mixed oxides are important in hydrogen adsorption.

Sign in / Sign up

Export Citation Format

Share Document